Jan Řehoř

Morphology of the Chip Formation at Orthogonal High Speed Milling of AISI H13

Katarina Monkova, Jaroslava Fulemová, Peter Monka, 2016 .

Influence of form Factor of the Cutting Edge on Tool Life during Finishing Milling

Jaroslava Fulemová, Jan Řehoř, 2015 .

Research Study on Influence of Predefined Factors on Drilling Produced Hole before Reaming

Jaroslava Fulemová, Jan Řehoř, Václava Pokorná, 2016 .

Analysis of the hard turning of AISI H13 steel with ceramic tools based on tool geometry: surface roughness, tool wear and their relation

Diego Carou, Carlos Henrique Lauro, João Paulo Davim, 2016 .

Residual stresses evaluation in precision milling of hardened steel based on the deflection-electrochemical etching technique

Diego Carou, Jan Řehoř, D. Carou, 2017 .