M. Kawano

发表

Development of Intermediate-temperature SOFC Modules and Systems

Toru Inagaki, Katsuya Hirata, Hiroyuki Yoshida, 2005, ECS Transactions.

Influence of Preparation Methods on the Carbon Deposition and Reduction Behavior of Ni–ScSZ Cermet

T. Inagaki, T. Matsui, K. Eguchi, 2010 .

Carbon Deposition over Ni–ScSZ Anodes Subjected to Various Heat-Treatments for Internal Reforming of Solid Oxide Fuel Cells

T. Inagaki, R. Kikuchi, T. Matsui, 2008 .

Synthesis of matrix-type NiO-SDC composite particles by spray pyrolysis with acid addition for development of SOFC cermet anode

T. Inagaki, H. Yoshida, K. Kawahara, 2007 .

Studies on synthetic conditions of spray pyrolysis by acids addition for development of highly active Ni-SDC cermet anode

T. Inagaki, H. Yoshida, K. Kawahara, 2006 .

Internal Reforming of SOFCs Carbon Deposition on Fuel Electrode and Subsequent Deterioration of Cell

R. Kikuchi, T. Matsui, K. Eguchi, 2007 .

Effect of SO2 Concentration on Degradation of Sm0.5Sr0.5CoO3 Cathode

Y. Xiong, K. Yamaji, H. Yokokawa, 2009 .

Direct Internal Steam Reforming at SOFC Anodes Composed of NiO – SDC Composite Particles

T. Inagaki, R. Kikuchi, T. Matsui, 2007 .

Preparation of Matrix‐Type Nickel Oxide/Samarium‐Doped Ceria Composite Particles by Spray Pyrolysis

T. Inagaki, H. Yoshida, K. Kawahara, 2007 .

Study on pyrolysing behavior of NiO-SDC composite particles prepared by spray pyrolysis technique

H. Deguchi, T. Inagaki, H. Yoshida, 2007 .

Effects of atomization conditions on morphology and SOFC anode performance of spray pyrolyzed NiO–Sm0.2Ce0.8O1.9 composite particles

T. Inagaki, Seiji Takahashi, H. Yoshida, 2006 .

Synthesis and characterizations of composite particles for solid oxide fuel cell anodes by spray pyrolysis and intermediate temperature cell performance

T. Inagaki, Seiji Takahashi, H. Yoshida, 2005 .

Generation of thymine radicals from 6-alkoxy-5-bromo-5,6-dihydrothymine derivatives by radiolytic reduction and photolytic dehalogenation.

S. Nishimoto, H. Hatta, Takeo Ito, 2008, Chemical research in toxicology.

Effect of MgO formation in the vicinity of Ni-SDC/LSGM interface on SOFC performance

T. Inagaki, H. Yoshida, Masaya Suzuki, 2009 .

Preparation of SOFC anode composites by spray pyrolysis

Eri Node, T. Inagaki, Seiji Takahashi, 2006 .

Evaluation of IgG ELISA using N-lauroyl-sarcosine-soluble proteins of Bartonella henselae for highly specific serodiagnosis of cat scratch disease.

K. Ichihara, H. Tsuneoka, J. Nojima, 2012, Diagnostic microbiology and infectious disease.

Development of Intermediate-Temperature SOFC Module Using Doped Lanthanum Gallate

T. Miyazawa, T. Ishihara, T. Inagaki, 2004 .

Improvement of the redox durability of Ni-gadolinia doped ceria anodes due to the use of the composite particles prepared by spray pyrolysis method

Satoshi Hashigami, T. Inagaki, H. Yoshida, 2014 .

Morphological evolution of NiO-ScSZ composite in a high-temperature reducing atmosphere

T. Inagaki, T. Matsui, K. Eguchi, 2012 .

Microstructural Change of Ni–GDC Cermet Anode in the Electrolyte‐supported Disk‐type SOFC upon Daily Start‐up and Shout‐down Operations

N. Shikazono, N. Kasagi, T. Matsui, 2012 .

Residual Stress Analysis in Lanthanum Gallate-Based Cells before and after Fuel Cell Operation

H. Deguchi, T. Inagaki, H. Yoshida, 2008 .

Carbon Dioxide Reforming of Methane for Solid Oxide Fuel Cells

T. Inagaki, H. Yoshida, K. Hashino, 2011 .

Carbon Dioxide Reforming of Methane on Nickel‐Ceria‐Based Oxide Cermet Anode for Solid Oxide Fuel Cells

T. Inagaki, H. Yoshida, K. Hashino, 2010 .

Steam reforming on Ni-samaria-doped ceria cermet anode for practical size solid oxide fuel cell at intermediate temperatures

T. Inagaki, R. Kikuchi, T. Matsui, 2008 .