L. Toualbi

发表

Application of synchrotron radiation to analyze the precipitation in ODS materials before irradiation in Fe–9%Cr single grain of powder and consolidated Fe–18%Cr

Y. Carlan, S. Schlutig, D. Menut, 2012 .

Chemical and microstructural evolution on ODS Fe–14CrWTi steel during manufacturing stages

Y. Carlan, M. Mathon, D. Hamon, 2012 .

Plasticity and brittleness of the ordered βo phase in a TNM-TiAl alloy

H. Clemens, J. Monchoux, A. Couret, 2022, Intermetallics.

Cyclic deformation of TiAl generic microstructures at room and high temperature: Bauschinger effect & strain rate sensitivity

P. Kanouté, A. Couret, L. Toualbi, 2020 .

Assessment of a new fabrication route for Fe-9Cr-1W ODS cladding tubes

R. Logé, Y. Carlan, M. Mathon, 2012 .

A simple approach for the modeling of an ODS steel mechanical behavior in pilgering conditions

R. Logé, Y. Carlan, E. Vanegas-Márquez, 2012 .

Modeling of the shot peening of a nickel alloy with the consideration of both residual stresses and work hardening

P. Kanouté, D. Retraint, E. Rouhaud, 2023, International Journal of Solids and Structures.

A calibration procedure for the assessment of work hardening Part II: Application to shot peened IN718 parts

P. Kanouté, D. Retraint, E. Rouhaud, 2021 .

A calibration procedure for the assessment of work hardening part I: Effects of the microstructure and load type

D. Retraint, S. Kruch, J. Badreddine, 2021 .

Use of neutron and X-ray diffraction to study the precipitation mechanisms of oxides in ODS materials

G. André, Y. Carlan, F. Onimus, 2011 .

Plasticity and brittleness of the ordered beta-0 phase in a TNM-TiAl alloy

H. Clemens, J. Monchoux, A. Couret, 2023 .