J. Hunt

发表

A numerical analysis of dendritic and cellular array growth: the spacing adjustment mechanisms

Shu-zu Lu, J. Hunt, S. Lu, 1992 .

A numerical analysis of time dependent isolated dendritic growth for conditions near the steady state

J. Hunt, 1990 .

A process-based model for non-equilibrium clumped isotope effects in carbonates

J. Watkins, J. Hunt, 2015 .

The influence of temperature, pH, and growth rate on the δ18O composition of inorganically precipitated calcite

D. DePaolo, F. Ryerson, J. Watkins, 2014 .

Experimental and numerical study of pattern formation in faceted cellular array growth

D. Shangguan, J. Hunt, 1992 .

In situ observation of faceted cellular array growth

D. Shangguan, J. Hunt, 1991 .

A model of a casting

J. Hunt, S. Flood, 1987 .

Kinetics of the Gelation of Colloidal Silica at Geothermal Conditions, and Implications for Reservoir Modification and Management

S. Ezzedine, S. Roberts, W. Bourcier, 2013 .

SILICA GEL BEHAVIOR UNDER DIFFERENT EGS CHEMICAL AND THERMAL CONDITIONS: AN EXPERIMENTAL STUDY

S. Ezzedine, S. Roberts, W. Bourcier, 2012 .

Polymerization of aqueous silica in H2O-K2O solutions at 25-200°C and 1bar to 20kbar

A. Kavner, C. Manning, D. Snyder, 2011 .

A thermodynamic model for the system SiO2–H2O near the upper critical end point based on quartz solubility experiments at 500–1100 °C and 5–20 kbar

C. Manning, J. Hunt, 2011 .

The use of measured values of surface energies to test heterogeneous nucleation theory

N. Maraşlı, J. Hunt, 1998 .

Microstructure and texture evolution after twin roll casting and subsequent cold rolling of Al–Mg–Mn aluminium alloys

M. W. Meredith, J. Hunt, Ch. Gras, 2005 .

Cellular and dendritic growth. I

J. Hunt, M. Burden, 1974 .

A model of a casting

J. Hunt, S. Flood, 1987 .

The measurement of Al-Cu dendrite tip and eutectic interface temperatures and their use for predicting the extent of the eutectic range

J. Hunt, M. Tassa, 1976 .

Numerical modeling of cellular/dendritic array growth: spacing and structure predictions

J. Hunt, S. Lu, John D. Hunt, 1996 .

Numerical modelling of cellular and dendritic array growth: spacing and structure predictions

J. Hunt, S. Lu, 1993 .

Development of the twin-roll casting process

J. D. Hunt, Peter George Grocock, R. Cook, 1995 .

On the nature of crystal growth from the melt

D. Uhlmann, J. Hunt, K. Jackson, 1967 .

The measurement of solid-liquid surface energies in the Al-Cu, Al-Si and Pb-Sn systems

M. Gündüz, J. Hunt, 1985 .

Twin roll casting of aluminium alloys

J. Hunt, M. Yun, S. Lokyer, 2000 .

Columnar and equiaxed growth: I. A model of a columnar front with a temperature dependent velocity

J. Hunt, S. Flood, 1987 .

Columnar and equiaxed growth: II. Equiaxed growth ahead of a columnar front

S. C. Flood, J. D. Hunt, J. Hunt, 1987 .

A Numerical Model of a Two-pan Heat Flux DSC

J. Hunt, H. Dong, 2001 .

The extent of the eutectic range

J. Hunt, M. Burden, 1974 .

The prediction of the thermophysical properties and the solidification of commercial alloys.

A. Dinsdale, K. Mills, J. A. Robinson, 2000 .

Measurements of cell and primary dendrite arm spacings in directionally solidified aluminium alloys

D. G. McCartney, J. Hunt, 1981 .

Macroscopic stability of a planar, cellular or dendritic interface during directional freezing

D. Hebditch, J. Hunt, M. Burden, 1973 .

Thermoelectric investigation of solidification of lead I. Pure lead

J. Hunt, G. H. Rodway, 1991 .

Dynamical study of the pattern formation of faceted cellular array growth

J. D. Hunt, D. Shangguan, D. K. Shangguan, 1989 .

Microdefects formation during the twin-roll casting of Al–Mg–Mn aluminium alloys

M. W. Meredith, J. Hunt, Ch. Gras, 2005 .

Directional solidification of Al–1.5 wt% Ni alloys under diffusion transport in space and fluid-flow localisation on earth

B. Billia, H. N. Thi, B. Drevet, 2005 .

The use of an electric analogue to solve the lamellar eutectic diffusion problem

J. Hunt, K. A. Jackson, J. Hunt, 1977 .

Micro- and macrodefects in thin sheet twin-roll cast aluminum alloys

D. Edmonds, S. Lockyer, J. Hunt, 1996 .

An Experimental Investigation of the Effect of Strip Thickness, Metallostatic Head and Tip Setback on the Productivity of a Twin-roll Caster

J. D. Hunt, Philip Milroy Thomas, D. Edmonds, 1991 .

An experimental study of twin-roll casting

D. Edmonds, D. Browne, X. Yang, 1991 .

Defect Formation in Twin Roll-Cast AA 3xxx and 5xxx Series Aluminium Alloys

M. W. Meredith, J. Hunt, Ch. Gras, 2002 .

The formation of surface bleeds in twin roll cast aluminium sheet

S. Lockyer, J. Hunt, M. Yun, 2001 .

Microstructural defects in high productivity twin-roll casting of aluminium

D. Edmonds, M. Henderson, D. Monaghan, 1993 .

Different growth regimes during directional dendritic growth

Q. Han, J. Hunt, X. Wan, 1997 .

Centre line Segregation in Twin Roll Cast Aluminum Alloy Slab

L. R. Morris, J. Hunt, I. Jin, 1982 .

Microsegregation in Al-Cu alloys

J. Hunt, H. Dong, E. Kurum, 2005 .

A study of microsegregation in Al-Cu using a novel single-pan scanning calorimeter

J. Hunt, H. Cama, H. Dong, 2003 .

Cellular and dendritic growth in rapidly solidified AlFe and AlCu alloys

W. Kurz, J. Hunt, S. Lu, 1994 .

A Numerical Finite Difference Model of Steady State Cellular and Dendritic Growth

D. G. McCartney, J. D. Hunt, J. Hunt, 1984 .

A numerical analysis of dendritic and cellular growth of a pure material investigating the transition from “array” to “isolated” growth

J. Hunt, 1991 .

A mechanism for the columnar to equiaxed transition in castings or ingots

J. Hunt, M. Burden, 1975 .

A numerical model for a heat flux DSC: Determining heat transfer coefficients within a DSC

J. D. Hunt, Hongbiao Dong, Hongbiao Dong, 2005 .

Determination of liquid fraction during solidification of aluminium alloys using a single-pan scanning calorimeter

Hongbiao Dong, J. Hunt, H. Cama, 2003 .

A Novel Single-pan Scanning Calorimeter. Measurement of thermophysical properties of metallic alloys

J. Hunt, H. Dong, 2001 .

A comparison of a novel single-pan calorimeter with a conventional heat-flux differential scanning calorimeter

Hongbiao Dong, J. Hunt, 2000 .

Optimization of SPRT measurements of freezing in a zinc fixed-point cell

J. Pearce, D. Lowe, R. Veltcheva, 2012 .

In situ observation of nonfaceted cellular growth in a narrow channel

D. Shangguan, J. Hunt, 1991 .

Thermoelectric investigation of solidification of lead II. Lead alloys

J. Hunt, G. H. Rodway, 1991 .

Hot-tearing in Aluminium Copper Alloys

Y. Guven, J. Hunt, 1988 .

MAXIMAZING HEAT EXTRACTION AND MINIMAZING WATER LOSSES IN HYDROTHERMAL SYSTEMS : A NUMERICAL INVESTIGATION

S. Ezzedine, S. Roberts, J. Roberts, 2013 .

Some observations on primary dendrite spacings

J. Hunt, M. Burden, 1976 .

Numerical finite difference model for steady state cellular array growth

D. G. McCartney, J. Hunt, 1987 .

Particle pushing: critical flow rate required to put particles into motion

J. D. Hunt, Qingyou Han, Q. Han, 1995 .

Numerical modeling of cellular/dendritic array growth: Spacing and undercooling predictions

S. Lu, J. Hunt, 1995 .

Directional cellular growth of succinonitrile–0.075 wt% acetone bulk samples Part 2: Analysis of cellular pattern

B. Billia, B. Kauerauf, S. Rex, 2001 .

Particle pushing: the concentration of particles near a solid interface during downward flow

Q. Han, J. Hunt, 1994 .

Steady state columnar and equiaxed growth of dendrites and eutectic

J. Hunt, J. D. Hunt, J. Hunt, 1984 .

Optimizing zone refining

J. Hunt, J. Hunt, G. H. Rodway, 1989 .