论文信息 - Technological requirements of profile machining

Technological requirements of profile machining

The term ‘profile machining’ is used to refer to the milling of vertical surfaces described by profile curves. Profile machining requires higher precision (1/1000 mm) than regular 3D machining (1/100 mm) with the erosion of sharp vertices should being especially avoided. Although, profile machining is very essential for making trimming and flange dies, it seldom brought into focus. This paper addresses the technological requirements of profile machining including machining width and depth control, minimizing toolware, and protecting sharp vertices. Issues of controller alarms are also addressed.

Sang-Chul Park | Yunchan Chung

[1] Byoung Kyu Choi,et al. Automatic feedrate adjustment for pocket machining , 2003, Comput. Aided Des..

[2] G. Boothroyd,et al. Fundamentals of Metal Machining and Machine Tools , 1975 .

[3] Hayong Shin,et al. Directional Offset of a Spatial Curve for Practical Engineering Design , 2003, ICCSA.

[4] Desmond J. Walton,et al. Curve fitting with arc splines for NC toolpath generation , 1994, Comput. Aided Des..

[5] Sang C. Park,et al. A pair-wise offset algorithm for 2D point-sequence curve , 1999, Comput. Aided Des..

[6] Hoi-Min Jeong,et al. Machining of 2D Parametric Spline Using Cutter Radius Compensation , 1995 .

[7] Jens Schönherr,et al. Smooth biarc curves , 1993, Comput. Aided Des..

[8] Sang C. Park,et al. Mitered offset for profile machining , 2003, Comput. Aided Des..