M. Bergoglio

发表

Final report on the regional key comparison Euromet . M . PK 1 . b ( Euromet Project 442 , Phase B ) in the pressure range from 3 · 10-4 Pa to 0 . 9

K. Jousten, J. Legras, J. Šetina, 2004 .

Experimental and computational study of gas flow delivered by a rectangular microchannels leak

S. Colin, H. S. H. Mohand, M. Bergoglio, 2015 .

Final report on key comparison EURAMET.M.P-K13 in the range 50 MPa to 500 MPa of hydraulic gauge pressure

W. Sabuga, J. Šetina, M. Bergoglio, 2015 .

Leak detection, calibrations and reference flows: Practical example

M. Bergoglio, A. Calcatelli, D. Mari, 2007 .

Evaluation of the conductance of the orifice of the new CNR-IMGC dynamic expander

M. Bergoglio, A. Calcatelli, M. Niewiński, 1999 .

Primary pressure measurements down to 10−6 Pa

L. Marzola, M. Bergoglio, A. Calcatelli, 1988 .

Final Report on Key Comparison CCM.P-K4 in Absolute Pressure from 1 Pa to 1000 Pa

M. Bergoglio, Karl Jousten, N Bignell, 2002 .

Uncertainty evaluation of the IMGC-CNR static expansion system

M Bergoglio, A Calcatelli, M. Bergoglio, 2004 .

The physical measurement of pressure in SI units and its extension to lower pressures

M. Bergoglio, A. Calcatelli, 2001 .

Study of outgassing of sputter-ion pump materials treated with three different cleaning procedures

M. D. Simon, M. Bergoglio, A. Calcatelli, 1996 .

Gas flowrate measurements for leak calibration

M. Bergoglio, A. Calcatelli, G. Rumiano, 1995 .

Primary and secondary vacuum measurements

M. Bergoglio, A. Calcatelli, G. Rumiano, 1993 .

Gas adsorption/desorption and materials stability

M. Bergoglio, A. Calcatelli, P. Chen, 1990 .

Mathematical model applied to the experimental calibration results of a capillary standard leak

M. Bergoglio, Gabriele Brondino, A. Calcatelli, 2006 .

Results of bilateral pressure comparisons in the vacuum region between the ETL and the IMGC

M. Hirata, M. Bergoglio, A. Calcatelli, 1997 .

Final report on key comparison CCM.P-K4 of absolute pressure standards from 1 Pa to 1000 Pa

K. Jousten, A. Miiller, N. Bignell, 2002 .

Final report on EURAMET.M.P-K4.2010: Key and supplementary comparison of national pressure standards in the range 1 Pa to 15 kPa of absolute and gauge pressure

K. Jousten, W. Sabuga, D. Pražák, 2014 .

Analysis of interlaboratory comparisons affected by correlations of the reference standards and drift of the travelling standards

Mercede Bergoglio, Andrea Malengo, Domenico Mari, 2011 .

Calculation of effective area A0 for six piston–cylinder assemblies of pressure balances. Results of the EUROMET Project 740

Pierre Otal, M. Bergoglio, Wladimir Sabuga, 2005 .

Adsorption/desorption on PtIr alloy used for mass standards

M. Bergoglio, A. Calcatelli, M. Plassa, 1997 .

Some considerations on handling the calibration results of capacitance membrane gauges

M. Bergoglio, A. Calcatelli, 2001 .

Leak rate metrology for the society and industry

M. Bergoglio, D. Mari, M. Bergoglio, 2012 .

Preliminary Uncertainty Estimation of the Pressure Distortion Coefficient of a Pressure Balance by FEM Calculations

G. Buonanno, M. Dell’Isola, G. Molinar, 2001 .

Summary Abstract: Changes in time of the metrological characteristics of a quadrupole mass spectrometer

M. Bergoglio, A. Calcatelli, G. Rumiano, 1987 .