Effect of target thickness in blunt projectile penetration of Weldox 460 E steel plates

This paper describes an experimental, analytical and numerical investigation of the penetration and perforation of circular Weldox 460 E steel plates with different thicknesses struck by a blunt projectile at various impact velocities. In the experimental tests, a compressed gas gun was used to launch the sabot mounted projectile at impact velocities well above and just below the ballistic limit of the target plates. Nominal hardness, diameter, length and mass of the projectile were kept constant in all tests. The target plate was clamped in a rigid circular frame, and the thickness was varied between 6 and 30 mm: Measurements were made of the initial and residual velocities, and the ballistic limit velocity and the residual versus impact velocity curve were obtained for each target thickness tested. In addition, a digital high-speed camera system was used to photograph the penetration event. The experimental findings from the tests are presented and discussed, and the results are used to assess some empirical, analytical and numerical models. It is shown that especially the results obtained by the finite element approach are encouraging in terms of predicting the response of the plates examined. r 2002 Elsevier Science Ltd. All rights reserved.

[1]  S. R. Bodner,et al.  A two-dimensional analysis of penetration by an eroding projectile , 1994 .

[2]  Jonas A. Zukas,et al.  Practical aspects of numerical simulation of dynamic events: material interfaces , 2000 .

[3]  Dongquan Liu,et al.  Perforation of rigid-plastic plate by blunt missile , 1995 .

[4]  Jonas A. Zukas,et al.  High velocity impact dynamics , 1990 .

[5]  Y. Bai,et al.  Plugging: physical understanding and energy absorption , 1982 .

[6]  T. W. Ipson,et al.  Ballistic Perforation Dynamics , 1963 .

[7]  Yi-long Bai,et al.  Adiabatic Shear Localization: Occurrence, Theories and Applications , 1992 .

[8]  T. Børvik,et al.  A computational model of viscoplasticity and ductile damage for impact and penetration , 2001 .

[9]  Werner Goldsmith,et al.  Non-ideal projectile impact on targets , 1999 .

[10]  Tore Børvik,et al.  Observations on shear plug formation in Weldox 460 E steel plates impacted by blunt-nosed projectiles , 2001 .

[11]  Tore Børvik,et al.  Perforation of 12 mm thick steel plates by 20 mm diameter projectiles with flat, hemispherical and c , 2002 .

[12]  C. Ruiz,et al.  Impact loading of plates — An experimental investigation , 1983 .

[13]  Dongquan Liu,et al.  Ballistic limit of metal plates struck by blunt deformable missiles : experiments , 2000 .

[14]  M. Langseth,et al.  An Experimental set-up used in Ballistic Penetration , 2001 .

[15]  M. Langseth,et al.  Numerical simulation of plugging failure in ballistic penetration , 2001 .

[16]  M. Langseth,et al.  Impact loading of plates: Validation of numerical simulations by testing , 1997 .

[17]  Odd Sture Hopperstad,et al.  Perforation of 12 mm thick steel plates by 20 mm diameter projectiles with flat, hemispherical and conical noses: Part II: numerical simulations , 2002 .

[18]  R. L. Woodward,et al.  The interrelation of failure modes observed in the penetration of metallic targets , 1984 .

[19]  Norman Jones,et al.  Low-velocity perforation of punch-impact-loaded metal plates , 1996 .

[20]  M. Langseth,et al.  The behaviour of square steel plates subjected to a circular blunt ended load , 1992 .

[21]  G. R. Johnson,et al.  Strain-Rate Effects in Metals at Large Shear Strains , 1983 .

[22]  S. L. Rice,et al.  Impact strength of materials , 1972 .

[23]  S. R. Bodner,et al.  Dynamic perforation of viscoplastic plates by rigid projectiles , 1983 .

[24]  Jean-Louis Chaboche,et al.  Mechanics of Solid Materials , 1990 .

[25]  M. Ortiz,et al.  Adaptive Lagrangian modelling of ballistic penetration of metallic targets , 1997 .

[26]  M. J. Forrestal,et al.  Perforation experiments on HY-100 steel plates with 4340 Rc 38 and maraging T-250 steel rod projectiles , 1999 .

[27]  M. Langseth,et al.  Dropped objects' plugging capacity of aluminium alloy plates , 1994 .

[28]  Werner Goldsmith,et al.  The mechanics of penetration of projectiles into targets , 1978 .

[29]  G. G. Corbett,et al.  Impact loading of plates and shells by free-flying projectiles: A review , 1996 .

[30]  M. Langseth,et al.  Ballistic penetration of steel plates , 1999 .

[31]  Jonas A. Zukas,et al.  Practical Aspects of Numerical Simulations of Dynamic Events: Effects of Meshing. , 2000 .

[32]  M. M. Al-Mousawi.  Material behaviour under high stress and ultrahigh loading rates: edited by J. Mescall and V. Weiss, Plenum Press, New York, 1983. ISBN 0-306-41474-0, x+326 pages, illustrated, hard-cover, US$49.50. , 1986 .

[33]  M. Langseth,et al.  Dropped objects' plugging capacity of steel plates: An experimental investigation , 1990 .

[34]  M. Langseth,et al.  DROPPED OBJECTS. PLUGGING CAPACITY OF STEEL PLATES , 1988 .

[35]  N. Jones,et al.  Experimental Investigation into the Dynamic Plastic Response and Perforation of a Clamped Circular Plate Struck Transversely by a Mass , 1994 .

[36]  G. R. Johnson,et al.  Fracture characteristics of three metals subjected to various strains, strain rates, temperatures and pressures , 1985 .

[37]  S. Bodner,et al.  Penetration into thick targets—Refinement of A 2D dynamic plasticity approach , 1994 .

[38]  Zdeněk P. Bažant,et al.  Mechanics of solid materials , 1992 .