Joint gap kinematics in posterior-stabilized total knee arthroplasty measured by a new tensor with the navigation system.

BACKGROUND The management of soft tissue balance during surgery is essential for the success of total knee arthroplasty (TKA) but remains difficult, leaving it much to the surgeon's feel. Previous assessments for soft tissue balance have been performed under unphysiological joint conditions, with patellar eversion and without the prosthesis only at extension and 90 deg of flexion. We therefore developed a new tensor for TKA procedures, enabling soft tissue balance assessment throughout the range of motion while reproducing postoperative joint alignment with the patellofemoral (PF) joint reduced and the tibiofemoral joint aligned. Our purpose in the present study was to clarify joint gap kinematics using the tensor with the CT-free computer assisted navigation system. METHOD OF APPROACH Joint gap kinematics, defined as joint gap change during knee motion, was evaluated during 30 consecutive, primary posterior-stabilized (PS) TKA with the navigation system in 30 osteoarthritic patients. Measurements were performed using a newly developed tensor, which enabled the measurement of the joint gap throughout the range of motion, including the joint conditions relevant after TKA with PF joint reduced and trial femoral component in place. Joint gap was assessed by the tensor at full extension, 5 deg, 10 deg, 15 deg, 30 deg, 45 deg, 60 deg, 90 deg, and 135 deg of flexion with the patella both everted and reduced. The navigation system was used to obtain the accuracy of implantations and to measure an accurate flexion angle of the knee during the intraoperative joint gap measurement. RESULTS Results showed that the joint gap varied depending on the knee flexion angle. Joint gap showed an accelerated decrease during full knee extension. With the PF joint everted, the joint gap increased throughout knee flexion. In contrast, the joint gap with the PF joint reduced increased with knee flexion but decreased after 60 deg of flexion. CONCLUSIONS We clarified the characteristics of joint gap kinematics in PS TKA under physiological and reproducible joint conditions. Our findings can provide useful information for prosthetic design and selection and allow evaluation of surgical technique throughout the range of knee motion that may lead to consistent clinical outcomes after TKA.

[1]  P. Sharkey,et al.  Why Are Total Knee Arthroplasties Failing Today? , 2002 .

[2]  G. Scuderi**,et al.  Accuracy of soft tissue balancing in total knee arthroplasty. , 2000, The Journal of arthroplasty.

[3]  D. D’Lima,et al.  e-Knee: Evolution of the Electronic Knee Prosthesis Telemetry Technology Development , 2001, The Journal of bone and joint surgery. American volume.

[4]  A. Tria,et al.  The total condylar knee prosthesis: the first 5 years. , 1979, Clinical orthopaedics and related research.

[5]  R. Kober,et al.  Technique and first clinical results of robot-assisted total knee replacement. , 2002, The Knee.

[6]  S. Odum,et al.  Early Failures in Total Knee Arthroplasty , 2001, Clinical orthopaedics and related research.

[7]  M. Winemaker,et al.  Perfect balance in total knee arthroplasty: the elusive compromise. , 2002, The Journal of arthroplasty.

[8]  S A Banks,et al.  In vivo kinematics of cruciate-retaining and -substituting knee arthroplasties. , 1997, The Journal of arthroplasty.

[9]  J. Insall,et al.  Total knee arthroplasty , 2015 .

[10]  S. Banks,et al.  Fluoroscopic analysis of the kinematics of deep flexion in total knee arthroplasty. Influence of posterior condylar offset. , 2002, The Journal of bone and joint surgery. British volume.

[11]  S F Attfield,et al.  Measurement of soft tissue imbalance in total knee arthroplasty using electronic instrumentation. , 1994, Medical engineering & physics.

[12]  Laskin Rs,et al.  The surgical technique for performing a total knee replacement arthroplasty. , 1989 .

[13]  R. Laskin Lateral Release Rates After Total Knee Arthroplasty , 2001, Clinical orthopaedics and related research.

[14]  M. Kurosaka,et al.  Prosthetic alignment and sizing in computer-assisted total knee arthroplasty , 2004, International Orthopaedics.

[15]  S F Attfield,et al.  Quantification of soft-tissue imbalance in condylar knee arthroplasty. , 1993, Journal of biomedical engineering.

[16]  K. Greene,et al.  Measuring flexion in knee arthroplasty patients. , 2004, The Journal of arthroplasty.

[17]  B. Marson,et al.  The effect of a tourniquet on intraoperative patellofemoral tracking during total knee arthroplasty. , 1999, The Journal of arthroplasty.

[18]  Peter Loan,et al.  Computer-Assisted Navigation in Total Knee Replacement: Results of an Initial Experience in Thirty-five Patients , 2002, The Journal of bone and joint surgery. American volume.

[19]  J B Stiehl,et al.  Femoral condylar lift-off in vivo in total knee arthroplasty. , 2001, The Journal of bone and joint surgery. British volume.

[20]  D. Banzer,et al.  Positioning of total knee arthroplasty with and without navigation support. A prospective, randomised study. , 2003, The Journal of bone and joint surgery. British volume.

[21]  M. Kurosaka,et al.  Clinical values in computer-assisted total knee arthroplasty. , 2006, Orthopedics.