An integrated exploration of thermal and water management dynamics on the performance of a stand-alone 5-kW Ballard fuel-cell system for its scale-up design

A semi-empirical dynamic model with a generalized modeling framework is presented in this paper for the optimal design of a proton-exchange membrane fuel-cell system in order to bring out the importance of thermal and water management dynamics. Numerous electrochemical models exist in the literature presently predict the static and dynamic behavior at a specified operated conditions. However, those models have not considered the influence of both thermal and water management dynamics on the cell polarization and performance behavior. Hence an integrated exploration is done to illustrate the combined effect of operating temperature and membrane hydration over the steady state and dynamic behavior of the fuel-cell stack system. Benchmark data obtained from a stand-alone 5-kW Ballard fuel-cell power system using Nafion 117 membrane are taken to validate the predicted results over a wide range of operating conditions. The influence of stack-operating temperature over the membrane dynamics is investigated, and a similar trend is followed to analyze the temperature dynamics for the effect of dehydrated membrane. Thereby, the optimal operating condition of the stack is determined in terms of thermal and water management dynamics that facilitate the scale-up design of a fuel-cell stack system.

[1]  Huei Peng,et al.  SIMULATION AND ANALYSIS OF TRANSIENT FUEL CELL SYSTEM PERFORMANCE BASED ON A DYNAMIC REACTANT FLOW MODEL , 2002 .

[2]  J. C. Amphlett,et al.  Performance modeling of the Ballard Mark IV solid polymer electrolyte fuel cell. II: Empirical model development , 1995 .

[3]  A. Parthasarathy,et al.  Temperature Dependence of the Electrode Kinetics of Oxygen Reduction at the Platinum/Nafion® Interface—A Microelectrode Investigation , 1992 .

[4]  Chien-Hsing Lee,et al.  Modeling of the Ballard-Mark-V proton exchange membrane fuel cell with power converters for applicat , 2011 .

[5]  Patrick C. Hammett,et al.  Empirical Model Development , 2014 .

[6]  Ralph E. White,et al.  A water and heat management model for proton-exchange-membrane fuel cells , 1993 .

[7]  Luciane Neves Canha,et al.  An electrochemical-based fuel-cell model suitable for electrical engineering automation approach , 2004, IEEE Transactions on Industrial Electronics.

[8]  Michael C. Georgiadis,et al.  Modelling and explicit model predictive control for PEM fuel cell systems , 2012 .

[9]  Mario Paolone,et al.  Experimental analysis of a PEM fuel cell performance at variable load with anodic exhaust management optimization , 2013 .

[10]  T. Springer,et al.  Polymer Electrolyte Fuel Cell Model , 1991 .

[11]  G.J.M. Janssen,et al.  Water transport in the proton-exchange-membrane fuel cell: measurements of the effective drag coefficient , 2001 .

[12]  S. Dutta,et al.  Numerical prediction of mass-exchange between cathode and anode channels in a PEM fuel cell , 2001 .

[13]  E H Law,et al.  Model-based control strategies in the dynamic interaction of air supply and fuel cell , 2004 .

[14]  K. Agbossou,et al.  Characterization of a Ballard MK5-E Proton Exchange Membrane Fuel Cell Stack , 2001 .

[15]  Jason R. Kolodziej,et al.  Modeling of an automotive fuel cell thermal system , 2010 .

[16]  Y. Wang,et al.  Modeling and Dynamic Characteristic Simulation of a Proton Exchange Membrane Fuel Cell , 2009, IEEE Transactions on Energy Conversion.

[17]  G.J.M. Janssen,et al.  Water transport in the proton-exchange-membrane fuel cell: measurements of the effective drag coefficient , 2002 .

[18]  Michael C. Georgiadis,et al.  Modeling, simulation and experimental validation of a PEM fuel cell system , 2011, Comput. Chem. Eng..

[19]  Dawn Bernardi,et al.  Water‐Balance Calculations for Solid‐Polymer‐Electrolyte Fuel Cells , 1990 .

[20]  J. C. Amphlett,et al.  A model predicting transient responses of proton exchange membrane fuel cells , 1996 .

[21]  T. Fuller,et al.  Water and Thermal Management in Solid‐Polymer‐Electrolyte Fuel Cells , 1993 .

[22]  Caisheng Wang,et al.  A Physically Based Dynamic Model for Solid Oxide Fuel Cells , 2007, IEEE Transactions on Energy Conversion.

[23]  T. Springer,et al.  Modeling and Experimental Diagnostics in Polymer Electrolyte Fuel Cells , 1993 .

[24]  James Larminie,et al.  Fuel Cell Systems Explained , 2000 .

[25]  J. C. Amphlett,et al.  TECHNICAL PAPERS ELECTROCHEMICAL SCIENCE AND TECHNOLOGY Performance Modeling of the Ballard Mark IV Solid Polymer Electrolyte Fuel Cell I. Mechanistic Model Development , 1995 .

[26]  Jiujun Zhang,et al.  A review of water flooding issues in the proton exchange membrane fuel cell , 2008 .

[27]  Ned Djilali,et al.  THREE-DIMENSIONAL COMPUTATIONAL ANALYSIS OF TRANSPORT PHENOMENA IN A PEM FUEL CELL , 2002 .

[28]  L.N. Canha,et al.  An analysis of the dynamic performance of proton exchange membrane fuel cells using an electrochemical model , 2001, IECON'01. 27th Annual Conference of the IEEE Industrial Electronics Society (Cat. No.37243).

[29]  Zidong Wei,et al.  A Review of Water Management in Polymer Electrolyte Membrane Fuel Cells , 2009 .

[30]  Pierre R. Roberge,et al.  Development and application of a generalised steady-state electrochemical model for a PEM fuel cell , 2000 .

[31]  Lin Wang,et al.  A parametric study of PEM fuel cell performances , 2003 .

[32]  Vijayachitra Senniappan,et al.  Investigation of Water Management Dynamics on the Performance of a Ballard-Mark-V Proton Exchange Membrane Fuel Cell Stack System , 2013, International Journal of Electrochemical Science.

[33]  A.G. Stefanopoulou,et al.  Control of fuel cell breathing , 2004, IEEE Control Systems.

[34]  B. Gou,et al.  Feedback-Linearization-Based Nonlinear Control for PEM Fuel Cells , 2008, IEEE Transactions on Energy Conversion.

[35]  P. R. Pathapati,et al.  A new dynamic model for predicting transient phenomena in a PEM fuel cell system , 2005 .

[36]  Caisheng Wang,et al.  Dynamic models and model validation for PEM fuel cells using electrical circuits , 2005 .

[37]  F. Topin,et al.  Transient Model of Heat, Mass, and Charge Transfer as Well as Electrochemistry in the Cathode Catalyst Layer of a PEMFC , 2002 .