F. Schultheiss

发表

Modeling the cost of varying surface finish demands during longitudinal turning operations

Fredrik Schultheiss, Sören Hägglund, Jan-Eric Ståhl, 2015 .

General Conception of Polar Diagrams for the Evaluation of the Potential Machinability of Workpiece Materials

F. Schultheiss, J. Ståhl, Linhong Xu, 2013 .

Experimental Study of the Minimum Chip Thickness during the Machining of Duplex Stainless Steel

F. Schultheiss, J. Ståhl, M. Agmell, 2011 .

Tool life in stainless steel AISI 304: applicability of Colding’s tool life equation for varying tool coatings

F. Schultheiss, E. Adoberg, D. Johansson, 2016 .

On the Analytical Representation of Chip Area and Tool Geometry when Oblique Turning with Round Tools. Part 1: Chip Area Parameters Under Variation of Side and Back Rake Angle☆

F. Schultheiss, J. Ståhl, V. Bushlya, 2015 .

Screening Environmental Impact Reduction Enabled by Brass Reclamation Through Hot Forging Operations

F. Schultheiss, A. Furberg, J. Johansson, 2020, Advances in Transdisciplinary Engineering.

Determining process parameters for successful material reclamation of lead-free brass chips using hot forging operations: Lubrication

F. Schultheiss, J. Ståhl, V. Bushlya, 2019, Procedia CIRP.

Influence of the tool surface micro topography on the tribological characteristics in metal cutting: Part I experimental observations of contact conditions

F. Schultheiss, J. Ståhl, R. M'Saoubi, 2013 .

Sustainable machining through increasing the cutting tool utilization

Jan-Eric Ståhl, Fredrik Schultheiss, Jinming Zhou, 2013 .

Influence of the Workpiece Material Properties on the Cutting Forces

F. Schultheiss, J. Ståhl, V. Bushlya, 2014 .

On the Machinability of Ductile and Strain Hardening Materials - Models and Methods for Analyzing Machinability

Fredrik Schultheiss, F. Schultheiss, Fredrik Schultheiss, 2013 .

Tool Life and Wear Model in Metal Cutting, Part 1 - Influence of Varying Flank Wear Criterion on Colding's Tool Life Equation

Jan-Eric Ståhl, Fredrik Schultheiss, Daniel Johansson, 2014 .

Tool Life and Wear Modelling in Metal Cutting, Part 2 ─ Based on Combining the Archard and the Colding Equations

Jan-Eric Ståhl, Fredrik Schultheiss, Daniel Johansson, 2014 .

Cost Based Process Optimization by Incrementally Changing the Cutting Data during Sustainable Machining

Jan-Eric Ståhl, Fredrik Schultheiss, Bengt Lundqvist, 2012 .

Residual stress analysis of machined lead-free and lead-containing brasses

Jan-Eric Ståhl, Fredrik Schultheiss, Lars Nyborg, 2016 .

Analytical and experimental determination of the Ra surface roughness during turning

Jan-Eric Ståhl, Fredrik Schultheiss, Sören Hägglund, 2011 .

Wear mechanisms of uncoated and coated cemented carbide tools in machining lead-free silicon brass

Jan-Eric Ståhl, Fredrik Schultheiss, Daniel Johansson, 2017 .