MANUFACTURING REQUIREMENTS IN DESIGN: THE RTM PROCESS IN AERONAUTICS

Abstract A sub-unit of an aeronautical structure (fuselage, fin, wing, etc.) consists of a set of components fixed rigidly together. One of today’s major industrial challenges is to produce these sub-units out of composite materials in order to increase the level of integration and reduce mass and cost. This article describes a procedure to assist in the industrialisation of aeronautical components produced from composite materials in a design for manufacturing (DFM) context. In a multi-expertise approach, the problem of optimising integration is combined with the feasibility of injection for the resin transfer molding (RTM) process. This approach then takes into account admissible manufacturing deviations, defined from a classification of the structure parts. The limits set for admissible deviations guarantee the mechanical behaviour of the assembled component and the requirements of the assembly as a whole. Finally, an industrialisation solutions space is defined. A constraint satisfaction problem solver is used to carry out this research with a spar from a horizontal plane in an aircraft used to illustrate the procedure.

[1]  Frédéric Ratle,et al.  Evolutionary operators for optimal gate location in liquid composite moulding , 2009, Appl. Soft Comput..

[2]  Raphaël Chenouard,et al.  Résolution par satisfaction de contraintes appliquée à l'aide à la décision en conception architecturale. (Constraint satisfaction solving applied to decision support for embodiment design) , 2007 .

[3]  Toby Walsh,et al.  Handbook of Constraint Programming , 2006, Handbook of Constraint Programming.

[4]  C. Nardari,et al.  Simultaneous engineering in design and manufacture using the RTM process , 2002 .

[5]  Satyandra K. Gupta,et al.  New Directions in Design for Manufacturing , 2004 .

[6]  V. P. Agrawal,et al.  Design for ‘X’-abilities of RTM Products - A Graph Theoretic Approach , 2006, Concurr. Eng. Res. Appl..

[7]  Arnaud Alix,et al.  RTM technology development : new metho dologies for process control improvement : Processing equipment , 2005 .

[8]  Masoud Rais-Rohani,et al.  ANALYSIS AND OPTIMIZATION OF PRIMARY AIRCRAFT STRUCTURES BASED ON STRENGTH, MANUFACTURABILITY, AND COST REQUIREMENTS , 1999 .

[9]  Jean-Pierre Nadeau,et al.  Structuring of embodiment design problem based on the product lifecycle , 2005 .

[10]  Laurent Granvilliers,et al.  Search heuristics for constraint-aided embodiment design , 2009, Artificial Intelligence for Engineering Design, Analysis and Manufacturing.

[11]  François Trochu,et al.  Numerical analysis of cure temperature and internal stresses in thin and thick RTM parts , 2005 .

[12]  Alain Vautrin,et al.  Weight minimization of composite laminated plates with multiple constraints , 2003 .

[13]  C. Dong.  Dimension variation prediction and control for composites , 2003 .

[14]  Toby Walsh,et al.  Handbook of Constraint Programming (Foundations of Artificial Intelligence) , 2006 .

[15]  François Trochu,et al.  Application of the level set method to the simulation of resin transfer molding , 2006 .

[16]  Kuang-Ting Hsiao,et al.  Branch and bound search to optimize injection gate locations in liquid composite molding processes , 2002 .