A Novel PWM Technique With Two-Phase Modulation

In this paper, a new two-phase pulse width modulation (PWM) technique is proposed, in which the reference voltage is constructed by three space vectors. At any speed, the peak-to-peak value of the common-mode voltage (CMV) in one PWM cycle can be reduced to one third of the DC bus voltage, even despite of the dead-time effect. And in the low voltage region, not only the CMV but also the current ripple is restrained effectively. In the entire voltage range, the linear modulation region is not limited and the switching loss is reduced because of fewer switching actions. The validity of the proposed technique is verified through simulation and experimental results.

[1]  Y. Lai,et al.  Common-mode voltage reduction PWM technique for wide speed range control of induction motor drives fed by inverter with diode front end , 2003, 38th IAS Annual Meeting on Conference Record of the Industry Applications Conference, 2003..

[2]  Yen-Shin Lai,et al.  Optimal common-mode Voltage reduction PWM technique for inverter control with consideration of the dead-time effects-part I: basic development , 2004 .

[3]  Thomas A. Lipo,et al.  A new space vector modulation strategy for common mode voltage reduction [in PWM invertors] , 1997, PESC97. Record 28th Annual IEEE Power Electronics Specialists Conference. Formerly Power Conditioning Specialists Conference 1970-71. Power Processing and Electronic Specialists Conference 1972.

[4]  Giovanna Briti,et al.  A New Space Vector Modulation Strategy for Gammon Mode Voltage Reduction , 1997 .

[5]  M. M. Swamy,et al.  Common mode current attenuation techniques for use with PWM drives , 2001 .

[6]  Seung-Ki Sul,et al.  Common mode voltage reduction method modifying the distribution of zero voltage vector in PWM converter/inverter system , 1999, Conference Record of the 1999 IEEE Industry Applications Conference. Thirty-Forth IAS Annual Meeting (Cat. No.99CH36370).

[7]  H. van der Broeck,et al.  Analysis and Realization of a Pulse Width Modulator Based on Voltage Space Vectors , 1986, 1986 Annual Meeting Industry Applications Society.

[8]  J. Erdman,et al.  Effect of PWM inverters on AC motor bearing currents and shaft voltages , 1995, Proceedings of 1995 IEEE Applied Power Electronics Conference and Exposition - APEC'95.

[9]  Alfio Consoli,et al.  Reduction of common mode currents in PWM inverter motor drives , 1997, IAS '97. Conference Record of the 1997 IEEE Industry Applications Conference Thirty-Second IAS Annual Meeting.

[10]  Chen Jian.  DAMPING AND SUPPRESSION OF COMMON MODE INTERFERENCE CURRENTS IN PWM INVERTER , 2004 .

[11]  Thomas A. Lipo,et al.  Improvements in EMI performance of inverter-fed motor drives , 1994, Proceedings of 1994 IEEE Applied Power Electronics Conference and Exposition - ASPEC'94.

[12]  Yen-Shin Lai.  Investigations into the effects of PWM techniques on common mode voltage for inverter-controlled induction motor drives , 1999, IEEE Power Engineering Society. 1999 Winter Meeting (Cat. No.99CH36233).

[13]  Yen-Shin Lai,et al.  A new suboptimal pulse-width modulation technique for per-phase modulation and space vector modulation , 1997 .

[14]  K. Gopakumar,et al.  A dual two-level inverter scheme with common mode voltage elimination for an induction motor drive , 2004, IEEE Transactions on Power Electronics.

[15]  Yen-Shin Lai,et al.  Optimal bus-clamped PWM techniques for three-phase motor drives , 2004, 30th Annual Conference of IEEE Industrial Electronics Society, 2004. IECON 2004.

[16]  V. Oleschuk,et al.  Synchronized PWM scheme for dual inverter-fed drives with zero common-mode voltages , 2005, 31st Annual Conference of IEEE Industrial Electronics Society, 2005. IECON 2005..