An Approach to Assess LRFD-Φ from Load Test and Borehole Data In and Outside the Footprint of a Drilled Shaft

Currently (2007––2010), AASHTO’’s LRFD design of deep foundations recommends resistance factors for a variety of scenarios (e.g., method of analysis, number of load tests, etc.). Generally, values account for a desired level of reliability and are based on comprehensive databases (not site specific) of predicted versus measured resistances. Unfortunately, no consideration is given to locations of boreholes with respect to foundation elements, to spatial variability of design properties over the site or the use of load testing on LRFD assessment. The present work considers the case of side friction on axially loaded drilled shafts as assessed from laboratory analysis of rock core samples. Geo-statistical principles are used to rationally account for (1) the presence and amount of site specific load testing with borehole data in the footprint, (2) the availability of off-site load test data, (3) the amount of site specific borehole sampling, and (4) the presence or not of borehole data at production shaft locations. In agreement with previous studies, spatial variability within a site is identified as a dominating contributor to overall prediction uncertainty. Additionally, it is shown that spatial variability may only be eliminated by using borings inside shaft footprints and not through additional load testing or collection of borehole data at other locations on a site. A case study with field data is used to illustrate the approach for practice in Florida limestone.

[1]  Moonkyung Chung,et al.  Resistance factor calculations for LRFD of axially loaded driven piles in sands , 2011 .

[2]  Michael McVay,et al.  Influence of spatially variable side friction and collocated data on single and multiple shaft resistances , 2013 .

[3]  D. V. Griffiths,et al.  Load and resistance factor design of shallow foundations against bearing failure , 2008 .

[4]  Michael McVay,et al.  Influence of Spatially Variable Side Friction on Single Drilled Shaft Resistance and LRFD Resistance Factors , 2010 .

[5]  Michael McVay,et al.  Reliability based design of driven pile groups using combination of pile driving equations and high strain dynamic pile monitoring , 2013 .

[6]  Bryan E. Little,et al.  American Association of State Highway and Transportation Officials. Highway Drainage Guidelines American Association of State Highway and Transportation Officials. LRFD Bridge Design Specifications , 2000 .

[7]  Michael McVay,et al.  LOAD AND RESISTANCE FACTOR DESIGN (LRFD) FOR DEEP FOUNDATIONS , 2004 .

[8]  John C. Brixey,et al.  Analysis of straight-line data. , 1960 .

[9]  W. H. Tang,et al.  Calibration of models for pile settlement analysis using 64 field load tests , 2008 .

[10]  William Cavers,et al.  Resistance Factors for Settlement Design , 2005 .

[11]  M C McVay,et al.  STATIC AND DYNAMIC FIELD TESTING OF DRILLED SHAFTS: SUGGESTED GUIDELINES ON THEIR USE FOR FDOT STRUCTURES , 2003 .

[12]  Harald Klammler,et al.  Incorporating Geostatistical Aspects in LRFD Design for Deep Foundations , 2010 .

[13]  Michael McVay,et al.  A numerical and experimental study of bearing stiffness of drilled shafts socketed in heterogeneous rock , 2012 .

[14]  Li Min Zhang,et al.  CALIBRATION OF METHODS FOR DESIGNING LARGE-DIAMETER BORED PILES: ULTIMATE LIMIT STATE , 2009 .

[15]  P. Kitanidis.  Introduction to Geostatistics: Applications in Hydrogeology , 1997 .

[16]  Michael McVay,et al.  LOAD AND RESISTANCE FACTOR DESIGN (LRFD) FOR DRIVEN PILES USING DYNAMIC METHODS-A FLORIDA PERSPECTIVE , 2000 .

[17]  G. L. Sivakumar Babu,et al.  Reliability analysis of the bearing capacity of a shallow foundation resting on cohesive soil , 2006 .

[18]  D. V. Griffiths,et al.  Three-Dimensional Probabilistic Foundation Settlement , 2005 .

[19]  A. Peacock,et al.  Contaminant discharge and uncertainty estimates from passive flux meter measurements , 2012 .

[20]  Wilson H. Tang,et al.  REDUCING UNCERTAINTY OF PREDICTION FROM EMPIRICAL CORRELATIONS , 2004 .

[21]  Michael W. O'Neill,et al.  Resistance Factors for Single Driven Piles from Experiments , 1997 .

[22]  Michael McVay,et al.  Modification of LRFD Resistance Factors Based on Site Variability , 2009 .

[23]  Michael McVay,et al.  Approximate up-scaling of geo-spatial variables applied to deep foundation design , 2011 .

[24]  Michael McVay,et al.  Calibration of Load and Resistance Factor Design: Resistance Factors for Drilled Shaft Design , 2002 .

[25]  Gordon A. Fenton,et al.  Bearing-capacity prediction of spatially random c ϕ soils , 2003 .

[26]  J. Chilès,et al.  Geostatistics: Modeling Spatial Uncertainty , 1999 .

[27]  Michael Edward Hohn,et al.  An Introduction to Applied Geostatistics: by Edward H. Isaaks and R. Mohan Srivastava, 1989, Oxford University Press, New York, 561 p., ISBN 0-19-505012-6, ISBN 0-19-505013-4 (paperback), $55.00 cloth, $35.00 paper (US) , 1991 .

[28]  Kok-Kwang Phoon,et al.  Evaluation of Geotechnical Property Variability , 1999 .

[29]  Gordon A. Fenton,et al.  Reliability-Based Deep Foundation Design , 2007 .

[30]  K. Phoon,et al.  Characterization of Geotechnical Variability , 1999 .