P. Sartkulvanich

发表

Investigation of the Effect of Tool Edge Geometry upon Cutting Variables, Tool Wear and Burr Formation Using Finite Element Simulation — A Progress Report

T. Altan, I. Al-Zkeri, Yung-Chang Yen, 2004 .

Influence of Superplastic Forming on Reduction of Yield Strength Property for Ti-6Al-4V Fine Grain Sheet and Ti-6Al-4V Standard

K. O. Yu, P. Sartkulvanich, Don Li, 2016 .

EFFECTS OF FLOW STRESS AND FRICTION MODELS IN FINITE ELEMENT SIMULATION OF ORTHOGONAL CUTTING—A SENSITIVITY ANALYSIS

Taylan Altan, Partchapol Sartkulvanich, T. Altan, 2005 .

Determination of material properties for use in FEM simulations of machining and roller burnishing

Partchapol Sartkulvanich, P. Sartkulvanich, 2007 .

FLOW STRESS DATA FOR FINITE ELEMENT SIMULATION IN METAL CUTTING: A PROGRESS REPORT ON MADAMS

Taylan Altan, Partchapol Sartkulvanich, Joerg Soehner, 2005 .

Determination of flow stress for metal cutting simulation : a progress report

Taylan Altan, Partchapol Sartkulvanich, Frank Koppka, 2004 .

Finite element analysis of the effect of blanked edge quality upon stretch flanging of AHSS

Taylan Altan, Roland Golle, Partchapol Sartkulvanich, 2010 .

Finite Element Modeling of Hard Roller Burnishing: An Analysis on the Effects of Process Parameters Upon Surface Finish and Residual Stresses

Taylan Altan, Partchapol Sartkulvanich, Francisco Jasso, 2007 .

Finite Element Modeling of Roller Burnishing Process

Taylan Altan, Yung-Chang Yen, T. Altan, 2005 .

A FINITE ELEMENT ANALYSIS OF BURR FORMATION IN FACE MILLING OF A CAST ALUMINUM ALLOY

Taylan Altan, Partchapol Sartkulvanich, Hakan Sahlan, 2007 .