Austin C. Hayes

Evaluating the potential of aerial remote sensing in flue-cured tobacco

Austin C. Hayes, 2019 .

Additive Manufacturing: A New Paradigm for the Next Generation of High-Power-Density Direct-Drive Electric Generators

L. Fingersh, L. Sethuraman, K. Dykes, 2018, Volume 2: Heat Exchanger Technologies; Plant Performance; Thermal Hydraulics and Computational Fluid Dynamics; Water Management for Power Systems; Student Competition.

Influence of Powder Type on Aerosol Emissions in Powder-Binder Jetting with Emphasis on Lunar Regolith for In Situ Space Applications

Shelly L. Miller, G. Whiting, Austin C. Hayes, 2020 .

A Transient Printed Soil Decomposition Sensor Based on a Biopolymer Composite Conductor

J. Quinton, J. Neff, R. Bardgett, 2022, Advanced science.

Reducing the Structural Mass of Large Direct Drive Wind Turbine Generators through Triply Periodic Minimal Surfaces Enabled by Hybrid Additive Manufacturing

G. Whiting, Austin C. Hayes, 2021, Clean Technologies.

Rapid Fabrication of Low-Cost Thermal Bubble-Driven Micro-Pumps

R. MacCurdy, G. Whiting, Austin C. Hayes, 2022, Micromachines.

Pulsatory Mixing of Laminar Flow Using Bubble-Driven Micro-Pumps

Austin C. Hayes, B. Hayes, J. Krisher, 2018, Volume 7: Fluids Engineering.

Sintering of 3D printable simulated lunar regolith magnesium oxychloride cements

G. Whiting, Austin C. Hayes, J. Osio-Norgaard, 2021 .

Regulating flow of vapor to enhance pool boiling

Travis S. Emery, S. Kandlikar, Austin C. Hayes, 2019, Applied Thermal Engineering.

Topology optimization for structural mass reduction of direct drive electric machines

O. Sigmund, N. Aage, G. Whiting, 2023, Sustainable Energy Technologies and Assessments.