H. Kudo

发表

UPPER BOUND APPROACH TO METAL FORMING PROCESSES — TO DATE AND IN THE FUTURE

H. Kudo, 1985 .

Some analytical and experimental studies of axi-symmetric cold forging and extrusion—I

H. Kudo, 1960 .

The compression of rigid-perfectly-plastic material between rough parallel dies of unequal width

H. Kudo, W. Johnson, 1960 .

The cutting of metal strips between partly rough knife-edge tools

H. Kudo, W. Johnson, 1961 .

A note on the role of microscopically trapped lubricant at the tool-work interface

H. Kudo, 1965 .

Comments on: An analysis of the effect of friction on sheet drawing: H. C. Rogers and L. F. Coffin, Jr., Int. J. mech. Sci. 13, 141 (1971)

H. Kudo, T. Nagahama, K. Yoshida, 1972 .

Ultraprecision Micro-Grinding of Germanium Immersion Grating Element for Mid-Infrared Super Dispersion Spectrograph

Y. Yamagata, H. Kudo, H. Ohmori, 2001 .

Effect of Surface Topography of Workpiece on Pressure Dependence of Coefficient of Friction in Sheet Metal Forming

Hideaki Kudo, Akira Azushima, Junji Miyamoto, 1998 .

Direct Observation of Microcontact Behavior at the Interface between Tool and Workpiece in Lubricated Upsetting

H. Kudo, T. Yamaguchi, A. Azushima, 1996 .

Physical Simulation for Metal Forming with Strain Rate Sensitive Model Material

H. Kudo, A. Azushima, 1987 .

An Interpretation of the Speed Dependence of the Coefficient of Friction under the Micro-PHL Condition in Sheet Drawing

H. Kudo, A. Azushima, M. Uda, 1991 .

Direct Observation of Contact Behaviour to Interpret the Pressure Dependence of the Coefficient of Friction in Sheet Metal Forming

H. Kudo, A. Azushima, 1995 .

Some aspects of friction in metal-strip drawing

H. Kudo, H. Kudo, S. Fukui, 1962 .

A Review of Development and Use of the Upper Bound Approach to Metal Forming Processes

H. Kudo, H. Kudo, 1983 .

Temperature Measurement of CBN Tool in Turning of High Hardness Steel

Takashi Ueda, Keiji Yamada, Kazuo Nakayama, 1999 .

A Method of Blanking from Amorphous Alloy Foils Using Rubber Tool

H. Kudo, F. Takahashi, T. Nishimura, 1991 .

The use of upper-bound solutions for the determination of temperature distributions in fast hot rolling and axi-symmetric extrusion processes

W. Johnson, H. Kudo, W. Johnson, 1960 .

Some new slip-line solutions for two-dimensional steady-state machining

Hideaki Kudo, H. Kudo, 1965 .

An Attempt for Classification of Metal Forming Operations

H. Kudo, H. Kudo, 1980 .

An upper-bound approach to plane-strain forging and extrusion—I

Hideaki Kudo, H. Kudo, 1960 .