Pressure and flow rate monitoring in PEM fuel cells by embedded flexible micro-sensors

Pressure and flow rate are critical parameters associated with the performance of proton exchange membrane fuel cells (PEMFCs). Fuel cell flooding can be diagnosed by monitoring pressure drops. Flow rate is related to optimized operation of fuel cells and fuel cell aging. Previous research measured pressures at the flow channel inlet and outlet. However, determining the pressure distribution and flow rate inside PEMFCs is difficult. In this study, flexible micro-sensors are embedded into the flow channels to measure internal in situ pressures and flows of PEMFCs. These micro-sensors integrate micro pressure sensors and flow sensors via the micro-electromechanical systems (MEMS).

[1]  J. Garra,et al.  Dry etching of polydimethylsiloxane for microfluidic systems , 2002 .

[2]  Yu Sun,et al.  Precision patterning of PDMS membranes and applications , 2008 .

[3]  Z. Djuric,et al.  Analytical modelling of thermopile based flow sensor and verification with experimental results , 2009 .

[4]  Changzhi Shi,et al.  Polysilicon nanofilm pressure sensor , 2009 .

[5]  Juan C. Ordonez,et al.  The experimental validation of a simplified PEMFC simulation model for design and optimization purposes , 2009 .

[6]  Chin-Tsan Wang,et al.  Novel biometric flow slab design for improvement of PEMFC performance , 2010 .

[7]  Goutam Koley,et al.  Miniaturized implantable pressure and oxygen sensors based on polydimethylsiloxane thin films. , 2009, Materials science & engineering. R, Reports : a review journal.

[8]  Harvey G. Stenger,et al.  Flow rate and humidification effects on a PEM fuel cell performance and operation , 2007 .

[9]  Chou-Ching K. Lin,et al.  An implantable capacitive pressure sensor for biomedical applications , 2007 .

[10]  Liqun Du,et al.  Nickel membrane temperature sensor in micro-flow measurement , 2008 .

[11]  Young-Soo Choi,et al.  A novel pressure sensor with a PDMS diaphragm , 2008 .

[12]  Ma Lingzhi,et al.  Thermal distribution microfluidic sensor based on silicon , 2005 .

[13]  Chang-Soo Kim,et al.  A multi-layer structured cathode for the PEMFC , 2003 .

[14]  Elisabeth Smela,et al.  Patterning PDMS using a combination of wet and dry etching , 2009 .