René Leroy

发表

An experimental investigation on oil mist characterization used in MQL milling process

Christophe Louste, Naryanaswami Ranganathan, Arnaud Duchosal, 2013 .

Numerical optimization of the Minimum Quantity Lubrication parameters by inner canalizations and cutting conditions for milling finishing process with Taguchi method

Roger Serra, Hédi Hamdi, Arnaud Duchosal, 2015 .

Mise en uvre d'une optimisation multi-objectif en tournage d'un acier 100C6 : compromis entre qualité de surface et productivité

Roger Serra, Hicham Chibane, René Leroy, 2011 .

Dynamic characterization of the cutting conditions in dry turning

Roger Serra, Hicham Chibane, René Leroy, 2009 .

Numerical study of the inner canalization geometry optimization in a milling tool used in micro quantity lubrication

Roger Serra, Arnaud Duchosal, René Leroy, 2014 .

Tool design effect on microlubrication spray efficiency in milling using inner channels

Roger Serra, Hédi Hamdi, Arnaud Duchosal, 2017 .

Method for regulation of the electric assistance of a bike

Mathieu Boucher, René Leroy, Jean Paul Chemla, 2012 .

Minimum quantity lubrication advantages when applied to insert flank face in milling

Arnaud Duchosal, René Leroy, Sana Werda, 2017 .

Caractérisation in situ de soudure sans plomb

N. Ranganathan, René Leroy, Z. Ma, 2011 .

An automatic system based on vibratory analysis for cutting tool wear monitoring

Wafaa Rmili, Abdeljalil Ouahabi, Roger Serra, 2016 .

Numerical Model Study of Flow Dynamics through an End-to-Side Anastomosis: Choice of Anastomosis Angle and Prosthesis Diameter

Patrick Lermusiaux, René Leroy, P. Lermusiaux, 2006, Annals of vascular surgery.

Optimal milling conditions for carbon/epoxy composite material using damage and vibration analysis

Roger Serra, Abdelhake Bouchou, Hicham Chibane, 2013 .

Numerical steady state prediction of spitting effect for different internal canalization geometries used in MQL machining strategy

Roger Serra, Christophe Louste, Arnaud Duchosal, 2015 .

Thermal study during milling of Ti6Al4V produced by Electron Beam Melting (EBM) process

Arnaud Duchosal, René Leroy, Antoine Morandeau, 2019, Journal of Manufacturing Processes.

Influence of Minimum Quantity Lubrication on Friction Coefficient and Work-Material Adhesion During Machining of Cast Aluminum With Various Cutting Tool Substrates Made of Polycrystalline Diamond, High Speed Steel, and Carbides

Pierre Faverjon, Joël Rech, René Leroy, 2013 .

Numerical modeling and experimental measurement of MQL impingement over an insert in a milling tool with inner channels

Roger Serra, Hédi Hamdi, Arnaud Duchosal, 2015 .

Minimum Quantity Lubrication: Influence of the Oil Nature on Surface Integrity☆

Arnaud Duchosal, René Leroy, Guenhael Le Quilliec, 2016 .