Joseph Mathew

发表

Estimating the Loading Condition of a Diesel Engine Using Instantaneous Angular Speed Analysis

Lin Ma, Tian Ran Lin, Andy C. C. Tan, 2011, WCE 2011.

Condition monitoring of low speed bearings: A comparative study of the ultrasound technique versus vibration measurements

Andy C. C. Tan, Joseph Mathew, Eric Kim, 2008, WCE 2008.

Condition-based prognosis of machine health

Joseph Mathew, Andy C. C. Tan, Aiwina Soong Yin Heng, 2009 .

The Propagation of Vibration Energy in a Forging Shop

Fu Mingfu, Yong Sun, Joseph Mathew, 2002 .

Common vibration monitoring techniques

Joseph Mathew, 1998 .

Piezoceramnic Sensors: Issues on their Application in Active Vibration Control

Matthew Dunbabin, Joseph Mathew, Andy C. C. Tan, 2001 .

Condition monitoring and fault diagnosis of diesel engines using instantaneous angular speed analysis

Andy C. C. Tan, Lin Ma, Tian Ran Lin, 2015 .

High frequency transient vibration analysis for the detection and diagnosis of faults in low speed rolling element bearings

Joseph Mathew, Joshua Altmann, 1997 .

Visualisation of Vibration Mode Shapes to Assist Students in the Learning of Mechanical Vibrations

Andy C. C. Tan, Joseph Mathew, Mathew Dunbabin, 2001 .

Signal Patterns of Piston Slap of a Four-Cylinder Diesel Engine

Andy C. C. Tan, Tian Ran Lin, Joseph Mathew, 2015, WCE-2015 2015.

DWPA best basis demodulation for the detection and diagnosis of faults in rolling elements bearings

Joseph Mathew, Joshua Altmann, 1998 .

A general condition-based prognostics model for estimating the survival probability of equipment

Joseph Mathew, Soong Heng, Andy C. C. Tan, 2008 .

Condition monitoring and diagnosis of injector faults in a diesel engine using in-cylinder pressure and acoustic emission techniques

Tian Ran Lin, Andy C. C. Tan, Joseph Mathew, 2011 .

An Experimental Evaluation of Blind Equalizer Filters Length for the Recovery of Rolling Element Signals Masked by Noise

Joseph Mathew, Bo-Suk Yang, Dong Kim, 2004 .

Simulation of Progressive Degradation Data for Rolling Element Bearing Prognostics

Joseph Mathew, Soong Heng, Yong-Han Kim, 2006 .