Critical heat flux and turbulent mixing in hexagonal tight rod bundles

Abstract Experimental and theoretical investigations have been performed on critical heat flux (CHF) and turbulent mixing in tight, hexagonal, 7-rod bundles. Freon-12 was used as working fluid due to its low latent heat, low critical pressure and well known properties. It has been found that the two-phase mixing coefficient depends mainly on mass flux. It increases with decreasing mass flux and ranges from 0.01 to 0.04 for the test conditions considered. More than 900 CHF data points have been obtained in a large range of parameters: pressure 1.0–3.0 MPa and mass flux 1.0–6.0 Mg/m2s. The effect of different parameters on CHF has been analysed. It has been found that the effect of pressure, mass flux and vapour quality on CHF is similar to that observed in circular tubes. Nevertheless, the CHF in the tight rod bundle is much lower than that in a circular tube of the same equivalent hydraulic diameters. The effect of wire wraps on CHF is mainly dependent on local vapour qualities and subsequently on flow regimes. Based on subchannel flow conditions, the effect of radial power distribution on CHF is small. Comparison of the test results with CHF prediction methods underlines the need for further work.

[1]  Joel Weisman,et al.  A theoretically based critical heat flux prediction for rod bundles at PWR conditions , 1985 .

[2]  E. Royer,et al.  The 1995 look-up table for critical heat flux in tubes , 1996 .

[3]  L. Wolf,et al.  Comprehensive assessment of the Ispra BWR and PWR subchannel experiments and code analysis with different two-phase models and solution schemes , 1987 .

[4]  D. S. Rowe,et al.  Implications concerning rod bundle crossflow mixing based on measurements of turbulent flow structure , 1974 .

[5]  N. E. Todreas,et al.  COOLANT INTERCHANNEL MIXING IN REACTOR FUEL ROD BUNDLES: SINGLE-PHASE COOLANTS. , 1969 .

[6]  U. Müller,et al.  Critical heat flux in uniformly heated vertical tubes , 1997 .

[7]  W. Zeggel,et al.  CHF in the parameter range of advanced pressurized water reactor cores , 1987 .

[8]  Werner Oldekop,et al.  General Features of Advanced Pressurized Water Reactors with Improved Fuel Utilization , 1982 .

[9]  Y. Katto,et al.  Critical heat flux of forced convective boiling in uniformly heated vertical tubes with special reference to very large length-to-diameter ratios , 1987 .

[10]  M. Siman-Tov.  Application of energy balance and direct substitution methods for thermal margins and data evaluation , 1996 .

[11]  D. G. Reddy,et al.  Parametric study of CHF data. Volume 2. A generalized subchannel CHF correlation for PWR and BWR fuel assemblies. Final report , 1983 .

[12]  L. Tong.  Heat-transfer mechanisms in nucleate and film boiling , 1972 .

[13]  Y. Katto.  Critical heat flux , 1994 .

[14]  D. Groeneveld,et al.  1986 AECL-UO Critical Heat Flux Lookup Table , 1986 .

[15]  K. Rehme.  Pressure Drop Correlations for Fuel Element Spacers , 1973 .

[16]  R. J. Cena,et al.  COBRA-IV-I: an interim version of COBRA for thermal-hydraulic analysis of rod bundle nuclear fuel elements and cores , 1976 .