Alexander J. Dunbar

发表

Digital data requirements for powder bed fusion additive manufacturing and the implementation of a transparent communication architecture

Abdalla Ramadan Nassar, Alexander J. Dunbar, Edward W. Reutzel, 2016 .

Selection and installation of high resolution imaging to monitor the PBFam process, and synchronization to post-build 3D computed tomography

Robert W. M. Smith, Donald J. Natale, Jacob P. Morgan, 2020 .

Study of the Evolution of Distortion During the Powder Bed Fusion Build Process Using a Combined Experimental and Modeling Approach

Alexander J. Dunbar, 2018 .

Development and validation of a tightly coupled CFD/6-DOF solver for simulating floating offshore wind turbine platforms

Eric G. Paterson, Brent A. Craven, Alexander J. Dunbar, 2015 .

In-process monitoring of porosity in additive manufacturing using optical emission spectroscopy

Alexander J. Dunbar, Prahalada K. Rao, A. Nassar, 2020, IISE Trans..

Development of experimental method for in situ distortion and temperature measurements during the laser powder bed fusion additive manufacturing process

Timothy W. Simpson, R. P. Martukanitz, Pan Michaleris, 2016 .

Comparisons of laser powder bed fusion additive manufacturing builds through experimental in situ distortion and temperature measurements

Timothy W. Simpson, Pan Michaleris, Erik R. Denlinger, 2017 .

Experimental validation of finite element modeling for laser powder bed fusion deformation

Pan Michaleris, Erik R. Denlinger, Alexander J. Dunbar, 2016 .

Characterization of the strength of support structures used in powder bed fusion additive manufacturing of Ti-6Al-4V

Alexander J. Dunbar, A. Beese, P. Michaleris, 2017 .

Assessment of optical emission analysis for in-process monitoring of powder bed fusion additive manufacturing

Alexander J. Dunbar, A. Nassar, 2018 .