D. Márton

发表

Sputtering-induced surface roughness of metallic thin films

D. Márton, J. Fine, 1990 .

Experimental study of the charge model of interface states

D. Márton, I. Krafcsik, 1979 .

The Loss of Correction in Thoracolumbar Burst Fracture Treated by Surgery. Can We Predict It?

D. Márton, S. Anghel, 2014 .

A SIMS and XPS examination of low-pressure oxygen adsorption on Pt3Sn: Oxygen uptake and surface characteristics

D. Márton, W. Unger, 1989 .

Stability of self-assembled monolayers on titanium and gold.

A. Ayón, M. Feldman, D. Márton, 2008, Langmuir : the ACS journal of surfaces and colloids.

Synergistic Effect of Cyclic Mechanical Strain and Activated Macrophage Cells on Nitinol Corrosion

D. Márton, E. Sprague, 2010 .

Predictive factors for postoperative deformity in thoracolumbar burst fractures: a statistical approach.

D. Márton, S. Anghel, T. Bataga, 2015, Acta orthopaedica et traumatologica turcica.

Long-term stability of self-assembled monolayers on 316L stainless steel

D. Márton, C. Agrawal, G. Mani, 2010, Biomedical materials.

Anatomical and Surgical Basis for Adult Living Donor Liver Transplantation with the Right Liver Lobe

D. Márton, T. Bara, C. Borz, 2014 .

Human aortic endothelial cell response to 316L stainless steel material microstructure

D. Márton, E. Sprague, A. Choubey, 2009, Journal of materials science. Materials in medicine.

A sims study of the adsorption of oxygen on ion-bombarded silicon(111) surfaces

D. Márton, 1980 .

A new technique for the determination of the charge centroid in MNOS structures

D. Márton, I. Krafcsik, 1979 .

Residual damage to an atomically cleaned low‐temperature‐annealed Si(100) surface

I. Yamada, D. Márton, F. Saris, 1980 .

On the local energy levels of a silicon vacancy. A model of the defect‐molecule in the, wannier approximation

D. Márton, A. Hübler, J. Giber, 1977 .

Interface state density and capture cross section measurements on MOS structures by TSC

D. Márton, A. Hübler, 1985 .

Plasma surface modification of poly(D,L-lactic acid) as a tool to enhance protein adsorption and the attachment of different cell types.

C. M. Alves, J. Ong, R. Reis, 2008, Journal of biomedical materials research. Part B, Applied biomaterials.

Drug delivery from gold and titanium surfaces using self-assembled monolayers.

A. Ayón, M. Feldman, D. Márton, 2008, Biomaterials.

Stress corrosion behaviour of Al-Zn-Mg alloys based upon microchemical surface reactions

D. Márton, Á. Csanády, 1979 .

The influence of some alloying additions (Cr, Cu and Li) on the thermal oxidation of AlZnMg alloys

D. Márton, J. Sanz, S. Hofmann, 1982 .

The relationship between the corrosion resistance and impurity content of aluminium oxide layers

D. Márton, Á. Csanády, T. Turmezey, 1984 .

Influence of Mesh Fixation on the Development of Postoperative Pain after Laparoscopic Inguinal Hernia Repair: A Single Surgeon Experience.

D. Márton, É. Etele, D. Sala, 2020, Chirurgia.

Long-term stability of self-assembled monolayers on electropolished L605 cobalt chromium alloy for stent applications.

D. Márton, C. Agrawal, G. Mani, 2011, Journal of biomedical materials research. Part B, Applied biomaterials.

On the development of increasing surface roughness during ion sputtering

D. Márton, J. Fine, 1987 .

The mechanical stress deriving from molecular fitting: On the Si‐SiO2 interface and its effect upon the development and distribution of vacancies

D. Márton, P. Deák, J. Giber, 1977 .

Chlorine induced positive secondary ion yield enhancement in SIMS experiments on a Pt3Pb alloy sample

D. Márton, W. Unger, 1984 .

Oxygen Adsorption on Polycrystalline PT3Pb at Elevated Temperatures. A SIMS Study

D. Márton, W. Unger, L. Bori, 1982 .

The characterization of oxygen surface arrangements on a heated model Pt3Pb bimetallic catalyst: A case study by SIMS

D. Márton, W. Unger, 1986 .

Secondary ion mass spectrometry depth profiling and simultaneous electrical investigation of MOS structures

I. Bársony, D. Márton, J. Giber, 1978 .

Short Segment Fixation Versus Short Segment Fixation With Pedicle Screws at the Fracture Level for Thoracolumbar Burst Fracture

D. Márton, S. Anghel, 2014 .

Characterization of dehydroascorbic acid solutions by liquid chromatography/mass spectrometry.

P. Pastore, D. Márton, A. Zaramella, 2001, Rapid communications in mass spectrometry : RCM.

Influence of stent design and material composition on procedure outcome.

J. Palmaz, S. Bailey, D. Márton, 2002, Journal of vascular surgery.

Ion-induced radiation-enhanced diffusion of silver in nickel☆

D. Márton, J. Fine, G. Chambers, 1989 .

Radiation Enhanced Diffusion (RED) in a Sputtered Ag/Ni Layered System

D. Márton, J. Fine, G. Chambers, 1988 .

Comment on ‘Ion-beam mixing with chemical guidance. IV. Thermodynamic effects without invoking thermal spikes’ by Antonio Miotello and Roger Kelly

D. Márton, J. Fine, 1995 .

Influence of the individual layer thickness on the depth resolution determined in sputter depth profiling of multilayers

D. Márton, 1987 .

Depth profiling of Cu−Cr multilayer structures

D. Márton, J. Giber, J. László, 1986 .

SIMS depth profiling of CrNi multilayer targets

D. Márton, J. Giber, J. László, 1983 .

EFSA—a new evaluation method of the depth resolution in depth profiling of multilayer structures

D. Márton, J. Giber, J. László, 1985 .

DEPTH RESOLUTION IN ION SPUTTERING - AN ASPECT OF QUANTITATIVEMICROANALYSIS

D. Márton, J. Giber, J. László, 1984 .

A secondary ion mass spectrometry study of two-layer systems based on tellurium

D. Márton, V. Labunov, B. Kolosnicin, 1984 .

Depth Resolution of Ion Bombardment Technique Applied to NiPd, NiPt, PtPd, Thin Layer Systems

J. Mizsei, D. Márton, J. Giber, 1982 .

NUMERICAL CALCULATION OF SURFACE FREE ENERGIES OFSOLIDS

L. Z. Mezey, D. Marton, J. Giber, 1977 .

Cross-sectional composition investigations of sputtered tantalum nitride thin films by secondary ion mass spectrometry☆

D. Márton, V. Kolonits, M. Koltai, 1979 .

Drug loading of nanoporous TiO2 films

A. Ayón, M. Feldman, D. Márton, 2006, Biomedical materials.

Study of Anastomosis Safeness and Determination of High Risk Group for Developing Anastomotic Leakage in Patients with Colorectal Cancer

D. Márton, T. Arpad, E. Etel, 2020 .

Delivery of paclitaxel from cobalt-chromium alloy surfaces without polymeric carriers.

M. Feldman, D. Márton, G. Mani, 2010, Biomaterials.

Allylstannation of -, - and -diketones mediated by allylbutyltin halides: Bu(CH=CHCH) SnCl and Bu(CH =CHCH) SnCl

D. Márton, D. Marton, G. Tagliavini, 1997 .

Investigation of the initial stages of oxidation of differently prepared aluminium by SIMS

D. Márton, V. K. Josepovits, Á. Csanády, 1979 .

Evaluation of Pelvic Volume Modification in "Open Book" Fractures Using a Three-Dimensional Model

D. Márton, D. Sala, R. Neagoe, 2018 .

Human aortic endothelial cell response to 316L stainless steel material microstructure

D. Márton, E. Sprague, A. Choubey, 2009, Journal of materials science. Materials in medicine.

Predictive factors for postoperative deformity in thoracolumbar burst fractures: a statistical approach.

D. Márton, S. Anghel, T. Bataga, 2015, Acta Orthopaedica et Traumatologica Turcica.

Simplified IMISR Method with Computer Data Acquisition

János Giber, A. Solydom, D. Marton, 1984 .

General Approach to Physical Examination of the Shoulder Based on the O’Brien, MOB, and Porcellini Tests

D. Márton, E. Élthes, János Székely, 2021, Journal of Interdisciplinary Medicine.