Modeling and design of flexure jointed Stewart platforms for control purposes

A number of researchers have been investigating the use of Stewart platforms (or hexapods) for precision applications including machining, vibration isolation and precise pointing. To avoid friction and backlash, these hexapods often employ flexure joints. This does eliminate nonlinear friction and backlash, but adds linear spring/damper dynamics. In addition, since the motion is so accurate, base and/or payload vibrations become significant disturbances to suppress. This paper develops guidelines for designing the flexure joints to facilitate closed-loop control. In addition, since base accelerations are typically the dominant disturbance, their effect is derived. Unlike most prior hexapod dynamic formulations, the model is experimentally verified.

[1]  Charles C. Nguyen,et al.  Dynamic analysis of a 6 DOF CKCM robot end-effector for dual-arm telerobot systems , 1989, Robotics Auton. Syst..

[2]  J. Spanos,et al.  A soft 6-axis active vibration isolator , 1995, Proceedings of 1995 American Control Conference - ACC'95.

[3]  John J. Craig,et al.  Introduction to Robotics Mechanics and Control , 1986 .

[4]  Leonard S. Haynes,et al.  Six degree-of-freedom active vibration control using the Stewart platforms , 1994, IEEE Trans. Control. Syst. Technol..

[5]  Zhiming Ji.  Study of the effect of leg inertia in Stewart platforms , 1993, [1993] Proceedings IEEE International Conference on Robotics and Automation.

[6]  Mark Campbell,et al.  Six-Axis Vibration Isolation System Using Soft Actuators and Multiple Sensors , 2002 .

[7]  Frank L. Lewis,et al.  Control of a Stewart-platform-based robotic milling cell , 1992 .

[8]  John E. McInroy,et al.  Design and control of flexure jointed hexapods , 2000, IEEE Trans. Robotics Autom..

[9]  D. C. H. Yang,et al.  Inverse dynamic analysis and simulation of a platform type of robot , 1988, J. Field Robotics.

[10]  Ron P. Podhorodeski,et al.  A family of stewart platforms with optimal dexterity , 1993, J. Field Robotics.

[11]  J. Doyle,et al.  Essentials of Robust Control , 1997 .

[12]  J. E. McInroy,et al.  Precise, fault-tolerant pointing using a Stewart platform , 1999 .

[13]  R. Cubalchini.  Technology and design needs for precision pointing systems , 1995, Proceedings of 1995 34th IEEE Conference on Decision and Control.

[14]  Min-Jie Liu,et al.  Dynamics analysis of the Gough-Stewart platform manipulator , 2000, IEEE Trans. Robotics Autom..

[15]  G.W. Neat,et al.  Method and experimental validation of a precision, reconfigurable pointing control strategy , 1997, Proceedings of the 36th IEEE Conference on Decision and Control.

[16]  C. Reboulet,et al.  Dynamic models of a six degree of freedom parallel manipulators , 1991, Fifth International Conference on Advanced Robotics 'Robots in Unstructured Environments.

[17]  G. W. Neat,et al.  A robotic approach to fault-tolerant, precision pointing , 1999, IEEE Robotics Autom. Mag..

[18]  J. E. McInroy.  Dynamic modeling of flexure jointed hexapods for control purposes , 1999, Proceedings of the 1999 IEEE International Conference on Control Applications (Cat. No.99CH36328).

[19]  Clément Gosselin.  Parallel computational algorithms for the kinematics and dynamics of parallel manipulators , 1993, [1993] Proceedings IEEE International Conference on Robotics and Automation.