Optimization of an off-grid hybrid PV-Wind-Diesel system with different battery technologies using genetic algorithm

Abstract The power supply of remote sites and applications at minimal cost and with low emissions is an important issue when discussing future energy concepts. This paper presents the modelling and optimization of a stand-alone hybrid energy system. The system consists of photovoltaic (PV) panels and a wind turbine as renewable power sources, a diesel generator for back-up power and batteries to store excess energy and to improve the system reliability. For storage the technologies of lithium-ion, lead-acid, vanadium redox-flow or a combination thereof have been considered. To be able to use different battery technologies at the same time, a battery management system (BMS) is needed. The presented BMS minimizes operation costs while taking into account different battery operating points and ageing mechanisms. The system is modelled and implemented in Matlab/Simulink. As input, the model uses data of the irradiation, wind speed and air temperature measured in 10 min intervals for 10 years in Aachen – Germany. The load is assumed to be that of a rural UMTS/GSM base station for telecommunication. For a time frame of 20 years, the performance is evaluated and the total costs have been determined. Using a genetic algorithm, component sizes and settings have then been varied and the system re-evaluated to minimize the overall costs. The optimization has been also done for a site in Quneitra – Syria which has very good solar radiation that allows for the comparison between two countries, as the weather data in the two countries differ greatly (different weather data). The optimization results show that using batteries in combination with the renewables is economical and ecological. However, the best solution is to combine redox-flow batteries with the renewables. In addition, a power supply system consisting only of batteries, PV and wind generators may be applicable as well to satisfy the power demand.

[1]  Sergio B. Silva,et al.  Economic evaluation and optimization of a photovoltaic-fuel cell-batteries hybrid system for use in the Brazilian Amazon. , 2010 .

[2]  Ziyad M. Salameh,et al.  Methodology for optimally sizing the combination of a battery bank and PV array in a wind/PV hybrid system , 1996 .

[3]  Kazunori Ozawa,et al.  Lithium Ion Rechargeable Batteries , 2009 .

[4]  M. Wohlfahrt‐Mehrens,et al.  Ageing mechanisms in lithium-ion batteries , 2005 .

[5]  A Testa,et al.  Optimal design of energy storage systems for stand-alone hybrid wind/PV generators , 2010, SPEEDAM 2010.

[6]  Anikó Ekárt,et al.  Genetic algorithms in computer aided design , 2003, Comput. Aided Des..

[7]  Dirk Uwe Sauer,et al.  Optimierung des Einsatzes von Blei-Säure-Akkumulatoren in Photovoltaik-Hybrid-Systemen unter spezieller Berücksichtigung der Batteriealterung , 2009 .

[8]  M. Kalantar,et al.  Optimal design and modeling of stand-alone hybrid PV-wind systems , 2007, 2007 Australasian Universities Power Engineering Conference.

[9]  Dirk Uwe Sauer,et al.  Concept of a Battery Aging Model for Lithium-Ion Batteries Considering the Lifetime Dependency on the Operation Strategy , 2009 .

[10]  A.H. Gastaj,et al.  Optimal sizing of hybrid power system using genetic algorithm , 2005, 2005 International Conference on Future Power Systems.

[11]  Andrew Cruden,et al.  Dynamic model of a lead acid battery for use in a domestic fuel cell system , 2006 .

[12]  C. Rydh.  Environmental assessment of vanadium redox and lead-acid batteries for stationary energy storage , 1999 .

[13]  P. Malbranche,et al.  Lead–acid batteries in stationary applications: competitors and new markets for large penetration of renewable energies , 2005 .

[14]  A. Rufer,et al.  Multiphysics and energetic modeling of a vanadium redox flow battery , 2008, 2008 IEEE International Conference on Sustainable Energy Technologies.

[15]  Henrik W. Bindner,et al.  Model prediction for ranking lead-acid batteries according to expected lifetime in renewable energy systems and autonomous power-supply systems , 2007 .

[16]  Narayan C. Kar,et al.  Battery pack modeling for the analysis of battery management system of a hybrid electric vehicle , 2009, 2009 IEEE Vehicle Power and Propulsion Conference.

[17]  Rik W. De Doncker,et al.  Impedance-based Simulation Models for Energy Storage Devices in Advanced Automotive Power Systems , 2003 .

[18]  Dario Bezmalinović,et al.  Techno-economic analysis of PEM fuel cells role in photovoltaic-based systems for the remote base stations , 2013 .

[19]  Christian Blanc.  Modeling of a vanadium redox flow battery electricity storage system , 2009 .

[20]  J. M. Ngundam,et al.  Evaluation of optimal power options for base transceiver stations of Mobile Telephone Networks Cameroon , 2012 .

[21]  Zabih Ghassemlooy,et al.  A MIMO-ANN system for increasing data rates in organic visible light communications systems , 2013, 2013 IEEE International Conference on Communications (ICC).

[22]  Gareth Kear,et al.  Development of the all‐vanadium redox flow battery for energy storage: a review of technological, financial and policy aspects , 2012 .

[23]  L. Clotea,et al.  Smart electrical energy storage system for small power wind turbines , 2010, 2010 12th International Conference on Optimization of Electrical and Electronic Equipment.

[24]  Anthony G. Fane,et al.  New All‐Vanadium Redox Flow Cell , 1986 .

[25]  Gerhard Fettweis,et al.  Power consumption modeling of different base station types in heterogeneous cellular networks , 2010, 2010 Future Network & Mobile Summit.

[26]  L. Chiaraviglio,et al.  Optimal Energy Savings in Cellular Access Networks , 2009, 2009 IEEE International Conference on Communications Workshops.

[27]  Kostas Kalaitzakis,et al.  Methodology for optimal sizing of stand-alone photovoltaic/wind-generator systems using genetic algorithms , 2006 .

[28]  Kanzumba Kusakana,et al.  Hybrid renewable power systems for mobile telephony base stations in developing countries , 2013 .

[29]  Jeremy Lagorse,et al.  Hybrid stand-alone power supply using PEMFC, PV and battery - Modelling and optimization , 2009, 2009 International Conference on Clean Electrical Power.