Stability and nonlinear dynamic behavior of drilling shaft system in copper stave deep hole drilling

The stability and nonlinear dynamic behavior of drilling shaft system in copper stave deep hole drilling were analyzed. The effects of the fluctuation of the cutting force, the mass eccentricity and the hydrodynamic forces of cutting fluid could be taken into consideration in the model of drilling shaft system. Based on the isoparametric finite element method, the variational form of Reynolds equation in hydrodynamic fluid was used to calculate nonlinear hydrodynamic forces and their Jacobian matrices simultaneously. In the stability analysis, a new shooting method for rapidly determining the periodic orbit of the nonlinear drilling shaft system and its period was presented by rebuilding the traditional shooting method and changing the time scale. Through the combination of theories with experiment, the correctness and effectiveness of the above methods are verified by using the Floquet theory. The results show that the mass eccentricity can inhibit the whirling motion of drilling shaft to some extent.

[1]  E Jiaqiang,et al.  Numerical simulation of flow phenomena and optimum operation of tundish , 2003 .

[2]  Etsuo Marui,et al.  Whirling Vibration in Drilling. Part 3: Vibration Analysis in Drilling Workpiece with a Pilot Hole , 1988 .

[3]  D. Kinderlehrer,et al.  An introduction to variational inequalities and their applications , 1980 .

[4]  Zhanqi Hu.  RESEARCH ON VORTEX MOTION OF BTA DRILLING SHAFT CAUSED BY HYDRO-FORCE , 2005 .

[5]  Md. Abdul Matin,et al.  Analysis of the Cutting Process of a Cylindrical Workpiece Clamped by a Three-Jaw Chuck , 1988 .

[6]  Etsuo Marui,et al.  Whirling Vibration in Drilling. Part 1: Cause of Vibration and Role of Chisel Edge , 1986 .

[7]  Leon O. Chua,et al.  Practical Numerical Algorithms for Chaotic Systems , 1989 .

[8]  Rama B. Bhat,et al.  Whirling Vibrations in Boring Trepanning Association Deep Hole Boring Process : Analytical and Experimental Investigations , 2007 .

[9]  R. G. Helenbrook,et al.  Water requirements for blast furnace copper staves , 2000 .

[10]  Cui Rong-fan,et al.  Bifurcation control of nonlinear oscillator in primary and secondary resonance , 2007 .

[11]  Etsuo Marui,et al.  Whirling Vibration in Drilling. Part 2: Influence of Drill Geometries, Particularly of the Drill Flank, on the Initiation of Vibration , 1986 .

[12]  Etsuo Marui,et al.  Theoretical analysis on chatter vibration in drilling and its suppression , 2003 .

[13]  Chyn-Shu Deng,et al.  Roundness Errors in BTA Drilling and a Model of Waviness and Lobing Caused by Resonant Forced Vibrations of Its Long Drill Shaft , 2004 .

[14]  Jih-Hua Chin,et al.  Theoretical and experimental investigations on the spinning BTA deep-hole drill shafts containing fluids and subject to axial forces , 1999 .

[15]  Sergey A. Voronov,et al.  Modeling Vibratory Drilling Dynamics , 2001 .