The effect of temperature, the nature of the pore fluid, and subyield differential stress on the permeability of phyllosilicate-rich fault gouge

[1] Elevated temperatures and subyield deviatoric stresses were applied to oriented natural samples of clay-bearing fault gouge under pressure in order to establish their effects on the water and argon permeability under conditions closer to those found at depth in fault zones. It was found that the application of subyield differential stress normal to the fault plane resulted in a permeability reduction by a factor of ∼2. Argon permeability showed a constant rate of decrease with increasing temperature up to 150°C and limited time-dependent compaction at temperature. More substantial time-dependent compaction at elevated temperature with water pore fluid reduced the permeability by a factor of 3 over ∼6 days. When water-wet, water permeability increased with temperature up to ∼80°C, and then reduced at higher temperatures. This behavior is interpreted to be due to a combination of thermal compaction and the destabilization of structured water films coating pore throats at elevated temperatures. Increasing the pore fluid pressure did not appear to play an important role in stabilizing water films in pore throats. Based on these results, the reduction of permeability due to blocking of pore throats by structured water films is unlikely to play a role in the deeper part of fault zones. However, in the shallow crust this permeability reduction mechanism may be responsible for a significant lowering of the permeability. This has important implications for fluids that may be traveling up large faults or for the modeling of fluid flow around waste repositories, particularly when these may create temperature perturbations by their presence.

[1]  Y. Bernabé.  Chapter 6 On the Measurement of Permeability in Anisotropic Rocks , 1992 .

[2]  D. Faulkner,et al.  On the internal structure and mechanics of large strike-slip fault zones: field observations of the Carboneras fault in southeastern Spain , 2001 .

[3]  M. Zoback,et al.  How faulting keeps the crust strong , 2000 .

[4]  Patricia McGuiggan,et al.  Measurements of and Relation Between the Adhesion and Friction of Two Surfaces Separated by Molecularly Thin Liquid Films , 1989 .

[5]  T. Tullis,et al.  Implications of permeability and its anisotropy in a mica gouge for pore pressures in fault zones , 2001 .

[6]  M. Paterson,et al.  Porosity and permeability evolution during hot isostatic pressing of calcite aggregates , 1994 .

[7]  J. Israelachvili,et al.  Molecular layering of water in thin films between mica surfaces and its relation to hydration forces , 1984 .

[8]  C. Wang,et al.  Permeability and frictional properties of San Andreas Fault Gouges , 1981 .

[9]  D. Faulkner,et al.  The gas permeability of clay-bearing fault gouge at 20°C , 1998, Geological Society, London, Special Publications.

[10]  D. Lockner,et al.  Permeability differences between surface-derived and deep drillhole core samples , 1994 .

[11]  Jacob N. Israelachvili,et al.  Adhesion forces between surfaces in liquids and condensable vapours , 1992 .

[12]  J. Byerlee,et al.  Permeability and strength of San Andreas Fault gouge under high pressure , 1981 .

[13]  J. D. Blacic,et al.  Hydraulic diffusivity measurements on laboratory rock samples using an oscillating pore pressure method , 1990 .

[14]  D. Faulkner,et al.  Can the maintenance of overpressured fluids in large strike-slip fault zones explain their apparent weakness? , 2001 .

[15]  J. Byerlee,et al.  Permeability of fault gouge under confining pressure and shear stress , 1984 .

[16]  E. Rutter,et al.  Pressure solution in nature, theory and experiment , 1983, Journal of the Geological Society.

[17]  James D. Byerlee,et al.  Friction, overpressure and fault normal compression , 1990 .

[18]  W. Brace,et al.  Stick-Slip as a Mechanism for Earthquakes , 1966, Science.

[19]  S. Hall,et al.  Comparative microstructures of natural and experimentally produced clay-bearing fault gouges , 1986 .

[20]  G. Fischer,et al.  Chapter 8 The Determination of Permeability and Storage Capacity: Pore Pressure Oscillation Method , 1992 .

[21]  J. Israelachvili,et al.  Measurements of Static and Dynamic Interactions of Molecularly Thin Liquid Films Between Solid Surfaces , 1988 .

[22]  M. Clennell,et al.  Nonlinear stress dependence of permeability: A mechanism for episodic fluid flow in accretionary wedges , 1999 .

[23]  L. Klinkenberg.  The Permeability Of Porous Media To Liquids And Gases , 2012 .

[24]  Marc J. Assael,et al.  Experimental Data for the Viscosity and Thermal Conductivity of Water and Steam , 2000 .

[25]  Jacob N. Israelachvili,et al.  Measurement of the viscosity of liquids in very thin films , 1986 .

[26]  A. Maltman,et al.  Anisotropic permeability and tortuosity in deformed wet sediments , 1990 .

[27]  C. Wibberley,et al.  Internal structure and permeability of major strike-slip fault zones: the Median Tectonic Line in Mie Prefecture, Southwest Japan , 2003 .

[28]  S. Cox,et al.  Enhancement of fluid permeability during shear deformation of a synthetic mud , 2000 .

[29]  K. McClay,et al.  The geometry and evolution of a transpressional strike-slip system: the Carboneras fault, SE Spain , 1995, Journal of the Geological Society.

[30]  D. Faulkner,et al.  Comparisons of water and argon permeability in natural clay‐bearing fault gouge under high pressure at 20°C , 2000 .

[31]  J. Israelachvili,et al.  Liquid dynamics in molecularly thin films , 1990 .