Feng Quanke

发表

Principle and Thermodynamic Process of the Compressor of Composite Gear Teeth

Feng Quanke, 2005 .

Rational thermal circuit model derived from thermal simulation results for hybrid IPEM

Feng Quanke, Zeng Xiangjun, Yu Xiaoling, 2004, The 4th International Power Electronics and Motion Control Conference, 2004. IPEMC 2004..

Fault Diagnosis Using Wavelet Neural Networks

Feng Quanke, Liu Qipeng, Yu Xiaoling, 2003 .

Status and Hot Spot of Twin Screw Compressor

Feng Quanke, 2005 .

Study on Rotor Profile Design of Screw Compressors

Feng Quanke, 2012 .

Status and Recent Progress of Research on Flat Plate Heat Pipes

Feng Quanke, 2006 .

Formation of a designed compressor piston ring profile during operation

Feng Quanke, Shu Pengcheng, 2001 .

Compressor technique progressing and its professional personnel training

Feng Quanke, 2003 .

Heat Transfer Research on a Novel Cold Plate Used for High Power Electronics Module

Feng Quanke, 2009 .

Finite-element modeling of thermal performance for a novel water-cooled device used in switched mode power supply

Feng Quanke, Yu Xiaoling, Jiang Guibin, 2004, The 4th International Power Electronics and Motion Control Conference, 2004. IPEMC 2004..

Research of Wear-out-failure of Star-wheel Teeth in Single Screw Compressors

Feng Quanke, 2009 .

The Crankshaft Vibration Analysis of Large-type Piston Compressor-Modal Analysis

Feng Quanke, 2011 .

Study of Thermal Effect of Power Circuit on Driver & Protection PCB in Hybrid IPEM

Xiong Wei, Zhou Wei, Feng Quanke, 2004 .

Discussion on the Flow Rate Modification Scheme of C4201 Primary Compressor

Feng Quanke, 2008 .

Experimental Research on the Heat Transfer and Flow Performance of a Composite Heat Sink

Feng Quanke, Wang Qianlong, Yu Xiaoling, 2003 .