Wen-Der Ueng

发表

Automatic reconstruction of B-spline surfaces with constrained boundaries

Jiing-Yih Lai, Yao-Chen Tsai, Chung-Yi Huang, 2012, Comput. Ind. Eng..

A sweep-surface fitting algorithm for reverse engineering

Jiing-Yih Lai, Wen-Der Ueng, 1998 .

Sequential eigen-assignment technique for structural damage identification

Kun-Nan Chen, Wen-Der Ueng, Yunn-Lin Hwang, 2015 .

On the development of airfoil section inspection and analysis technique

Jiing-Yih Lai, Tao-Hsien Hsu, Wen-Der Ueng, 2006 .

Reconstruction of surfaces of revolution from measured points

Jiing-Yih Lai, Wen-Der Ueng, 2000 .

B-spline surface fitting to random points with bounded boundary conditions

Jiing-Yih Lai, Yao-Chen Tsai, Kuo-Jen Chen, 2007, Int. J. Comput. Appl. Technol..

VIRTUAL 3D PLANNING OF PELVIC FRACTURE REDUCTION AND IMPLANT PLACEMENT

Jiing-Yih Lai, Yao-Chen Tsai, Chung-Yi Huang, 2012 .

Sweep-surface reconstruction from three-dimensional measured data

Jiing-Yih Lai, Ji-Liang Doong, Wen-Der Ueng, 1998, Comput. Aided Des..

On the development of a parametric interpolator with confined chord error, feedrate, acceleration and jerk

Jiing-Yih Lai, Kuan-Yuan Lin, Wen-Der Ueng, 2008 .

Unconstrained and constrained curve fitting for reverse engineering

Jiing-Yih Lai, Yao-Chen Tsai, Wen-Der Ueng, 2007 .

A nurbs curve interpolator with jerk‐limited trajectory planning

Jiing-Yih Lai, Kuan-Yuan Lin, Wen-Der Ueng, 2009 .

CNC codes conversion from linear and circular paths to NURBS curves

Jiing-Yih Lai, Kuan-Yuan Lin, Wen-Der Ueng, 2008 .

An iterative coordinate setup algorithm for airfoil blades inspection

Jiing-Yih Lai, Tao-Hsien Hsu, Wen-Der Ueng, 2005 .