Design and Calibration of the X-33 Flush Airdata Sensing (FADS) System

This paper presents the design of the X-33 Flush Airdata Sensing (FADS) system. The X-33 FADS uses a matrix of pressure orifices on the vehicle nose to estimate airdata parameters. The system is designed with dual-redundant measurement hardware, which produces two independent measurement paths. Airdata parameters that correspond to the measurement path with the minimum fit error are selected as the output values. This method enables a single sensor failure to occur with minimal degrading of the system performance. The paper shows the X-33 FADS architecture, derives the estimating algorithms, and demonstrates a mathematical analysis of the FADS system stability. Preliminary aerodynamic calibrations are also presented here. The calibration parameters, the position error coefficient (epsilon), and flow correction terms for the angle of attack (delta alpha), and angle of sideslip (delta beta) are derived from wind tunnel data. Statistical accuracy of' the calibration is evaluated by comparing the wind tunnel reference conditions to the airdata parameters estimated. This comparison is accomplished by applying the calibrated FADS algorithm to the sensed wind tunnel pressures. When the resulting accuracy estimates are compared to accuracy requirements for the X-33 airdata, the FADS system meets these requirements.

[1]  Gene F. Franklin,et al.  Digital control of dynamic systems , 1980 .

[2]  Stephen A. Whitmore,et al.  In-flight demonstration of a real-time flush airdata sensing system , 1996 .

[3]  Stephen A. Whitmore,et al.  Preliminary results from a subsonic high angle-of-attack flush airdata sensing (HI-FADS) system: Design, calibration, and flight test evaluation , 1990 .

[4]  Stephen A. Whitmore,et al.  In-flight demonstration of a Real-Time Flush Airdata Sensing (RT-FADS) system , 1995 .

[5]  P. W. Huber.  Hypersonic shock-heated flow parameters for velocities to 46,000 feet per second and altitudes to 323,000 feet , 1963 .

[6]  Stephen A. Whitmore,et al.  Qualitative evaluation of a flush air data system at transonic speeds and high angles of attack , 1987 .

[7]  W. J. Monta,et al.  Description and calibration of the Langley unitary plan wind tunnel , 1981 .

[8]  H. E. Boyer,et al.  Metals handbook; desk edition , 1985 .

[9]  Timothy R. Moes,et al.  Wind-tunnel investigation of a flush airdata system at Mach numbers from 0.7 to 1.4 , 1990 .

[10]  W. Freiberger.  International Dictionary of Applied Mathematics. , 1962 .

[11]  Stephen A. Whitmore,et al.  Development of a pneumatic high-angle-of-attack flush airdata sensing system , 1991 .

[12]  J. Anderson,et al.  Hypersonic and High-Temperature Gas Dynamics , 2019 .

[13]  Stephen A. Whitmore,et al.  Measurement uncertainty and feasibility study of a flush airdata system for a hypersonic flight experiment , 1994 .

[14]  D. M. While.  Shuttle Entry Air Data System (SEADS) hardware development. Volume 1: Summary , 1983 .

[15]  Stephen A. Whitmore,et al.  Development of a Pneumatic High-Angle-of-Attack Flush Airdata Sensing (HI-FADS) System , 2022 .

[16]  F J Capone,et al.  The NASA Langley 16-Foot Transonic Tunnel---Historical Overview, Facility Description, Calibration, Flow Characteristics, Test Capabilities , 1995 .

[17]  A. Shapiro.  The dynamics and thermodynamics of compressible fluid flow. , 1953 .

[18]  Edward A. Haering.  Airdata Calibration Techniques for Measuring Atmospheric Wind Profiles , 1992 .

[19]  E. R. Keener,et al.  Flight evaluation of the x-15 ball-nose flow-direction sensor as an air-data system , 1965 .

[20]  I. G. Currie.  Fundamental mechanics of fluids , 1974 .