The threshold shift due to ion implantation may be defined as the shift in curves ofN_{\inv}versus VG, whereN_{\inv}is the inversion layer carrier density per unit area and VGis the gate bias. This definition corresponds to the experimental shift of current versus gate bias curves, because current is proportional toN_{\inv}in the linear regime of operation of the MOSFET (metal-oxide-semiconductor field-effect transistor). In addition, the shift inN_{\inv}versus VGcurves is not sensitive to the value chosen forN_{\inv}, provided this value is not so low as to fall within the weak-inversion, subthreshold regime. Therefore, this definition of threshold shift avoids the use of arbitrary criteria for threshold, such as 2φB(φB= bulk Fermi level measured from midgap), which have uncertain meaning in implanted structures. Here, the use ofN_{\inv}versus VGcurves is made practical by introduction of a simplified method of calculation. It is shown how to evaluateN_{\inv}and VGwithout using a numerical solution of Poisson's equation, by invoking a charge-sheet approximation for the inversion layer and a modified depletion approximation for majority carriers. The resulting formulation applies provided the profile does not vary rapidly within a Debye length of the depletion edge, and provided most of the implant extends beyond the inversion layer. Threshold shift is shown to depend primarily upon the zero-order and first-order moments of the excess surface charge the implant has introduced into the depletion region of the device (the dose and centroid of this portion of the implanted charge). For fully depleted implants, a simple equivalent delta-function implant with the same dose and centroid as the real implant can be used to find threshold, and calculations can be made on a programmable pocket calculator. For a partially depleted implant, the moments of the depleted portion of the implant are needed. In addition, built-in junction effects can become significant. Comparison of the delta-function approach with a slightly more complex calculation for Gaussian implants is made. For fully depleted implants, agreement is complete. For partially depleted implants, a good estimate is obtained by introducing the ideas of "effective dose" and of "clamping of the depletion edge."
[1]
D. P. Kennedy,et al.
On the measurement of impurity atom distributions in silicon by the differential capacitance technique
,
1968
.
[2]
F. Van de Wiele,et al.
Threshold voltage of nonuniformly doped MOS structures
,
1973
.
[3]
H. Feltl.
Onset of heavy inversion in MOS devices doped nonuniformly near the surface
,
1977,
IEEE Transactions on Electron Devices.
[4]
W. C. Johnson,et al.
The influence of debye length on the C-V measurement of doping profiles
,
1971
.
[5]
J. Brews.
A charge-sheet model of the MOSFET
,
1978
.
[6]
Electrical characteristics of boron-implanted n-channel MOS transistors for use in logic circuits
,
1975,
IEEE Transactions on Electron Devices.
[7]
Depletion approximation analysis of the differential capacitance—Voltage characteristics of an MOS structure with nonuniformly doped semiconductors
,
1979,
IEEE Transactions on Electron Devices.
[8]
R. Troutman,et al.
Ion-implanted threshold tailoring for insulated gate field-effect transistors
,
1977,
IEEE Transactions on Electron Devices.
[9]
M. R. MacPherson,et al.
Threshold shift calculations for ion implanted MOS devices
,
1972
.
[10]
Theoretical and experimental study of MOS transistors nonuniformly doped by SILOX technique
,
1976
.
[11]
G. E. Smith,et al.
MOS field-effect transistors and integrated circuits
,
1973
.
[12]
J. Brews.
Subthreshold behavior of uniformly and nonuniformly doped long-channel MOSFET
,
1979,
IEEE Transactions on Electron Devices.