C J Hooke

发表

Rapid Calculation of the Pressures and Clearances in Rough, Elastohydrodynamically Lubricated Contacts Under Pure Rolling. Part 2: General Roughness

C J Hooke, K Y Li, 2006 .

Load sharing in~etallic)and~on-metallic gears

James Shippen, D Walton, C J Hooke, 1994 .

Rapid Calculation of the Pressures and Clearances in Rough, Elastohydrodynamically Lubricated Contacts Under Pure Rolling. Part 1: Low Amplitude, Sinusoidal Roughness

C J Hooke, K Y Li, 2006 .

Controlling the Dynamic Characteristics of a Hydrostatic Bearing by Using a Pocket-Connected Accumulator

J E T Penny, C J Hooke, M J Goodwin, 1983 .

Load Sharing in Metallic and Non-Metallic Gears

James Shippen, D Walton, C J Hooke, 1994 .

The Minimum Film Thickness in Lubricated Line Contacts during a Reversal of Entrainment—Isoviscous Behaviour

C J Hooke, 1992 .

The Effects of Non-Flatness on the Performance of Slippers in Axial Piston Pumps

Y. P. Kakoullis, C J Hooke, Y P Kakoullis, 1983 .

A Note on Tip Relief and Backlash Allowances in Non-Metallic Gears

James Shippen, D Walton, C J Hooke, 1995 .

End Plate Balance in Gear Pumps

C J Hooke, E Koc, 1984 .

Stress concentration factors around the intersection of two cylindrical holes in an infinite elastic body

C J Hooke, G Demunshi, 1977 .

An Interpolation Procedure for the Minimum Film Thickness in Point Contacts

C J Hooke, C. Hooke, 1990 .

The Lubrication of Overclamped Slippers in Axial Piston Pumps—Centrally Loaded Behaviour

C J Hooke, K Y Li, 1988 .

Roughness in elastohydrodynamic contacts

C J Hooke, K Y Li, 2010 .

Minimum Film Thicknesses in Lubricated Point Contacts Operating in the Elastic Piezoviscous Regime

C J Hooke, C. Hooke, 1988 .

Solution of axisymmetric torsion problems by point matching

C J Hooke, C. Hooke, G J Matthews, 1971 .

The Lubrication of Slippers in Axial Piston Pumps and Motors—the Effect of Tilting Couples

C J Hooke, K Y Li, 1989 .