Shi Hyoung Ryu

发表

The form error prediction in side wall machining considering tool deflection

Shi Hyoung Ryu, Hae Sung Lee, Chong Nam Chu, 2003 .

An analytical expression for end milling forces and tool deflection using Fourier series

Shi Hyoung Ryu, S. Ryu, 2012 .

The form error reduction in side wall machining using successive down and up milling

Shi Hyoung Ryu, Chong Nam Chu, C. Chu, 2005 .

Roughness and texture generation on end milled surfaces

Shi Hyoung Ryu, Chong Nam Chu, Deok Ki Choi, 2006 .

Electro-chemical micro drilling using ultra short pulses

Shi Hyoung Ryu, Chong Nam Chu, C. Chu, 2004 .

Analysis of Cutting Edge Geometry Effect on Surface Roughness in Ball-end Milling Using the Taguchi Method

Shi Hyoung Ryu, Chul Yong Cho, 2014 .

Fabrication of WC micro-shaft by using electrochemical etching

Shi Hyoung Ryu, Doo-chul Choi, S. H. Choi, 2006 .

Micro Electrochemical Machining of Stainless Steel Using Citric Acid

Shi Hyoung Ryu, 2008 .

Micro electrochemical milling

Shi Hyoung Ryu, Chong Nam Chu, C. Chu, 2005 .

Micro fabrication by electrochemical process in citric acid electrolyte

Shi Hyoung Ryu, S. Ryu, 2009 .