Applicability of low macrobending loss hollow-core PCF to FTTH applications

Fiber-To-The-Home (FTTH) technology has been significantly implemented in access networks, providing very high data rates transmission and a variety of digital content to subscribers. It involves an optical cable link being installed between the building entry point and each subscriber with the Multiple Dwelling Units (MDUs), i.e. flats and apartments. In other words, optical cable has to lie fairly straight to carry a strong signal, since typically is necessary to bend, twist and turn the lines in and out of tight corners without degrading the link connection. In this paper we propose the use of Hollow-Core Photonic Crystal Fiber (HC-PCF) for FTTH applications. It is presented an experimental analysis of the macrobending effects in a HC-PCF based on a comparison with traditional fibers and by following the ITU-T G.657B standard recommendations. We observe this fiber, with only 6.5 µm core, is bending loss insensitive, even at extremely small bending radius of 2 mm, in which it presents a loss of only 0.58 dB.

[1]  Dirk Müller,et al.  Generation of Megawatt Optical Solitons in Hollow-Core Photonic Band-Gap Fibers , 2003, Science.

[2]  Jonathan Shephard,et al.  High energy nanosecond laser pulses delivered single-mode through hollow-core PBG fibers. , 2004, Optics express.

[3]  S. Matsuo,et al.  Bend-insensitive and low-splice-loss optical fiber for indoor wiring in FTTH , 2004, Optical Fiber Communication Conference, 2004. OFC 2004.

[4]  A. Amer,et al.  FTTh design and deployment guidelines for civil work, fiber distribution and numbering , 2006, 2006 Optical Fiber Communication Conference and the National Fiber Optic Engineers Conference.

[5]  S. Arismar Cerqueira,et al.  Recent progress and novel applications of photonic crystal fibers , 2010 .

[6]  R. Buczyński.  Photonic Crystal Fibers , 2004 .

[7]  D Reid,et al.  Femtosecond soliton pulse delivery at 800nm wavelength in hollow-core photonic bandgap fibers. , 2004, Optics express.

[8]  Jonathan C. Knight,et al.  Photonic crystal fibres , 2003, Nature.

[9]  Wei Jin,et al.  Fusion Splicing Photonic Crystal Fibers and Conventional Single-Mode Fibers: Microhole Collapse Effect , 2007, Journal of Lightwave Technology.

[10]  Paulo Dainese,et al.  Requirements for Bend Insensitive Fibers for Verizon's FiOS and FTTH applications , 2008, OFC/NFOEC 2008 - 2008 Conference on Optical Fiber Communication/National Fiber Optic Engineers Conference.

[11]  J. P. Carvalho,et al.  Modal interferometer based on hollow-core photonic crystal fiber for strain and temperature measurement. , 2009, Optics express.

[12]  Knight,et al.  Single-Mode Photonic Band Gap Guidance of Light in Air. , 1999, Science.

[13]  Yunjiang Rao,et al.  In-Line Fabry–Perot Etalons Based on Hollow-CorePhotonic Bandgap Fibers for High-Temperature Applications , 2009 .

[14]  P. Roberts,et al.  Ultimate low loss of hollow-core photonic crystal fibres. , 2005, Optics express.

[15]  D. Nolan,et al.  Ultra-Low Bending Loss Single-Mode Fiber for FTTH , 2008, Journal of Lightwave Technology.

[16]  J. Shephard,et al.  Single-mode mid-IR guidance in a hollow-core photonic crystal fiber. , 2005, Optics express.

[17]  J. Knight,et al.  Tailoring the Nonlinear Response of Hollow-core Photonic Bandgap Fibres , 2008, 1st Workshop on Specialty Optical Fibers and Their Applications.

[18]  F. Gerome,et al.  Control of surface modes in low loss hollow-core photonic bandgap fibers , 2008, 2008 Conference on Lasers and Electro-Optics and 2008 Conference on Quantum Electronics and Laser Science.

[19]  A. B. Ruffin,et al.  Fiber-Based Broadband-Access Deployment in the United States , 2006, Journal of Lightwave Technology.

[20]  F Benabid,et al.  Generation and Photonic Guidance of Multi-Octave Optical-Frequency Combs , 2007, Science.

[21]  Vladimir P. Minkovich,et al.  Photonic crystal fiber microtaper supporting two selective higher-order modes with high sensitivity to gas molecules , 2008 .

[22]  K. Tajima,et al.  Hole-assisted fiber design for small bending and splice losses , 2003, IEEE Photonics Technology Letters.