论文信息 - Milling maps and amorphization during mechanical alloying

Milling maps and amorphization during mechanical alloying

The effect of various milling parameters such as, milling intensity, ball:powder weight ratio and number of balls on the glass forming ability of an elemental blend of composition Ti50Ni50 has been studied by mechanical alloying. In order to understand the results, all the milling parameters have been converted into two energy parameters, namely, impact energy of the ball and the total energy of milling. In a milling map of these two parameters, the conditions for amorphous phase formation have been isolated. A similar exercise has been carried out for Ti50Cu50 as a function of milling time at two milling intensities. The results indicate that a minimum impact energy of the ball and a minimum total energy are essential for amorphization by mechanical alloying.

[1] B. Murty,et al. Synthesis of amorphous phase in Ti---Ni---Cu system by mechanical alloying , 1990 .

[2] S. Ranganathan,et al. Solid state amorphization in binary Ti-Ni, Ti-Cu and ternary Ti-Ni-Cu system by mechanical alloying , 1992 .

[3] F. Padella,et al. Mechanical alloying of the Fe−Zr system. Correlation between input energy and end products , 1991 .

[4] William L. Johnson,et al. Thermodynamic and kinetic aspects of the crystal to glass transformation in metallic materials , 1986 .

[5] W. Johnson,et al. Preparation of amorphous Ti1−xCux (0.10 , 1986 .

[6] C. Saw,et al. The synthesis of amorphous NiTi alloy powders by mechanical alloying , 1985 .

[7] E. Gaffet. Planetary ball-milling: an experimental parameter phase diagram , 1991 .

[8] T. Courtney,et al. The physics of mechanical alloying: A first report , 1990 .

[9] Kenji Suzuki,et al. Effect of ball-to-powder weight ratio on the amorphization reaction of Al50Ta50 by ball milling , 1991 .

[10] A. Weeber,et al. Amorphization by ball milling. A review , 1988 .

[11] R. Watanabe,et al. Model Simulation of Energy Consumption during Vibratory Ball Milling of Metal Powder , 1990 .

[12] J. Eckert,et al. Glass-forming range in mechanically alloyed Ni-Zr and the influence of the milling intensity , 1988 .

[13] K. Buschow. Effect of short-range ordering on the thermal stability of amorphous TiCu alloys , 1983 .