Taeg-Woo Lee

发表

Microstructural and mechanical properties of AISI 440C stainless steel fabricated using selective laser melting

S. Cha, S. Hyun, G. Kim, 2022, Materials Science and Engineering: A.

Study on the effect of preheating temperature of SLM process on characteristics of CoCrMo alloy

S. Hyun, J. Park, G. B. Bang, 2022, Materials Science and Engineering: A.

Microstructural evaluation and failure analysis of Ag wire bonded to Al pads

So-Yeon Park, Nam-Kwon Cho, Young-Jun Jeon, 2015, Microelectron. Reliab..

Stress-induced hexagonal close-packed to face-centered cubic phase transformation in commercial-purity titanium under cryogenic plane-strain compression

Sung-Hwan Lim, Won-Yong Kim, S. Hwang, 2013 .

Microstructural study on effects of C-alloying on Cu-Fe-P cast alloy

Sung-Hwan Lim, Won-Yong Kim, Taeg-Woo Lee, 2012, Metals and Materials International.

Microstructural study on a Fe-10Cu alloy fabricated by selective laser melting for defect-free process optimization based on the energy density

Byoung-Soo Lee, Gun-Hee Kim, Taeg-Woo Lee, 2020 .

Post-annealing effects on the electrochemical performance of a Si/TiSi2 heteronanostructured anode material prepared by mechanical alloying

Sung-Hwan Lim, Jung-Bae Park, Taeg-Woo Lee, 2017 .

Oxide Scale Behavior and Surface Protection of Al–Mg Alloys Containing a Trace of Ca

Sung-Hwan Lim, Bonghwan Kim, S. Ha, 2018, International Journal of Metalcasting.

Precipitation of Oxide Particles in Surface Mixed Layer of Al–Mg Alloys with a Trace of Ca During Oxidation

Sung-Hwan Lim, Bonghwan Kim, S. Ha, 2017 .

Effect of internal pores on tensile properties of Co-Cr-Mo alloy fabricated by selective laser melting

Hyung-ki Park, H. Kim, C. Mo, 2021, Rapid Prototyping Journal.