B. Mahato

发表

Texture evolution during room temperature ageing of silver processed by equal-channel angular pressing

T. Langdon, J. Gubicza, S. Chowdhury, 2011 .

Low strain rate deformation behavior of a Cr–Mn austenitic steel at −80 °C

L. P. Karjalainen, A. Hamada, D. Porter, 2012 .

Role of Grain Boundary Character Distribution on Tensile Properties of 304L Stainless Steel

S. Das, N. Narasaiah, B. Mahato, 2007 .

A Stacking Fault Energy Perspective into the Uniaxial Tensile Deformation Behavior and Microstructure of a Cr-Mn Austenitic Steel

L. P. Karjalainen, A. Hamada, D. Porter, 2014, Metallurgical and Materials Transactions A.

On diffusion and interfacial enrichment of boron in the Laves phase: an in situ TEM-heat-treatment study on newly developed 3Co–3W–9Cr steel

J. K. Sahu, B. Mahato, S. Tripathy, 2019, Philosophical Magazine Letters.

A comparative study on microstructure and mechanical properties near interface for dissimilar materials during conventional V-groove and narrow gap welding

P. Singh, S. Das, K. Sivaprasad, 2017 .

Effect of Stress Relief Annealing on Microstructure & Mechanical Properties of Welded Joints Between Low Alloy Carbon Steel and Stainless Steel

S. Das, P. Singh, S. Das, 2016, Metallurgical and Materials Transactions A.

Microstructural investigation of rolling contact fatigue (RCF) on a failed planetary gear of a windmill gearbox

M. A. Rao, V. Rajinikanth, M. K. Soni, 2020 .

Concurrent precipitation and associated texture evolution in AA 6082 alloy during high pressure torsion (HPT) processing

V. Rajinikanth, G. Wilde, M. Wegner, 2017 .

An effective stacking fault energy viewpoint on the formation of extended defects and their contribution to strain hardening in a Fe–Mn–Si–Al twinning-induced plasticity steel

L. P. Karjalainen, D. Porter, S. Shee, 2015 .

Stability of austenite and quasi-adiabatic heating during high-strain-rate deformation of twinning-induced plasticity steels

V. Kuokkala, Arpan Das, S. Chowdhury, 2010 .

Thermal stability and effect of substrate temperature of TiSiBC hard nanocomposite coatings on microstructure, mechanical, thermal behaviour deposited by magnetron sputtering

L. Pathak, S. Mishra, B. Mahato, 2013 .

Effect of texture on corrosion behavior of AISI 304L stainless steel

Raghuvir Singh, P. De, D. Bhattacharya, 2005 .

Influence of Cold-Worked Structure on Electrochemical Properties of Austenitic Stainless Steels

Raghuvir Singh, B. Mahato, B. R. Ravi Kumar, 2007 .

Deformation-induced transformation textures in metastable austenitic stainless steel

Ashutosh Kumar Singh, P. De, D. Bhattacharya, 2006 .

Aging Degradation of Austenitic Stainless Steel Weld Probed by Electrochemical Method and Impact Toughness Evaluation

Raghuvir Singh, G. Das, B. Mahato, 2017, Metallurgical and Materials Transactions A.

Strain partitioning between matrix and precipitates during fatigue deformation of 2.25Cr–Mo steel

B. Mahato, P. Jena, J. Sahu, 2020 .

Simultaneous twinning nucleation mechanisms in an Fe–Mn–Si–Al twinning induced plasticity steel

L. P. Karjalainen, T. Sawaguchi, J. Kömi, 2017 .

Evolution of Recrystallization Texture in AISI300 Series Austenitic Stainless Steels After Cold Rolling to Large Strain

P. De, S. Chowdhury, B. Mahato, 2009 .

Role of strain-induced martensite on microstructural evolution during annealing of metastable austenitic stainless steel

R. N. Ghosh, S. K. Das, S. Das, 2010 .

Sensitization induced stress corrosion failure of AISI 347 stainless steel fractionator furnace tubes

Raghuvir Singh, M. Gunjan, J. Swaminathan, 2011 .

Effect of large strains on grain boundary character distribution in AISI 304L austenitic stainless steel

Arpan Das, S. Chowdhury, B. Mahato, 2007 .

Effect of Structural Heterogeneity on In Situ Deformation of Dissimilar Weld Between Ferritic and Austenitic Steel

S. Das, Swapan Das, G. Das, 2015, Metallurgical and Materials Transactions A.

Development of Multi-Walled Carbon Nanotube and Processed Graphite Incorporated Hydraulically Bonded Refractory Castable

Dheeraj Kumar, B. Mahato, R. K. Singh, 2015, Interceram - International Ceramic Review.

Evolution of geometrically necessary dislocation at the γ-γ′ interface and its effect on tensile deformation behaviour of disk super alloy

B. Mahato, S. Tripathy, P. Jena, 2021 .

Texture Evolution of IF-Steel Sheets Processed by Equal-Channel Angular Sheet Extrusion (ECASE)

S. Chowdhury, B. Mahato, O. Saray, 2011 .

Comparison of rolling texture in low and medium stacking fault energy austenitic stainless steels

D. Bhattacharya, N. Bandyopadhyay, B. Mahato, 2005 .

Effect of Strain-Induced Precipitation on the Austenite Non-recrystallization (Tnr) Behavior of a High Niobium Microalloyed Steel

S. Sangal, V. Rajinikanth, B. Mahato, 2019, Metallurgical and Materials Transactions A.

Microstructure-mechanical property evaluation and deformation mechanism in Al added medium Mn steel processed through intercritical rolling and annealing

V. Srivastava, S. Chowdhury, B. Mahato, 2021 .

Study of microstructural degradation of a failed pinion gear at a cement plant

M. A. Rao, V. Rajinikanth, B. Mahato, 2019, Engineering Failure Analysis.

Effect of Cyclic Thermal Process on Ultrafine Grain Formation in AISI 304L Austenitic Stainless Steel

B. Mahato, B. R. Ravi Kumar, Sailaja Sharma, 2009 .

Stacking Fault Energy of Austenite Phase in Medium Manganese Steel

S. Chowdhury, B. Mahato, J. Chakraborty, 2019, Metallurgical and Materials Transactions A.

Formation of ultrafine grained microstructure in the austenitic stainless steel and its impact on tensile properties

B. Mahato, B. Kumar, Sailaja Sharma, 2011 .

Evolution of grain-boundary character distribution during iterative processing of an austenitic stainless steel

Pankaj Kumar, P. De, Arpan Das, 2008 .

Correlation of defect density with texture evolution during cold rolling of a Twinning-Induced Plasticity (TWIP) steel

A. Kumar, C. Haase, S. Chowdhury, 2018 .

Correlation of Microstructure and Texture in a Two-Phase High-Mn Twinning-Induced Plasticity Steel During Cold Rolling

A. Hamada, M. Ashiq, B. Mahato, 2017, Metallurgical and Materials Transactions A.

Influence of strain-induced phase transformation on the surface crystallographic texture in cold-rolled-and-aged austenitic stainless steel

D. Bhattacharya, B. Mahato, N. R. Bandyopadhyay, 2005 .

Corrosion behavior of ultrafine-grained AA2024 aluminum alloy produced by cryorolling

K. Sivaprasad, K. Venkateswarlu, G. Das, 2017, International Journal of Minerals, Metallurgy, and Materials.

High Temperature Characterization of CO2 Treated Fluxed Pellets Developed for Basic Oxygen Steel Making

Saroj Kumar Ghosh, J. Pal, B. Mahato, 2009 .