Junichi Hongu

发表

Nonlinear oscillator design based on phase reduction method for closed‐loop system

D. Iba, Junichi Hongu, 2022 .

Relation of nonlinear oscillator design based on phase reduction method and fractional derivative

D. Iba, Junichi Hongu, 2022, International Journal of Adaptive Control and Signal Processing.

Tooth surface temperature and power transmission efficiency of plastic sine-curve gear

T. Koide, A. Tamura, I. Moriwaki, 2012 .

D11 Control System for Dynamic Absorber using Neural Oscillator and its Application to Single Degree of Freedom Model

Daisuke Iba, Junichi Hongu, Morimasa Nakamura, 2013 .

Failure Detection of Plastic Gears Based on a Comparison of Fourier Coefficients of a Gear Mesh Vibration Model by Rectangle Pulse Train and Frequency Analysis of Acceleration Response

Daisuke Iba, Junichi Hongu, Morimasa Nakamura, 2013 .

Estimation of Gear Friction Coefficient using Directional Parameter of Tooth Surface

T. Koide, Junichi Hongu, Ryohei Horita, 2021, Journal of tribology.

An active mass damper operated by a system consisting of a neural oscillator and PD controller (A design method of a PD controller for vibration mitigation with consideration of acceleration responses of an auxiliary mass)

Daisuke Iba, Junichi Hongu, Morimasa Nakamura, 2016 .

A DESIGN METHOD OF A PD CONTROLLER FOR USE IN AN ACTIVE MASS DAMPER SYSTEM INCORPORATING A NEURAL OSCILLATOR

Daisuke Iba, Junichi Hongu, Morimasa Nakamura, 2015 .

Structural vibration control using an active mass damper operated by a combination system of a neural oscillator and position controller

Daisuke Iba, Junichi Hongu, Morimasa Nakamura, 2015 .

Experimental evaluation of a neural-oscillator-driven active mass damper system

Daisuke Iba, Junichi Hongu, D. Iba, 2014, Smart Structures.

Fundamental study on detection of plastic-gear-failure signs (synchronization of a nonlinear oscillator to mesh frequency)

Akira Sone, Daisuke Iba, Arata Masuda, 2014 .

Mutual synchronization between structure and central pattern generator

Daisuke Iba, Junichi Hongu, D. Iba, 2012, Smart Structures.

New measuring method for single pitch deviation of hobbed gears (Using measured helix form data conditioned with Gaussian filter)

Daisuke Iba, Myungsoo Kim, Tomohiro Tatsumi, 2016 .

Development of a contact-type probe for measurements of ultra-fine-pitch gears and application to pseudo roughness evaluation

Myongsoo Kim, D. Iba, I. Moriwaki, 2017 .

Development of a contact-type probe for measurements of ultra-fine-pitch gears and application to pseudo roughness evaluation

Myongsoo Kim, D. Iba, I. Moriwaki, 2017, Journal of Mechanical Science and Technology.

Measurement of tooth flanks with a gear measuring instrument and evaluation of its surface texture (Effect of different probe profiles on measurement results)

Myungsoo Kim, D. Iba, I. Moriwaki, 2017 .