I. Mansir

发表

Review of Fuel/Oxidizer-Flexible Combustion in Gas Turbines

M. Nemitallah, MD Azazul Haque, A. Abdelhafez, 2020 .

Numerical modeling of heat transfer characteristics in a two-pass oxygen transport reactor for fire tube boilers under oxy-fuel combustion

R. Ben‐Mansour, I. Mansir, M. Habib, 2021, Applied Thermal Engineering.

Experimental and numerical investigation of flow field and oxy-methane combustion characteristics in a low-power porous-plate reactor

A. Khalifa, M. Nemitallah, I. Mansir, 2018, Energy.

Experimental investigation of the stability of a turbulent diffusion flame in a gas turbine combustor

M. Nemitallah, I. Mansir, M. Habib, 2018, Energy.

Design, exergy analysis, and optimization of a hydrogen generation/storage energy system with solar heliostat fields and absorption-ejector refrigeration system

F. Musharavati, S. Khanmohammadi, I. Mansir, 2021, International Journal of Hydrogen Energy.

Review of Novel Combustion Techniques for Clean Power Production in Gas Turbines

Sherif S. Rashwan, M. Nemitallah, A. Abdelhafez, 2018 .

A new coupled energy system consisting of fuel cell, solar thermal collector, and organic Rankine cycle; Generation and storing of electrical energy

I. Mansir, M. Taghavi, Yuning Chen, 2022, Sustainable Cities and Society.

Design analysis and tri-objective optimization of a novel integrated energy system based on two methods for hydrogen production: By using power or waste heat

Yan Cao, I. Mansir, E. B. Bani Hani, 2021, International Journal of Hydrogen Energy.

Assessment of the effect of distance between lithium-ion batteries with a number of triangular blades, on the thermal management of the battery pack in a chamber full of phase change material

I. Mansir, N. Sinaga, N. Farouk, 2022, Journal of Energy Storage.

Designing a system for battery thermal management: Cooling LIBs by nano-encapsulated phase change material

I. Mansir, A. Mouldi, M. Dahari, 2022, Case Studies in Thermal Engineering.

Investigation of heat transfer, melting and solidification of phase change material in battery thermal management system based on blades height

I. Mansir, 2022, Journal of Energy Storage.

Frontiers in combustion techniques and burner designs for emissions control and CO2 capture: A review

M. Nemitallah, A. Abdelhafez, I. Mansir, 2019, International Journal of Energy Research.

Experimental study on combustion characteristics and lean blow-out limits of non-premixed oxy-methane flames in a porous-plate reactor

A. Khalifa, M. Nemitallah, I. Mansir, 2019, Heat and Mass Transfer.

Experimental and numerical study of oxy‐methane flames in a porous‐plate reactor mimicking membrane reactor operation

M. Nemitallah, I. Mansir, M. Habib, 2019, International Journal of Energy Research.

Dynamic simulation of hydrogen-based zero energy buildings with hydrogen energy storage for various climate conditions

I. Mansir, Hamdi Ayed, C. Diyoke, 2022, International Journal of Hydrogen Energy.

Heat transfer and exergy destruction analyses with ferrofluid in LS-3 solar collector under dipole magnetic field

I. Mansir, M. Salem, I. Mahariq, 2022, Sustainable Energy Technologies and Assessments.

Utilization of renewable hybrid energy for refueling station in Al-Kharj, Saudi Arabia

E. M. Barhoumi, I. Mansir, P. Okonkwo, 2022, International Journal of Hydrogen Energy.

Enhancing the solar still performance using reflectors and sliding-wick belt

A. S. Abdullah, I. Mansir, F. Essa, 2021, Solar Energy.

Characteristics of Oxyfuel Combustion in Lean-Premixed Multihole Burners

M. Nemitallah, A. Abdelhafez, I. Mansir, 2019, Energy & Fuels.

Artificial neural network multi-objective optimization of a novel integrated plant to produce power, cooling and potable water

Salah I. Yahya, I. Mansir, A. Rezaei, 2022, Energy for Sustainable Development.

An innovative design of a high strength and low weight sudden micro expansion by considering a nanofluid: Electronic cooling application

M. Goodarzi, M. Safaei, I. Mansir, 2021, Case Studies in Thermal Engineering.

A focused review of the hydrogen storage tank embrittlement mechanism process

E. M. Barhoumi, Wesam H. Beitelmal, I. Mansir, 2023, International Journal of Hydrogen Energy.

Employing numerical method for evaluating the heat transfer rate of a hot tube by nanofluid natural convection

I. Mansir, M. Dahari, Abdullah Mohamed, 2022, Case Studies in Thermal Engineering.

Using natural convection mechanism of nanofluid for cooling an embedded hot plate in corner of a square enclosure: A numerical simulation

K. Gepreel, I. Mansir, A. Mouldi, 2022, Case Studies in Thermal Engineering.

Improvement of cooling of a high heat flux CPU by employing a cooper foam and NEPCM/water suspension

Yan Liu, X. Nguyen, I. Mansir, 2022, Journal of Energy Storage.

Exergy and exergo-economic investigation of a novel hydrogen production and storage system via an integrated energy system

Yan Cao, H. Dhahad, I. Mansir, 2021, International Journal of Hydrogen Energy.

Thermal process simulation and multi-variable study/optimization of a novel geothermal-driven multi-generation process using bi-evaporator with zeotropic mixture

I. Mansir, M. Dahari, Pradeep Kumar Singh, 2023, Case Studies in Thermal Engineering.

A review of bipolar plates materials and graphene coating degradation mechanism in proton exchange membrane fuel cell

I. Mansir, P. Okonkwo, A. Abdullah, 2021, International Journal of Energy Research.

Free convection to cool a hot square block by embedding in center of a chamber by nanofluid and magnetohydrodynamic

K. Gepreel, I. Mansir, M. Dahari, 2022, Case Studies in Thermal Engineering.

Experimental study on entropic behavior of smooth pipe due to the simultaneous usage of spring turbulator and air bubble injection

F. Jarad, Q. Xu, I. Mansir, 2022, Case Studies in Thermal Engineering.

Economic and energy-exergy analysis of a novel in-plane solar segmented annular thermometric generator

I. Mansir, N. Alkhamis, Mohana S. Alanazi, 2023, Thermal Science and Engineering Progress.

Heat transfer enhancement for slip flow of single-walled and multi-walled carbon nanotubes due to linear inclined surface by using modified Prabhakar fractional approach

K. Alharbi, Kamel Al-khaled, S. Khan, 2022, Archive of Applied Mechanics.

Evaluations on effect of volume fraction of injected air on exergo-economic performance of a shell and tube heat exchanger

F. Jarad, Q. Xu, I. Mansir, 2022, Case Studies in Thermal Engineering.

Installation of permanent cadmium-lined channel as a means for increasing epithermal NAA capabilities of miniature neutron source reactors

Y. A. Ahmed, I. B. Mansir, B.B.M. Dewu, 2013 .

Analytical model for a techno-economic assessment of green hydrogen production in photovoltaic power station case study Salalah city-Oman

E. M. Barhoumi, Wesam H. Beitelmal, I. Mansir, 2022, International Journal of Hydrogen Energy.

Techno-economic analysis and optimization of solar and wind energy systems for hydrogen production: a case study

E. M. Barhoumi, I. Mansir, P. Okonkwo, 2022, Energy Sources, Part A: Recovery, Utilization, and Environmental Effects.

Thermal and hydrodynamic management of a finned-microchannel heat sink applying artificial neural network

Ming Li, I. Mansir, M. Dahari, 2023, Case Studies in Thermal Engineering.

Investigating the effects of employing a cooling radiator on MHD natural convection by injecting MWCNTs into water

I. Mansir, H. Algarni, M. Wae-hayee, 2023, Ain Shams Engineering Journal.

Performance boost of a helical heat absorber by utilization of twisted tape turbulator, an experimental investigation

F. Jarad, I. Mansir, I. Mahariq, 2022, Case Studies in Thermal Engineering.

Profit and efficiency enhancement of a cylindrical solar collector by structural modification of helical tube

F. Jarad, I. Mansir, H. Moria, 2022, Case Studies in Thermal Engineering.

Thermomagnetic mix convection heat transfer of air in the influence of the magnetic field of permanent magnet

I. Mansir, M. Salem, I. Mahariq, 2022, Case Studies in Thermal Engineering.

Heat transfer, pressure drop, and economic analysis of a tube with a constant temperature equipped with semi-circular and teardrop-shaped turbulators

I. Mansir, Abdullah Mohamed, A. Shawabkeh, 2022, Case Studies in Thermal Engineering.

Heat transfer analysis on ferrofluid natural convection system with magnetic field

I. Mansir, M. Wae-hayee, Y. Cao, 2023, Ain Shams Engineering Journal.

Experimental study of the hydrothermal characteristics of copper tube in the presence of the multi-string and multi-strip magnetic turbulator

Dong Liu, I. Mansir, Xijie Chen, 2023, Applied Thermal Engineering.

Integration of wind turbine with biomass-fueled SOFC to provide hydrogen-rich fuel; economic and CO2 emission reduction assessment

Ali E. Anqi, I. Mansir, A. Deifalla, 2022, Process Safety and Environmental Protection.

Techno-economic analysis of photovoltaic-hydrogen refueling station case study: A transport company Tunis-Tunisia

E. M. Barhoumi, I. Mansir, P. Okonkwo, 2021, International Journal of Hydrogen Energy.

Recent review of natural and artificial background radiation dosimetry studies in Saudi Arabia

I. Mansir, S. Jonah, A. Alarjani, 2023, Radiation and Environmental Biophysics.

Machine learning‐based metaheuristic optimization of hydrogen energy plant with solid oxide fuel cell

I. Mansir, M. Aliyu, N. Sinaga, 2022, International Journal of Energy Research.

Enhancing Trays Solar Still Performance Using Wick Finned Absorber, Nano-Enhanced PCM

A. S. Abdullah, I. Mansir, F. Essa, 2021, SSRN Electronic Journal.

Mathematical modeling of heterogeneous metal foams for phase-change heat transfer enhancement of latent heat thermal energy storage units

Ali J. Chamkha, M. Ghalambaz, M. Ghalambaz, 2022, Applied Mathematical Modelling.

Energy and exergoeconomic assessments of a renewable hybrid ERC/ORC integrated with solar dryer unit, PEM electrolyzer, and RO desalination subsystem

I. Mansir, Xiang Niu, A. Abed, 2023, Process Safety and Environmental Protection.

Applying Bayesian Markov chain Monte Carlo (MCMC) modeling to predict the melting behavior of phase change materials

Abdullah K. Alanazi, M. Goodarzi, I. Mansir, 2021, Journal of Energy Storage.

Mixed convection of EG/NEPCM inside a lid-driven cavity with a rotating cylinder

I. Mansir, Pradeep Kumar Singh, Rishabh Chaturvedi, 2023, Case Studies in Thermal Engineering.

Economic and thermal performance analysis of two-stage thin-film solar thermoelectric power generator

I. Mansir, Hamdi Ayed, Man-Wen Tian, 2023, Case Studies in Thermal Engineering.

A focused review of carbon corrosion mechanism in proton exchange membrane fuel cell during start-up and shut-down processes

I. Mansir, P. Okonkwo, 2023, Energy Sources, Part A: Recovery, Utilization, and Environmental Effects.

Proposal of a biogas upgrading process for a novel eco-friendly trigeneration model, producing power, methanol, and desalinated water

X. Chen, I. Mansir, Hamdi Ayed, 2023, Process Safety and Environmental Protection.

Numerical simulation and 4E analysis of a novel trigeneration scheme utilizing CO2 capture and solid oxide electrolysis units

I. Mansir, Z. Abubakar, B. Chauhan, 2023, Process Safety and Environmental Protection.

Effect of electrode spacing on hydrogen production using a home-made alkaline electrolyzer

I. Mansir, P. Okonkwo, H. Bhowmik, 2022, Materials Letters.

Economic, Environmental and Multi Objective Optimization of a Clean Tri-generation System Based Co-firing of Natural Gas and Biomass: An Emergy Evaluation

I. Mansir, M. Dahari, Hao Lin, 2023, Process Safety and Environmental Protection.

Hydrogen production, oxygen separation and syngas oxy-combustion inside a water splitting membrane reactor

Shakirudeen A. Salaudeen, M. Nemitallah, I. Mansir, 2017 .

A comprehensive numerical study on the effectiveness of a rotational-based PTC collector integrated porous foam and PV module

Heng Chen, I. Mansir, B. Chauhan, 2023, Renewable Energy.

Thermal outcomes for blood-based carbon nanotubes (SWCNT and MWCNTs) with Newtonian heating by using new Prabhakar fractional derivative simulations

Kamel Al-khaled, S. Khan, I. Mansir, 2022, Case Studies in Thermal Engineering.

Effects of core excess reactivity and coolant average temperature on maximum operable time of NIRR-1 miniature neutron source reactor

Yassen Adnan Ahmed, G. I. Balogun, I. Mansir, 2011 .

Numerical simulation of dimensions and arrangement of triangular fins mounted on cylindrical lithium-ion batteries in passive thermal management

I. Mansir, N. Sinaga, N. Farouk, 2022, Journal of Energy Storage.

Comparison of three arrangements of internal combustion engine-driven energy systems boosted with PEM fuel cell towards net-zero energy systems

F. Musharavati, I. Mansir, N. Farouk, 2023, International journal of hydrogen energy.

Comparative transient simulation of a renewable energy system with hydrogen and battery energy storage for residential applications

I. Mansir, Hamdi Ayed, N. Farouk, 2022, International Journal of Hydrogen Energy.

Fractional simulations for thermal flow of hybrid nanofluid with aluminum oxide and titanium oxide nanoparticles with water and blood base fluids

K. Alharbi, I. Tlili, S. Khan, 2022, Nanotechnology Reviews.

Heat and mass transfer analysis for bi-dimensional bioconvective MHD nanofluid with varying thermal traits

I. Mansir, Dania Qaiser, Naseer M. Khan, 2024, International Journal of Modelling and Simulation.