Free Vibrations of Pultruded FRP Elements: Mechanical Characterization, Analysis, and Applications

The research shows the results of experimental tests to establish the dynamic parameters of fiber-reinforced polymer (FRP) structural elements in the free vibration field. The tests and the analysis consider the simply supported configuration of pultruded elements characterized by glass fiber reinforcement, glass fiber-reinforced polymer (GFRP) and the thermosetting vinylester matrix subjected to flexural, transversal, and torsional vibrations. Comparison between the experimental results and numerical analysis and the finite element method is also presented. The dynamic response of GFRP structural elements is compared with the behavior of steel and aluminum elements. The results show a good performance, especially in the case of open cross-sectional profiles, considering the advantages deriving from the ratio between the dead load and total load of fiber reinforced composite material. Finally, the use of pultruded GFRP elements for new-built decks is investigated to detect possible resonance phenomena due...

[1]  J. Clarke.  Structural design of polymer composites : EUROCOMP design code and handbook , 1996 .

[2]  T. Huang,et al.  The Effect of Rotatory Inertia and of Shear Deformation on the Frequency and Normal Mode Equations of Uniform Beams With Simple End Conditions , 1961 .

[3]  Hugo Bachmann.  Case Studies of Structures with Man-Induced Vibrations , 1992 .

[4]  Ronald F. Gibson,et al.  Modal vibration response measurements for characterization of composite materials and structures , 2000 .

[5]  Hugo Bachmann,et al.  Vibration Problems in Structures: Practical Guidelines , 1994 .

[6]  Hugo Bachmann,et al.  Vibration problems in structures , 1995 .

[7]  Paul Reynolds,et al.  Vibration serviceability of footbridges under human-induced excitation : a literature review , 2005 .

[8]  T. Keller.  USE OF FIBRE REINFORCED POLYMERS IN BRIDGE CONSTRUCTION , 2003 .

[9]  L. C. Bank,et al.  Dynamic Response of Thin-Walled Composite Material Timoshenko Beams , 1990 .

[10]  T. A. McCarty,et al.  Experimental and Finite Element Analysis of Pultruded Glass-Graphite/Epoxy Hybrids in Axial and Flexural Modes of Vibration , 1996 .

[11]  S. Timoshenko,et al.  LXVI. On the correction for shear of the differential equation for transverse vibrations of prismatic bars , 1921 .

[12]  C. Sun,et al.  Vibration Damping of Structural Elements , 1995 .

[13]  Yang Zheng,et al.  FURTHER TESTS OF BEAM-TO-COLUMN CONNECTIONS FOR PULTRUDED FRAMES: FLANGE-CLEATED , 1999 .

[14]  L. Librescu,et al.  Thin-Walled Composite Beams: Theory and Application , 2006 .

[15]  Tai-Yan Kam,et al.  System identification of partially restrained composite plates using measured natural frequencies , 2006 .

[16]  Z. Hashin,et al.  The Elastic Moduli of Fiber-Reinforced Materials , 1964 .

[17]  F. Taheri,et al.  Evaluation of Vibration Damping of Glass-Reinforced-Polymer-Reinforced Glulam Composite Beams , 2005 .

[18]  J. Nowinski.  On the transverse wave propagation in orthotropic timoshenko bars , 1969 .

[19]  Robert Plunkett,et al.  Dynamic Mechanical Behavior of Fiber-Reinforced Composites: Measurement and Analysis , 1976 .

[20]  Julio F. Davalos,et al.  Analysis and design of pultruded FRP shapes under bending , 1996 .