The influence of turn-off dead time on the reverse-recovery behaviour of synchronous rectifiers in automotive DC/DC-converters

The current commutation from the channel into the body diode of a MOSFET synchronous rectifier as well as the relation of the PWM turn-off dead time and its reverse-recovery behaviour were simulated and investigated experimentally. Both, reverse-recovery charge and current can be reduced significantly by shortening the dead time to few 10 ns. It leads to an overall converter loss reduction of several percent. The improvement of the reverse-recovery behaviour is based on the turn-on dynamics of the diode. In the considered case it takes several 10 ns to enhance plasma in the n–-region of the body diode. Therefore, turning off of the synchronous rectifier before the plasma has reached a steady-state will lead to a lower reverse-recovery charge.

[1]  H. Kobayashi,et al.  Forward transient behavior of PiN and super junction diodes , 2004, 2004 Proceedings of the 16th International Symposium on Power Semiconductor Devices and ICs.

[2]  I.W. Hofsajer,et al.  Integral 3-D thermal, electrical and mechanical design of an automotive DC/DC converter , 2005, IEEE Transactions on Power Electronics.

[3]  J.-J. Huselstein,et al.  Use of the MOSFET channel reverse conduction in an inverter for suppression of the integral diode recovery current , 2002 .

[4]  Hans-Georg Herzog,et al.  Optimization of PWM dead times in DC/DC-converters considering varying operating conditions and component dependencies , 2009, 2009 13th European Conference on Power Electronics and Applications.

[5]  Robert W. Erickson,et al.  Fundamentals of Power Electronics , 2001 .

[6]  G. Dolny,et al.  The influence of body effect and threshold voltage reduction on trench MOSFET body diode characteristics , 2004, 2004 Proceedings of the 16th International Symposium on Power Semiconductor Devices and ICs.

[7]  Thomas Duerbaum,et al.  Switching loss contributions of synchronous rectifiers in VRM applications , 2003, IEEE 34th Annual Conference on Power Electronics Specialist, 2003. PESC '03..

[8]  Alex Q. Huang,et al.  An analysis and experimental approach to MOS controlled diodes behavior , 2000 .

[9]  Krishna Shenai,et al.  Modeling low-voltage power MOSFETs as synchronous rectifiers in buck converter applications , 2003, 38th IAS Annual Meeting on Conference Record of the Industry Applications Conference, 2003..

[10]  Josef Lutz,et al.  Influence of parasitic inductances on transient current sharing in parallel connected synchronous rectifiers and Schottky-barrier diodes , 2007, IET Circuits Devices Syst..

[11]  Wilfried Hofmann,et al.  Passive turn-on process of IGBTs in Matrix converter applications , 2009, 2009 13th European Conference on Power Electronics and Applications.

[12]  Gehan A. J. Amaratunga,et al.  MOS Controlled Diodes—A new power diode , 1995 .

[13]  R. Kolessar.  Physical study of the power diode turn-on process , 2000, Conference Record of the 2000 IEEE Industry Applications Conference. Thirty-Fifth IAS Annual Meeting and World Conference on Industrial Applications of Electrical Energy (Cat. No.00CH37129).

[14]  H.-G. Herzog,et al.  Observer based PWM dead time optimization in automotive DC/DC-converters with synchronous rectifiers , 2008, 2008 IEEE Power Electronics Specialists Conference.

[15]  Ramesh Oruganti,et al.  Design optimisation of power MOSFET for high frequency synchronous rectification , 1993, Proceedings of IECON '93 - 19th Annual Conference of IEEE Industrial Electronics.