Vincenzo D'Agostino

发表

Automotive dry-clutch control: Engagement tracking and FE thermal model

Mario Pisaturo, Adolfo Senatore, Vincenzo D'Agostino, 2016, 2016 IEEE 20th Jubilee International Conference on Intelligent Engineering Systems (INES).

Driveline Dynamics Simulation and Analysis of the Dry Clutch Friction-Induced Vibrations in the Eek Frequency Range

Utz von Wagner, Daniel Hochlenert, Vincenzo D'Agostino, 2013 .

Drainage flux simulation of green roofs under wet conditions

Vincenzo D'Agostino, Francesco Bettella, Lucia Bortolini, 2018 .

Piston Ring Behaviour Simulation Considering Mixed-Lubrication and Flexibility

Vincenzo D'Agostino, Adolfo Senatore, 2005 .

MODEL PREDICTIVE CONTROL FOR ELECTRO-HYDRAULIC ACTUATED DRY CLUTCH IN AMT TRANSMISSIONS

Mario Pisaturo, Adolfo Senatore, Vincenzo D'Agostino, 2014 .

A Finite Length Plain Journal Bearing Theory

Domenico Guida, Vincenzo D'Agostino, G. Capone, 1994 .

Approximate model for unsteady finite porous journal bearings fluid film force calculation

Adolfo Senatore, Vincenzo D'Agostino, Alessandro Ruggiero, 2005 .

CURRENT RESEARCH IN TRIBOLOGY AT DIMEC

Vincenzo D'Agostino, Adolfo Senatore, 2008 .

An analytical study of the fluid film force in finite‐length journal bearings. Part I

Domenico Guida, Adolfo Senatore, Vincenzo D'Agostino, 2001 .

Quantifying the effect of brush layering on slope stability

Vincenzo D'Agostino, Gian Battista Bischetti, Enrico Antonio Chiaradia, 2010 .

Experimental investigation and neural network prediction of brakes and clutch material frictional behaviour considering the sliding acceleration influence

Adolfo Senatore, Vincenzo D'Agostino, R. Di Giuda, 2011 .

LUBRICANTS FOR FRICTIONAL PAIRS IN AUTOMOTIVE SYSTEMS: A REVIEW OF REQUIREMENTS AND CURRENT INVESTIGATIONS

Mario Pisaturo, Vincenzo D'Agostino, Adolfo Senatore, 2016 .

Could electric motor in HEV assist vehicle launch and relief dry clutch from thermal damage?

Mario Pisaturo, Adolfo Senatore, Vincenzo D'Agostino, 2017, 2017 IEEE International Conference on Advanced Intelligent Mechatronics (AIM).

AN ANALYTICAL APPROACH FOR THE INVESTIGATION ON THE DYNAMIC BEHAVIOUR OF THE CRANKSHAFT JOURNAL BEARINGS

Domenico Guida, Alessandro Ruggiero, Vincenzo D'Agostino, 2002 .

AN ENGINE FRICTION MODEL TO SUPPORT EXPERIMENTAL ACTIVITY AND COMPONENT DESIGN -PART I: BASIC MODELING

Domenico Guida, Vincenzo D'Agostino, A. Ruggiero Senatore, 2001 .

Analytical solution for two‐dimensional Reynolds equation for porous journal bearings

Vincenzo D'Agostino, Adolfo Senatore, 2006 .

AN ANALYTICAL SOLUTION FOR THE PRESSURE FIELD IN THE LONG POROUS JOURNAL BEARINGS

Domenico Guida, Alessandro Ruggiero, Adolfo Senatore, 2004 .

Step pool evolution in an alpine torrent

Vincenzo D'Agostino, Mario Aristide Lenzi, V. D'Agostino, 2000 .

A COMPUTER MODEL FOR INVESTIGATIONS ON THE PISTON MOTION

Alessandro Ruggiero, T. L. L. Lenza, Adolfo Senatore, 2002 .

Sediment transport and water discharge during high flows in an instrumented watershed

Vincenzo D'Agostino, Lorenzo Marchi, Mario Aristide Lenzi, 1994 .

TRIBOLOGICAL AND RHEOLOGICAL BEHAVIOUR OF LUBRICATING GREASES WITH NANOSIZED INORGANIC BASED ADDITIVES

Paolo Ciambelli, Adolfo Senatore, Vincenzo D'Agostino, 2011 .

Influence of the variation between static and kinetic friction on stick-slip instability

Domenico Guida, G. Capone, Vincenzo D'Agostino, 1993 .

On the effective length of the top piston ring involved in hydrodynamic lubrication

Alessandro Ruggiero, Adolfo Senatore, Vincenzo D'Agostino, 2005 .

Assessing the physical vulnerability of check dams through an empirical damage index

Bruno Mazzorana, Vincenzo D'Agostino, Francesco Comiti, 2013 .

MODEL PREDICTIVE CONTROL FOR ACTUATED DRY-CLUTCH MANAGEMENT TO REDUCE VEHICLE LAUNCH DELAY DUE TO ENGINE TORQUE BUILD-UP

Mario Pisaturo, Adolfo Senatore, Vincenzo D'Agostino, 2014 .

Bankfull width and morphological units in an alpine stream of the dolomites (Northern Italy)

Vincenzo D'Agostino, Alessandro Vianello, A. Vianello, 2007 .

Bedload transport in the instrumented catchment of the Rio Cordon

Vincenzo D'Agostino, Mario Aristide Lenzi, P. Billi, 1999 .

New results from sediment transport measurements in two Alpine torrents

Vincenzo D'Agostino, Lorenzo Marchi, Mario Aristide Lenzi, 1998 .

PREVENTING WOOD-RELATED HAZARDS IN MOUNTAIN BASINS: FROM WOOD LOAD ESTIMATION TO DESIGNING RETENTION STRUCTURES

Bruno Mazzorana, Vincenzo D'Agostino, Francesco Bettella, 2012 .

Estimation of debris‐flow magnitude in the Eastern Italian Alps

Vincenzo D'Agostino, Lorenzo Marchi, L. Marchi, 2004 .

Hydrogeomorphic processes and torrent control works on a large alluvial fan in the eastern Italian Alps

Vincenzo D'Agostino, Lorenzo Marchi, Marco Cavalli, 2010 .

Debris flow magnitude in the Eastern Italian Alps: data collection and analysis

Vincenzo D'Agostino, Lorenzo Marchi, L. Marchi, 2000 .

Graphene Oxide Nanosheets as Effective Friction Modifier for Oil Lubricant: Materials, Methods, and Tribological Results

Paolo Ciambelli, Adolfo Senatore, Vincenzo D'Agostino, 2013 .

Fundamentals of lubrication and friction of piston ring contact

Adolfo Senatore, Vincenzo D'Agostino, A. Senatore, 2010 .

Bedload transport in the instrumented catchment of the Rio Cordon: Part II: Analysis of the bedload rate

Vincenzo D'Agostino, Mario Aristide Lenzi, M. A. Lenzi, 1999 .

Field and laboratory investigations of runout distances of debris flows in the Dolomites (Eastern Italian Alps)

Vincenzo D'Agostino, Lorenzo Marchi, Matteo Cesca, 2010 .