An Ultralow-Frequency Active Vertical Vibration Isolator With Geometric Antispring Structure for Absolute Gravimetry

The absolute gravimeter plays an important role in metrology, geophysics, and geological exploration. Seismic and environmental vibration has been one of the most serious factors limiting its performance. Consequently, an ultralow-frequency vertical vibration isolator is required to significantly improve its measurement precision. A novel active vertical vibration isolator employing geometric antispring (GAS) structure is proposed in this paper. The payload is supported by a GAS structure fixed on an inner frame, and the inner frame is hung by coil springs from the base. The relative movement of the payload with respect to the inner frame is detected, and the inner frame is driven by a voice coil actuator controlled by a feedback circuit to track the payload’s motion. The new isolator has a compact size, and it can be used for different load ranges by tuning the GAS structure. The practical closed-loop system has a resonant period of 19.2 s, compared with the period of 0.74 s in an open-loop system. Experiments showed that the new isolator has great performance in a homemade T-1 absolute gravimeter, reducing the measurement deviation by a factor of 32. It is expected to be used in both free-falling and atomic-interference absolute gravimeters. Future improvements may include optimizing the mechanical structure and integrating a temperature control subsystem.

[1]  Edwin R. Williams,et al.  Towards an electronic kilogram: an improved measurement of the Planck constant and electron mass , 2005 .

[2]  L J Wang,et al.  Ultra-low frequency vertical vibration isolator based on LaCoste spring linkage. , 2014, The Review of scientific instruments.

[3]  James E. Faller,et al.  Thirty Years of Progress in Absolute Gravimetry: A Scientific Capability Implemented by Technological Advances , 2002 .

[4]  David Blair,et al.  A long-period vertical vibration isolator for gravitational wave detection , 1998 .

[5]  A J F Metherell,et al.  Precision Measurement and Fundamental Constants II , 1985 .

[6]  Robin T. Stebbins,et al.  An ultra-low-noise, low-frequency, six degrees of freedom active vibration isolator , 1997 .

[7]  R. DeSalvo,et al.  Passive, Nonlinear, Mechanical Structures for Seismic Attenuation , 2005 .

[8]  R. W. P. Drever,et al.  Passive and active seismic isolation for gravitational radiation detectors and other instruments , 1982 .

[9]  Achim Peters,et al.  Active low frequency vertical vibration isolation , 1999 .

[10]  Kenji Numata,et al.  Study of quality factor and hysteresis associated with the state-of-the-art passive seismic isolation system for Gravitational Wave Interferometric Detectors , 2005 .

[11]  James E. Faller,et al.  g-the acceleration of gravity: its measurement and its importance , 1986 .

[12]  M. Loupias,et al.  Measurement of the seismic attenuation performance of the VIRGO Superattenuator , 2005 .

[13]  P. Sarin,et al.  Seismic isolation of Advanced LIGO: Review of strategy, instrumentation and performance , 2015, 1502.06300.

[14]  G. Losurdo,et al.  Measurement of the VIRGO superattenuator performance for seismic noise suppression , 2001 .

[15]  Lijun Wang,et al.  Active low-frequency vertical vibration isolation system for precision measurements , 2017 .

[16]  E. J. Douze,et al.  A preliminary report on infrasonic waves as a source of long-period seismic noise , 1974 .

[17]  Riccardo DeSalvo,et al.  One hertz seismic attenuation for low frequency gravitational waves interferometers , 2005 .

[18]  Peter R. Saulson,et al.  Vibration isolation for broadband gravitational wave antennas , 1984 .

[19]  Detlef Wolf,et al.  Observing Gravity Change in the Fennoscandian Uplift Area with the Hanover Absolute Gravimeter , 2012, Pure and Applied Geophysics.

[20]  W. Winston Chan,et al.  Wide‐angle triangulation array study of simultaneous primary microseism sources , 1989 .

[21]  D N Langenberg,et al.  Precision Measurement and Fundamental Constants , 1971 .

[22]  L J Wang,et al.  Ultra-low-frequency vertical vibration isolator based on a two-stage beam structure for absolute gravimetry. , 2016, The Review of scientific instruments.

[23]  A. Schimmel,et al.  Vertical and Horizontal Seismic Isolation Performance of the Advanced Virgo External Injection Bench Seismic Attenuation System , 2015 .

[24]  Keith McCamy,et al.  Microseisms: Coastal and pelagic sources , 1969 .

[25]  Wang Lijun,et al.  A new high precision absolute gravimeter , 2012 .

[26]  高森 昭光.  Low frequency seismic isolation for gravitational wave detectors , 2003 .

[27]  P. Nelson,et al.  An active vibration isolation system for inertial reference and precision measurement , 1991 .

[28]  Duncan Carr Agnew,et al.  Strainmeters and tiltmeters , 1986 .

[29]  M. Zhan,et al.  A programmable broadband low frequency active vibration isolation system for atom interferometry. , 2014, The Review of scientific instruments.

[30]  V. Sannibale,et al.  Monolithic geometric anti-spring blades , 2005 .

[31]  Hiroaki Yamamoto,et al.  The Seismic Attenuation System (SAS) for the Advanced LIGO gravitational wave interferometric detectors , 2009 .

[32]  Timothy M. Niebauer,et al.  A new generation of absolute gravimeters , 1995 .

[33]  Min-Kang Zhou,et al.  Note: A three-dimension active vibration isolator for precision atom gravimeters. , 2015, The Review of scientific instruments.