A high sensitivity quartz tuning fork temperature sensor

In this paper, a highly sensitive temperature sensor based on quartz tuning fork resonators is reported. The temperature sensor is configured by ZY (110°/10°) Cut quartz crystal wafer based bulk acoustic wave (BAW) tuning fork resonators whose operating frequency is at 31 KHz. The ideal thermo-sensitive ZY cut for quartz tuning fork resonators is analyzed with the theory. The characterization of a flexural mode tuning fork resonator whose inherent frequency sensitivity to temperature changes is reduced is presented. A Finite Element Method (FEM) has been used in the deign process. The specific cut quartz tuning fork is fabricated using photolithography and the etching technology. The temperature sensor is used to measure various temperature in the range −50–140 Degree C. The measurement results show that the tuning fork resonators based temperature sensor exhibits excellent sensitivity and short-term repeatability.

[1]  T. Leblois,et al.  P2O-9 Wet Etching of LGS crystals in H3PO4:H2O - Characterization of Anisotropy and Simulation , 2006, 2006 IEEE Ultrasonics Symposium.

[2]  Miko Elwenspoek,et al.  Micro resonant force gauges , 1992 .

[3]  E. P. Eernisse,et al.  Survey of quartz bulk resonator sensor technologies , 1988, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[4]  Zoran Djurić.  Mechanisms of noise sources in microelectromechanical systems , 2000 .

[5]  J.-M. Friedt,et al.  Introduction to the quartz tuning fork , 2007 .

[6]  C. Tellier,et al.  Wet Etching of LGS crystals in H 3 PO 4 :H 2 O Characterization of Anisotropy and Simulation , 2006 .

[7]  J. Vig.  Temperature-insensitive dual-mode resonant sensors - a review , 2001, IEEE Sensors Journal.

[8]  Antonio Arnau,et al.  A Review of Interface Electronic Systems for AT-cut Quartz Crystal Microbalance Applications in Liquids , 2008, Sensors.

[9]  T. Shiosaki,et al.  Chemical etching of lanthanum gallium silicate La3Ga5SiO14 single crystals , 2002 .

[10]  Hyungsik Chung,et al.  Analytical and finite element method design of quartz tuning fork resonators and experimental test of samples manufactured using photolithography 1—significant design parameters affecting static capacitance C0 , 2004 .

[11]  E. Benes,et al.  Sensors based on piezoelectric resonators , 1995 .

[12]  Peter Hauptmann,et al.  Quartz crystal resonator sensors under lateral field excitation—a theoretical and experimental analysis , 2008 .

[13]  E.P. EerNisse,et al.  Review of thickness-shear mode quartz resonator sensors for temperature and pressure , 2001, IEEE Sensors Journal.

[14]  F. Sthal,et al.  Study of LGS crystal micro-resonators using flexure mode: Temperature-compensated cuts , 2008, 2008 IEEE International Frequency Control Symposium.