C. Richard

发表

Correlation between the tribological behaviour and wear particle morphology—case of grey cast iron 250 versus Graphite and PTFE

C. Kowandy, C. Richard, Y. Chen, 2007 .

Silanization with APTES for Controlling the Interactions Between Stainless Steel and Biocomponents: Reality vs Expectation

C. Richard, P. Rouxhet, M. Genet, 2011 .

Development of 1-3 PZT-polymer composite for low frequency acoustical applications

C. Richard, R. Ting, C. Audoly, 1994, Proceedings of 1994 IEEE International Symposium on Applications of Ferroelectrics.

Evolution of the passive film and organic constituents at the surface of stainless steel immersed in fresh water.

C. Richard, P. Rouxhet, M. Genet, 2008, Journal of colloid and interface science.

Contribution to modeling the wear mechanism of X40CrMoV5/Fe360B steel couple in an open sliding contact at high temperature

C. Richard, R. Elleuch, R. Mnif, 2017 .

The effect of tribolayers on the behavior friction of X40CrMoV5/Fe360B steel couple in an open sliding contact

C. Richard, R. Elleuch, R. Mnif, 2017 .

Hot Wear Behavior of Steels 28NCDV10/Z20C13: Influence of Pre-Oxidation and Comparison with Al2O3, Al2O3–TiO2 Coatings

I. Guillot, C. Richard, G. Béranger, 1999 .

Degradation mechanisms and future challenges of titanium and its alloys for dental implant applications in oral environment.

Geetha Manivasagam, C. Richard, A. I. Muñoz, 2017, Materials science & engineering. C, Materials for biological applications.

Characteristics and properties of a magnetron sputtered gadolinia-doped ceria barrier layer for solid oxide electrochemical cells

P. Coddet, C. Richard, A. Thomann, 2018 .

Effect of surface nanocrystallization on the corrosion behavior of Ti–6Al–4V titanium alloy

C. Richard, D. Retraint, T. Roland, 2013 .

The Potential of Magnesium Alloys as Bioabsorbable / Biodegradable Implants for Biomedical Applications

Geetha Manivasagam, C. Richard, J. Landoulsi, 2014 .

Unravelling surface changes on Cu-Ni alloy upon immersion in aqueous media simulating catalytic activity of aerobic biofilms

Irma Liascukiene, C. Richard, M. Genet, 2020 .

Four-point bending tests of thermally produced WC-Co coatings

Jian Lu, J. Flavenot, C. Richard, 1996 .

Multistep magnetron sputtering process and in-situ heat treatment to manufacture thick, fully oxidized and well crystallized YSZ films

P. Coddet, C. Richard, A. Thomann, 2018, Surface and Coatings Technology.

Glucose oxidase immobilization on stainless steel to mimic the aerobic activities of natural biofilms

C. Richard, J. Landoulsi, M. Jeannin, 2008 .

Ennoblement of stainless steel in the presence of glucose oxidase: nature and role of interfacial processes.

C. Richard, P. Rouxhet, M. Genet, 2008, Journal of colloid and interface science.

Degradation mechanisms in martensitic stainless steels: Wear, corrosion and tribocorrosion appraisal

C. Richard, A. I. Muñoz, A. Dalmau, 2018 .

Enzymatic approach in microbial-influenced corrosion: a review based on stainless steels in natural waters.

C. Richard, J. Landoulsi, K. El Kirat, 2008, Environmental science & technology.

Enzyme-induced ennoblement of AISI 316L stainless steel: Focus on pitting corrosion behavior

C. Dagbert, C. Richard, J. Landoulsi, 2009 .

Diagnosis of the Diatom Community upon Biofilm Development on Stainless Steels in Natural Freshwater

C. Richard, J. Landoulsi, S. Mitbavkar, 2017, Scanning.

Study of a chromium-free treatment on Hot-Dip Galvanized steel: Electrochemical behaviour and performance in a saline medium

C. Richard, J. Landoulsi, D. Verchère, 2010 .

Quantitative Analysis of Porosity and Transport Properties by FIB-SEM 3D Imaging of a Solder Based Sintered Silver for a New Microelectronic Component

G. Quilliec, C. Richard, T. L. Bihan, 2016, Journal of Electronic Materials.

Characterization Methodology of a Tribological Couple: Metal Matrix Composite/Brake Pads

C. Richard, F. Robbe-Valloire, I. Sallit, 1998 .

Study of Cr2O3 coatings Part I: Microstructures and modulus

C. Richard, G. Béranger, L. J., 1995 .

Corrosion and wear behavior of thermally sprayed nano ceramic coatings on commercially pure Titanium and Ti–13Nb–13Zr substrates

C. Kowandy, C. Richard, J. Landoulsi, 2010 .

Innovative Surface Treatments of Titanium Alloys for Biomedical Applications

C. Richard, 2016 .

Measurement of Wear and Friction Resistance of Bulk and Coated Materials

Geetha Manivasagam, C. Richard, Y. Chen, 2015 .

Laser peening processing effect on mechanical and tribological properties of rolling steel 100Cr6

P. Peyre, C. Richard, I. Yakimets, 2004 .

The influences of heat treatments and interdiffusion on the adhesion of plasma-sprayed NiCrAlY coatings

Jian Lu, J. Flavenot, C. Richard, 1996 .

Tribological Behavior of New Martensitic Stainless Steels Using Scratch and Dry Wear Test

C. Richard, D. Joly, A. Igual-Muñoz, 2014, Tribology Letters.

ON THE MULTIAXIAL AMPLITUDE- AND FREQUENCY-DEPENDENT BEHAVIOR OF RUBBER: EXPERIMENTS AND CONSTITUTIVE MODELING

C. Richard, S. Méo, F. Lacroix, 2014 .

Power modules die attach: A comprehensive evolution of the nanosilver sintering physical properties versus its porosity

Régis Meuret, Stephane Azzopardi, Eric Woirgard, 2015, Microelectron. Reliab..

Implementation of the Homogenization Method in the Numerical Estimation of Wafer Warpage

F. Roqueta, C. Richard, A. Tougui, 2023, Coatings.

Characterization of wear particles for comprehension of wear mechanisms: Case of PTFE against cast iron

C. Kowandy, C. Richard, Y. Chen, 2008 .

Isolation and analysis of articular joints wear debris generated in vitro

C. Kowandy, C. Richard, H. Mazouz, 2006 .

The importance of the air temperature variable for the snowmelt runoff modelling using the SRM

D. Gratton, C. Richard, 2001 .

Synthesis by solid route and physicochemical characterizations of blends of calcium orthophosphate powders and mesoporous silicon particles

C. Richard, T. Defforge, Amandine Magnaudeix, 2023, Frontiers in Bioengineering and Biotechnology.

Lipstick Adhesion Measurement

C. Richard, 2021 .

Managing tribocorrosion investigations by stress mapping: Dual mobility concept, hip implant, as required step

Jean Geringer, Caroline Richard, C. Richard, 2021, Mechanical and Electro-Chemical Interactions Under Tribocorrosion.

Analysis of friction, wear and oxidation behaviour of X40CrMoV5/Fe360B steel couple in an open-sliding contact

C. Richard, R. Elleuch, R. Mnif, 2014 .

Albedo of Pavement Surfacing Materials: In Situ Measurements

C. Richard, G. Doré, J. Bilodeau, 2015 .

Investigation of failure mechanisms in WC-Co coated materials

C. Richard, H. Kebir, A. Laksimi, 2003 .

Effect of equal channel angular extrusion on wear and corrosion behavior of the orthopedic Ti–13Nb–13Zr alloy in simulated body fluid

S. Suwas, C. Richard, J. Landoulsi, 2012 .

Mechanisms of functional response and resource exploitation in browsing roe deer

C. Richard, A. Illius, P. Duncan, 2002 .

Studies on the corrosion and wear behavior of the laser nitrided biomedical titanium and its alloys

N. D. Pandey, C. Richard, M. Geetha, 2010 .

Evolution of microstructure of Lead free cu/Sn solders and copper oxide phase precipitation in Cu3Sn intermetallic during thermal cycling

C. Richard, Yousra Bettahi, 2019, Microelectronics Reliability.

New trends in laser shock wave physics and applications

Remy Fabbro, Patrice Peyre, Christelle Carboni, 2002, SPIE High-Power Laser Ablation.

Investigations of High Temperature Wear Mechanisms for Tool Steel Under Open-Sliding Contact

C. Richard, R. Elleuch, Z. Baccouch, 2014, Journal of Materials Engineering and Performance.