Satoshi Ito

发表

Nobukazu Takai, Haruo Kobayashi, Yohei Tan, 2010 .

Satoshi Ito, M. Sato, T. Simozuma, 2013 .

Structural Design of the Remountable Magnet and Development of Joint Section of a High-temperature Superconducting Conductor

Satoshi Ito, Hidetoshi Hashizume, Akio Sagara, 2015 .

FEM Analysis of Low-Frequency Disc Brake Squeal (In Case of Opposed Type Caliper)

Satoshi Ito, Toru Matsushima, Masaaki Nishiwaki, 1997 .

D-16-5 Improvement of Remained Noise Characteristics in FREBAS MR Image Denoising

Satoshi Ito, Yoshifumi Yamada, Masatoshi Miyazawa, 2006 .

J1202-2-3 Examination of Shape Optimization for the Fatigue Strength of Suspention Parts. : Suggestion of the Method to assume the Frequency Processing Stress or Strain Constraint.

Satoshi Ito, Takaaki Nagatani, 2010 .

Investigation for Traveling Complex Path in Steel Bridge by Magnet Wheel Robot

Yogo Takada, Satoshi Ito, Takehiro Shiba, 2017 .

Development of a Millimeter-Wave Beam Position and Profile Monitor for Transmission Efficiency Improvement in an ECRH System

Satoshi Ito, Masaki Nishiura, Takashi Mutoh, 2015 .

2103 Application of shape optimization to brake squeal phenomena

Kohei Shintani, Satoshi Ito, Kohei Furuya, 2014 .

How should electromagnetic waves below 30MHz be handled?

Satoshi Ito, Atsushi Maeda, Tatsushiko Kagoshima, 2014, Proceedings of 2014 International Conference on Modelling, Identification & Control.

The Study of Dynamic Characteristics of Selemion CMV-based IPMC Actuators in Humidity-Controlled Environments

Satoshi Ito, Minoru Sasaki, Hirohisa Tamagawa, 2015 .

A new shape optimization with robustness and its application for brake squeal phenomena

Kohei Shintani, Satoshi Ito, Kohei Furuya, 2016 .

Evaluation of HTS butt-jointing performance, focusing on the joint stress distribution

Satoshi Ito, Hidetoshi Hashizume, Shohei Takami, 2007 .

5520 Servo system development by using EMG and EOG signals

Satoshi Ito, Minoru Sasaki, Atsushi Ishida, 2006 .

1A2-E01 Development of a servo system using EMG and EOG signals

Satoshi Ito, Minoru Sasaki, Yuya Hamada, 2007 .

Effective speckle reduction in laser projection displays

Daisuke Imanishi, Satoshi Ito, Akio Furukawa, 2008, SPIE OPTO.

Early Experiences for Adaptation of Auto-tuning by ppOpen-AT to an Explicit Method

Satoshi Ito, Takahiro Katagiri, Satoshi Ohshima, 2013, 2013 IEEE 7th International Symposium on Embedded Multicore Socs.

A printed two‐arm spiral antenna operating at the 90‐GHz band

Satoshi Ito, Shigeo Kawasaki, Yoshizumi Yasuoka, 1995 .

Advanced Design of the Three-surface-multilayered Channel by Optimizing Structure of the Metal Layer

Satoshi Ito, H Hashizume, D Isshiki, 2016 .

System for use of an electronic catalog for the preparation and recovery of a subset of the electronic catalog and the free division of the electronic catalog

Satoshi Ito, Noriko Minamino, 2000 .

Feasibility of HTS Magnet Option for Fusion Reactors

Masataka Iwakuma, Satoshi Ito, Akio Sagara, 2014 .

Servo System Development Using EMG and EOG Signals

Satoshi Ito, Minoru Sasaki, Atsushi Ishida, 2008 .

Application of Semiconductor Lasers as a Projector Light Source

Daisuke Imanishi, Satoshi Ito, Shoji Hirata, 2005 .

21003 Verification of Control Effect by Shape Change in Vibration Control Arms for Parallel Flexible Structures

Toru Watanabe, Kazuto Seto, Satoshi Ito, 2006 .

Position control of a dual-stage actuator

Satoshi Ito, Minoru Sasaki, Hirohisa Tamagawa, 2010 .

Torsional vibration control of a flexible manipulator

Ryo Nakamura, Minoru Sasaki, Satoshi Ito, 2014 .

Mechanism and Control of a One-Actuator Mobile Robot Incorporating a Torque Limiter

Satoshi Ito, Ryosuke Morita, Shoya Sugiura, 2020, J. Intell. Robotic Syst..

Development of Magnetic Bridge Inspection Robot Aimed at Carrying Heavy Loads

Yogo Takada, Satoshi Ito, Yodai Matsumura, 2018 .

Present Status, Application andProspect oftheECRH SysteminLargeHelical Device

Satoshi Ito, Y. Yoshimura, Takashi Shimozuma, 2006 .

Preliminary Test Results on Remote Steering Antenna at Low Power Level

Satoshi Ito, Hiroshi Idei, Shin Kubo, 2011 .

C-12-46 ADC Test Signal Generation Algorithm for Mixed-Signal SoC

Haruo Kobayashi, Satoshi Uemori, Satoshi Ito, 2010 .

Production Test Considerations for Mixed‐signal IC with Background Calibration

Nobukazu Takai, Haruo Kobayashi, Yohei Tan, 2010 .

Application of shape optimization to brake squeal phenomena

Kohei Shintani, Satoshi Ito, Kohei Furuya, 2015 .

Red Enhanced Rear Projection Display System by Using High Power Red Semiconductor Lasers

Daisuke Imanishi, Satoshi Ito, Shoji Hirata, 2008 .

Application of the Non-Rotational Cutting Method to Automatic Seal Groove Processing

Hiroshi Suzuki, Satoshi Ito, Yasuhiro Fujita, 2006 .

Performance analysis of butt jointing in remountable HT_C superconducting magnet

Satoshi Ito, Hidetoshi Hashizume, Takeshi Yamauchi, 2004 .

UTILIZATION OF ELECTROCHEMICAL IMPEDANCE TECHNIQUES TO ESTIMATE CORROSION DAMAGE OF STEEL INFRASTRUCTURES

Satoshi Ito, K Matsuoka, K Homma, 1992 .

Design and development of high-temperature superconducting magnet system with joint-winding for the helical fusion reactor

Satoshi Ito, Hidetoshi Hashizume, Nagato Yanagi, 2015 .

Butt jointing performance for remountable HTS magnet by improving contact surface condition

Satoshi Ito, Hidetoshi Hashizume, Kazuhisa Yuki, 2006 .

Study on mechanical jointing of high temperature superconductors

Satoshi Ito, Hidetoshi Hashizume, Sumio Kitajima, 2002 .

Performance of a Mechanical Bridge Joint for 30-kA-Class High-Temperature Superconducting Conductors

Satoshi Ito, Hidetoshi Hashizume, Nagato Yanagi, 2014, IEEE Transactions on Applied Superconductivity.

Microwave Detection of Longitudinal Crack and Identification of Its Location in Straight Pipe

Satoshi Ito, Hidetoshi Hashizume, Kavoos Abbasi, 2008 .

Machinability of Ni3-Al-based intermetallic compounds

Satoshi Ito, Kazuo Mori, Teiji Yoshikawa, 1997 .

Joint Performance of HTc Superconductor for Remountable Magnet System

Satoshi Ito, Hidetoshi Hashizume, Akio Sagara, 2005 .

Proposal of mechanically jointed superconducting magnet using high critical temperature superconductors

Satoshi Ito, Hidetoshi Hashizume, S. Ito, 2002 .

Plasma Doping of Nitrogen in ZnSe Using Electron Cyclotron Resonance

Masao Ikeda, Satoshi Ito, Katsuhiro Akimoto, 1992 .

Prove the ability of microwave nondestructive method combined with signal processing to determine the position of a circumferential crack in pipes

Satoshi Ito, Hidetoshi Hashizume, K. Abbasi, 2008 .

Overview of fundamental study on remountable HTS magnet

Satoshi Ito, Hidetoshi Hashizume, S. Ito, 2006 .

Bridge-Type Mechanical Lap Joint of a 100 kA-Class HTS Conductor having Stacks of GdBCO Tapes ∗)

Satoshi Ito, Hidetoshi Hashizume, Nagato Yanagi, 2014 .

Numerical Analysis of Microwave NDT Applied to Piping Inspection

Noritaka Yusa, Satoshi Ito, Hidetoshi Hashizume, 2012 .

In vivo detection of amyloid plaques in the mouse brain using the near-infrared fluorescence probe THK-265.

Satoshi Ito, Kazuhiko Yanai, Nobuyuki Okamura, 2011, Journal of Alzheimer's disease : JAD.

MHD pressure drop characteristics in a three-surface-multi-layered channel under a strong magnetic field

Satoshi Ito, Hidetoshi Hashizume, Mitsuhiro Aoyagi, 2010 .

Design prospect of remountable high-temperature superconducting magnet

Satoshi Ito, Hidetoshi Hashizume, S. Ito, 2014 .