S. Dessiatoun

A. Shooshtari, M. Ohadi, A. Bar-Cohen, 2006, Thermal and Thermomechanical Proceedings 10th Intersociety Conference on Phenomena in Electronics Systems, 2006. ITHERM 2006..

Augmentation of Thin Falling-Film Evaporation on Horizontal Tubes Using an Applied Electric Field

M. Ohadi, S. Dessiatoun, J. Darabi, 2000 .

Comparison of near source two-phase flow cooling of power electronics in thermosiphon and forced convection modes

Michael M. Ohadi, Fabio Battaglia, Farah Singer, 2017, 2017 16th IEEE Intersociety Conference on Thermal and Thermomechanical Phenomena in Electronic Systems (ITherm).

Parametric Performance Analysis of an Electrostatic Wire-Cylinder Aerosol Separator in Laminar Flow Using a Numerical Modeling Approach

A. Shooshtari, M. Ohadi, S. Dessiatoun, 2010 .

Direct bonding of a titanium header to an embedded two-phase FEEDS cooling device for high-flux electronics

M. Ohadi, S. Dessiatoun, P. McCluskey, 2016, 2016 15th IEEE Intersociety Conference on Thermal and Thermomechanical Phenomena in Electronic Systems (ITherm).

Parametric study on the separation of fine immiscible oil droplets from a gaseous stream using an electrostatic force

A. Shooshtari, M. Ohadi, S. Dessiatoun, 2013 .

Enhancement of CO2 Absorption in Aqueous Diethanolamine Amine Using Microchannel Contactors

A. Shooshtari, M. Ohadi, S. Dessiatoun, 2012 .

Thermal Performance of Micro-Structured Evaporation Surfaces: Application to Cooling of High Flux Microelectronics

M. Ohadi, S. Dessiatoun, E. Al-Hajri, 2005 .

Volume of fluid-based numerical modeling of condensation heat transfer and fluid flow characteristics in microchannels

A. Shooshtari, M. Ohadi, H. Ganapathy, 2013 .

Performance characterization of R134a and R245fa in a high aspect ratio microchannel condenser

A. Shooshtari, M. Ohadi, S. Dessiatoun, 2013 .

Numerical modeling and thermal optimization of a single-phase flow manifold-microchannel plate heat exchanger

Michael M. Ohadi, Ebrahim Al-Hajri, Serguei Dessiatoun, 2015 .

Experimental characterization of heat transfer in an additively manufactured polymer heat exchanger

Joshua M. Pearce, M. Arie, A. Shooshtari, 2017 .

EHD Enhanced Convective Boiling of R-134a in Grooved Channels—Application to Subcompact Heat Exchangers

Michael M. Ohadi, Serguei Dessiatoun, M. Ohadi, 1997 .

A comparison analysis of air, liquid, and two-phase cooling of data centers

M. Pecht, M. M. Ohadi, S. V. Dessiatoun, 2012, 2012 28th Annual IEEE Semiconductor Thermal Measurement and Management Symposium (SEMI-THERM).

Heat transfer and pressure drop characteristics of a flat plate manifold microchannel heat exchanger in counter flow configuration

A. Shooshtari, M. Ohadi, S. Dessiatoun, 2016 .

Experimental investigation of heat transfer performance of a manifold microchannel heat sink for cooling of concentrated solar cells

Michael M. Ohadi, Serguei Dessiatoun, Amir Shooshtari, 2009, 2009 59th Electronic Components and Technology Conference.

Force-fed evaporation and condensation utilizing advanced micro-structured surfaces and micro-channels

Michael Ohadi, Edvin Cetegen, Serguei Dessiatoun, 2008, Microelectron. J..

Measurement of Two-Phase Flow and Heat Transfer Parameters using Infrared Thermometry

S. Dessiatoun, Jungho Kim, Eric M. Kommer, 2012 .

Open Source Laser Polymer Welding System: Design and Characterization of Linear Low-Density Polyethylene Multilayer Welds

Joshua M. Pearce, John J. Laureto, M. Ohadi, 2016 .

Critical review of available correlations for two-phase flow heat transfer of ammonia

Reinhard Radermacher, Michael M. Ohadi, Serguei Dessiatoun, 1996 .

In-Tube Boiling Heat Transfer Coefficients of R-123 and their Enhancement Using the EHD Technique

M. Ohadi, S. Dessiatoun, A. Singh, 1995 .

Embedded two-phase cooling of high heat flux electronics on silicon carbide (SiC) using thin-film evaporation and an enhanced delivery system (FEEDS) manifold-microchannel cooler

Daniel G. Bae, M. Mehregany, M. Ohadi, 2017, Intersociety Conference on Thermal and Thermomechanical Phenomena in Electronic Systems.

Embedded two-phase cooling of high flux electronics using a directly bonded FEEDS manifold

Michael Ohadi, Serguei Dessiatoun, Raphael Mandel, 2016, 2016 15th IEEE Intersociety Conference on Thermal and Thermomechanical Phenomena in Electronic Systems (ITherm).

Embedded Two-Phase Cooling of High Flux Electronics via Micro-Enabled Surfaces and Fluid Delivery Systems (FEEDS)

Patrick McCluskey, Michael M. Ohadi, Serguei Dessiatoun, 2015 .

Experimental Characterization of a Nickel Alloy-Based Manifold-Microgroove Evaporator

A. Shooshtari, M. Ohadi, S. Dessiatoun, 2015 .

Heat Transfer and Pressure Drop Characteristics of a Liquid Cooled Manifold-Microgroove Condenser

David L. Boyea, A. Shooshtari, M. Ohadi, 2013 .

High Performance Micro-Grooved Evaporative Heat Transfer Surface for Low Grade Waste Heat Recovery Applications

Michael M. Ohadi, Ebrahim Al-Hajri, Serguei Dessiatoun, 2011 .

Effect of Sand Fouling on Compact Fin Heat Exchangers

A. Shooshtari, M. Ohadi, S. Dessiatoun, 2014 .

An experimental study on energy saving analysis in the defrost cycle of residential heat pumps with the use of reverse air flow during defrost

Michael M. Ohadi, Serguei Dessiatoun, Amir Shooshtari, 2017 .

Air-Side Heat Transfer Enhancement Utilizing Design Optimization and an Additive Manufacturing Technique

M. Arie, A. Shooshtari, M. Ohadi, 2017 .

Flow Boiling Heat Transfer Coefficients of R-134a in a Microfin Tube

Michael M. Ohadi, Serguei Dessiatoun, A. Singh, 1996 .

Feasibility investigation on potential working fluids for electrohydrodynamically-assisted CPLs

M. Ohadi, S. Dessiatoun, M. Molki, 2001 .

EHD-Enhanced Boiling of R-123 Over Commercially Available Enhanced Tubes

M. Ohadi, S. Dessiatoun, A. Singh, 1995 .

Boosting electrical generation of a photovoltaic array by thermal harvest from p-Si cells: An experimental and theoretical study

M. Ohadi, S. Dessiatoun, K. Choo, 2016, 2016 15th IEEE Intersociety Conference on Thermal and Thermomechanical Phenomena in Electronic Systems (ITherm).