Mathias Agmell

The Link Between Plasticity Parameters and the Process Parameters in Orthogonal Cutting

Jan-Eric Ståhl, Mathias Agmell, Aylin Ahadi, 2013 .

The influence of tool micro-geometry on stress distribution in turning operations of AISI 4140 by FE analysis

Jan-Eric Ståhl, Oleksandr Gutnichenko, Mathias Agmell, 2017 .

Experimental and Numerical Investigation of Burr Formation in Intermittent Turning of AISI 4140

Jan-Eric Ståhl, Henrik Persson, Mathias Agmell, 2017 .

Numerical and experimental investigation of tool geometry effect on residual stresses in orthogonal machining of Inconel 718

Mathias Agmell, Aylin Ahadi, Jan-Eric Ståhl, 2021, Simul. Model. Pract. Theory.

The affect of Johnson Cook plasticity parameters on the cutting process parameters

Jan-Eric Ståhl, Mathias Agmell, Aylin Ahadi, 2012 .

Den gäspfria föreläsningen - Om att aktivera studenter i plenum

Dan Johansson, Frida Vermina Lundström, Mathias Agmell, 2014 .

Numerical Modelling and Analysis of Orthogonal Metal Cutting

Mathias Agmell, 2015 .

Modeling subsurface deformation induced by machining of Inconel 718

Jinming Zhou, Ru Peng, Mathias Agmell, 2017 .

Development of a simulation model to study tool loads in pcBN when machining AISI 316L

Jan-Eric Ståhl, Mathias Agmell, Aylin Ahadi, 2018, The International Journal of Advanced Manufacturing Technology.

Identification of plasticity constants from orthogonal cutting and inverse analysis

Jan-Eric Ståhl, Mathias Agmell, Aylin Ahadi, 2014 .