Inverse parameter estimation in a layered unsaturated field soil

Identification of soil hydraulic parameters is an important step for modeling soil water flow and transport behavior. Parameter fitting by inverse modeling is becoming increasingly attractive as a way to avoid experimental difficulties. In this study, the authors linked the inverse program SUFI (Sequential Uncertainty domain FItting) with the one-dimensional flow model HYDRUS5 to investigate the applicability of inverse modeling to the water regime of a layered field soil. Measured pressure head and water content data from an irrigation and drainage experiment were used. The soil profile at the experimental site consisted of at least five soil layers, including a compacted pan. They formulated a total of eight inverse scenarios in an effort to explain the observed pressure head and water content data. Important processes in the experiment included, among others, air entrapment and preferential flow. The authors obtained a relatively precise simulation of pressure head and water content only after accounting for a pan layer and treating the irrigation and the drainage phases separately. They found that fitting alone, even with 20 to 30 parameters, could not account satisfactorily for the soil hydraulic behavior. Rather, correct accounting of the soil hydraulic processes as well as the soil system provedmore » to be essential.« less

[1]  Peter Droogers,et al.  Inverse method to determine soil hydraulic functions from multistep outflow experiments. , 1994 .

[2]  Nunzio Romano,et al.  Use of an inverse method and geostatistics to estimate soil hydraulic conductivity for spatial variability analysis , 1993 .

[3]  P. Wierenga,et al.  A Pressure Transducer for Field Tensiometers1 , 1983 .

[4]  Van Genuchten,et al.  A closed-form equation for predicting the hydraulic conductivity of unsaturated soils , 1980 .

[5]  M. T. van Genuchten,et al.  Estimating Unsaturated Soil Hydraulic Properties from Tension Disc Infiltrometer Data by Numerical Inversion , 1996 .

[6]  W. Jury,et al.  Field measurement and modeling of cowpea water use and yield under stressed and well-watered growth conditions , 1982 .

[7]  R. Schulin,et al.  Calibration of time domain reflectometry for water content measurement using a composite dielectric approach , 1990 .

[8]  A. SANTINI,et al.  EVALUATION OF A LABORATORY INVERSE METHOD FOR DETERMINING UNSATURATED HYDRAULIC PROPERTIES OF A SOIL UNDER DIFFERENT TILLAGE PRACTICES , 1995 .

[9]  M. Schneebeli,et al.  Measurements of Water Potential and Water Content in Unsaturated Cystalline Rock , 1995 .

[10]  T. Vogel,et al.  On the reliability of unsaturated hydraulic conductivity calculated from the moisture retention curve , 1988 .

[11]  Wim G.M. Bastiaanssen,et al.  Is large-scale inverse modelling of unsaturated flow with areal average evaporation and surface soil moisture as estimated from remote sensing feasible? , 1993 .

[12]  Philippe Ackerer,et al.  Determining Soil Hydraulic Properties by Inverse Method in One-Dimensional Unsaturated Flow , 1997 .

[13]  Karim C. Abbaspour,et al.  Uncertainty in Estimation of Soil Hydraulic Parameters by Inverse Modeling: Example Lysimeter Experiments , 1999 .

[14]  D. Marquardt.  An Algorithm for Least-Squares Estimation of Nonlinear Parameters , 1963 .

[15]  R. G. Hills,et al.  The Las Cruces Trench Site: Characterization, Experimental Results, and One‐Dimensional Flow Predictions , 1991 .

[16]  K. Abbaspour,et al.  A sequential uncertainty domain inverse procedure for estimating subsurface flow and transport parameters , 1997 .

[17]  Hannes Flühler,et al.  SUSCEPTIBILITY OF SOILS TO PREFERENTIAL FLOW OF WATER : A FIELD STUDY , 1994 .

[18]  M. Flury,et al.  Longitudinal and lateral dispersion in an unsaturated field soil , 1999 .

[19]  Jan W. Hopmans,et al.  Optimization of Hydraulic Functions from Transient Outflow and Soil Water Pressure Data , 1993 .