Raju Pawade

发表

Multi-objective optimization of surface roughness and cutting forces in high-speed turning of Inconel 718 using Taguchi grey relational analysis (TGRA)

Suhas S. Joshi, Raju Pawade, S. Joshi, 2011 .

Sustainability modelling and assessment in high-speed turning of Inconel 718

Raju Pawade, Ganesh S. Kadam, 2016 .

Experimental Investigation of Cutting Forces and Temperature in Bone Drilling

Raju Pawade, Vishwanath Mali, Hemant Warhatkar, 2016 .

Surface integrity and sustainability assessment in high-speed machining of Inconel 718 – An eco-friendly green approach

Raju Pawade, Ganesh S. Kadam, R. Pawade, 2017 .

Application of Teaching: Learning Based optimization to Surface Integrity Parameters in Milling

Raju Pawade, Nandkumar N. Bhopale, Nilesh Nikam, 2015 .

Optimization of Cutting Parameters for Cutting Force Minimization in Helical Ball End Milling of Inconel 718 by Using Genetic Algorithm

Jambeswar Sahu, Raju Pawade, Varsharani Gaikhe, 2018 .

Prediction of EDM process parameters by using Artificial Neural Network (ANN) - A Prediction Technique

Babasaheb Ambedkar, Raju Pawade, Sagar U. Sapkal, 2014 .

An investigation of cutting forces and surface damage in high-speed turning of inconel 718

Mahmudur Rahman, Suhas S. Joshi, Raju Pawade, 2007 .

Effect of ball end milling parameters on surface and subsurface of Inconel-718

Raju Pawade, Nandkumar N. Bhopale, 2014 .

Experimental Investigation into the Effect of Ball End Milling Parameters on Surface Integrity of Inconel 718

Suhas S. Joshi, Raju Pawade, Nandkumar N. Bhopale, 2015, Journal of Materials Engineering and Performance.

Effect of process parameters on MRR, TWR and surface topography in ultrasonic machining of alumina–zirconia ceramic composite

Raju Pawade, P. K. Brahmankar, R. Pawade, 2014 .

Chip segmentation behaviour and surface topography in high-speed turning of titanium alloy (Ti-6Al-4V) with eco-friendly water vapour

Raju Pawade, Ganesh S. Kadam, D.S.N. Reddy, 2013 .

Electro Discharge Machining Characteristics of Ti-6Al-4V Alloy: A Grey Relational Optimization

Raju Pawade, Sagar U. Sapkal, Mitali S. Mhatre, 2014 .

Comparative Study of High Speed Machining of Inconel 718 in Dry Condition and by Using Compressed Cold Carbon Dioxide Gas as Coolant

Raju Pawade, P. K. Brahmankar, R. Pawade, 2014 .

Analysis of acoustic emission signals and surface integrity in the high-speed turning of Inconel 718

Suhas S. Joshi, Raju Pawade, S. Joshi, 2012 .

Effect of machining parameters and cutting edge geometry on surface integrity of high-speed turned Inconel 718

Suhas S. Joshi, Raju Pawade, P. K. Brahmankar, 2008 .

Surface quality analysis in ball end milling of Inconel 718 cantilevers by response surface methodology

Suhas S. Joshi, Raju Pawade, Nandkumar N. Bhopale, 2017 .