Characterization of melting and solidification in a real scale PCM-air heat exchanger: Numerical model and experimental validation

Abstract This paper describes the models developed to simulate the performance of a thermal energy storage (TES) unit in a real scale PCM-air heat exchanger, analyzing the heat transfer between the air and a commercially available and slab macroencapsulated phase change material (PCM). The models are based on one-dimensional conduction analysis, utilizing finite differences method, and implicit formulation, using the thermo-physical data of the PCM measured in the laboratory: enthalpy and thermal conductivity as functions of temperature. The models can take into account the hysteresis of the enthalpy curve and the convection inside the PCM, using effective conductivity when necessary. Two main paths are followed to accomplish the modeling: the thermal analysis of a single plate, and the thermal behavior of the entire TES unit. Comparisons between measurements and simulations are undertaken to evaluate the models. Average errors of less than 12% on thermal power are obtained for the entire cycle. Once the model is validated, a series of parameters and variables is studied to verify their influence on the behavior and design of the TES unit.

[1]  Zhang Yinping,et al.  A simple method, the -history method, of determining the heat of fusion, specific heat and thermal conductivity of phase-change materials , 1999 .

[2]  G. Hetsroni.  Handbook of hydraulic resistance , 1990 .

[3]  R. Velraj,et al.  Experimental investigation and numerical simulation analysis on the thermal performance of a building roof incorporating phase change material (PCM) for thermal management , 2008 .

[4]  Dan Zhou,et al.  Review on thermal energy storage with phase change materials (PCMs) in building applications , 2012 .

[5]  S. Medved,et al.  Influence of accuracy of thermal property data of a phase change material on the result of a numerical model of a packed bed latent heat storage with spheres , 2005 .

[6]  L. Cabeza,et al.  Determination of enthalpy?temperature curves of phase change materials with the temperature-history method: improvement to temperature dependent properties , 2003 .

[7]  Harald Mehling,et al.  Modeling of subcooling and solidification of phase change materials , 2007 .

[8]  Ashley F. Emery,et al.  Free Convection Through Vertical Plane Layers—Moderate and High Prandtl Number Fluids , 1969 .

[9]  Wasim Saman,et al.  Analysis and modelling of a phase change storage system for air conditioning applications , 2001 .

[10]  O. G. Martynenko,et al.  Handbook of hydraulic resistance , 1986 .

[11]  Jose M. Marin,et al.  PCM-air heat exchangers for free-cooling applications in buildings: Empirical model and application to design , 2009 .

[12]  Gene H. Golub,et al.  Matrix computations , 1983 .

[13]  V. Voller.  FAST IMPLICIT FINITE-DIFFERENCE METHOD FOR THE ANALYSIS OF PHASE CHANGE PROBLEMS , 1990 .

[14]  R. Shah,et al.  Thermal Boundary Conditions and Some Solutions for Laminar Duct Flow Forced Convection , 1974 .

[15]  L. E. Goodrich,et al.  Efficient numerical technique for one-dimensional thermal problems with phase change , 1978 .

[16]  Stéphane Citherlet,et al.  Numerical model and experimental validation of heat storage with phase change materials , 2007 .

[17]  Luisa F. Cabeza,et al.  Review on thermal energy storage with phase change: materials, heat transfer analysis and applications , 2003 .

[18]  Miroslaw Zukowski,et al.  Mathematical modeling and numerical simulation of a short term thermal energy storage system using phase change material for heating applications , 2007 .

[19]  A. Abdel-azim.  Fundamentals of Heat and Mass Transfer , 2011 .

[20]  A. Lázaro,et al.  PCM–air heat exchangers for free-cooling applications in buildings: Experimental results of two real-scale prototypes , 2009 .

[21]  Wasim Saman,et al.  Numerical analysis of a PCM thermal storage system with varying wall temperature , 2005 .

[22]  Göran Hed,et al.  Mathematical modelling of PCM air heat exchanger , 2006 .

[23]  V. Gnielinski.  New equations for heat and mass transfer in turbulent pipe and channel flow , 1976 .

[24]  Sunil Kumar Singal,et al.  Review of mathematical modeling on latent heat thermal energy storage systems using phase-change material , 2008 .

[25]  A. Bejan.  Convection Heat Transfer , 1984 .

[26]  M. Hamdan,et al.  Thermal energy storage using a phase change material , 1996 .

[27]  J. Whitelaw,et al.  Convective heat and mass transfer , 1966 .

[28]  Robert H. Halstead,et al.  Matrix Computations , 2011, Encyclopedia of Parallel Computing.

[29]  Wasim Saman,et al.  Thermal performance of PCM thermal storage unit for a roof integrated solar heating system , 2005 .